1# See docs/devel/tracing.rst for syntax documentation. 2 3# rc4030.c 4jazzio_read(uint64_t addr, uint32_t ret) "read reg[0x%"PRIx64"] = 0x%x" 5jazzio_write(uint64_t addr, uint32_t val) "write reg[0x%"PRIx64"] = 0x%x" 6rc4030_read(uint64_t addr, uint32_t ret) "read reg[0x%"PRIx64"] = 0x%x" 7rc4030_write(uint64_t addr, uint32_t val) "write reg[0x%"PRIx64"] = 0x%x" 8 9# sparc32_dma.c 10ledma_memory_read(uint64_t addr, int len) "DMA read addr 0x%"PRIx64 " len %d" 11ledma_memory_write(uint64_t addr, int len) "DMA write addr 0x%"PRIx64 " len %d" 12sparc32_dma_set_irq_raise(void) "Raise IRQ" 13sparc32_dma_set_irq_lower(void) "Lower IRQ" 14espdma_memory_read(uint32_t addr, int len) "DMA read addr 0x%08x len %d" 15espdma_memory_write(uint32_t addr, int len) "DMA write addr 0x%08x len %d" 16sparc32_dma_mem_readl(uint64_t addr, uint32_t ret) "read dmareg 0x%"PRIx64": 0x%08x" 17sparc32_dma_mem_writel(uint64_t addr, uint32_t old, uint32_t val) "write dmareg 0x%"PRIx64": 0x%08x -> 0x%08x" 18sparc32_dma_enable_raise(void) "Raise DMA enable" 19sparc32_dma_enable_lower(void) "Lower DMA enable" 20 21# i8257.c 22i8257_unregistered_dma(int nchan, int dma_pos, int dma_len) "unregistered DMA channel used nchan=%d dma_pos=%d dma_len=%d" 23 24# pl330.c 25pl330_fault(void *ptr, uint32_t flags) "ch: %p, flags: 0x%"PRIx32 26pl330_fault_abort(void) "abort interrupt raised" 27pl330_dmaend(void) "DMA ending" 28pl330_dmago(void) "DMA run" 29pl330_dmald(uint8_t chan, uint32_t addr, uint32_t size, uint32_t num, char ch) "channel:%"PRId8" address:0x%08"PRIx32" size:0x%"PRIx32" num:%"PRId32"%c" 30pl330_dmakill(void) "abort interrupt lowered" 31pl330_dmalpend(uint8_t nf, uint8_t bs, uint8_t lc, uint8_t ch, uint8_t flag) "nf=0x%02x bs=0x%02x lc=0x%02x ch=0x%02x flag=0x%02x" 32pl330_dmalpiter(void) "loop reiteration" 33pl330_dmalpfallthrough(void) "loop fallthrough" 34pl330_dmasev_evirq(uint8_t ev_id) "event interrupt raised %"PRId8 35pl330_dmasev_event(uint8_t ev_id) "event raised %"PRId8 36pl330_dmast(uint8_t chan, uint32_t addr, uint32_t sz, uint32_t num, char ch) "channel:%"PRId8" address:0x%08"PRIx32" size:0x%"PRIx32" num:%"PRId32" %c" 37pl330_dmawfe(uint8_t ev_id) "event lowered 0x%"PRIx8 38pl330_chan_exec_undef(void) "undefined instruction" 39pl330_exec_cycle(uint32_t addr, uint32_t size) "PL330 read from memory @0x%08"PRIx32" (size = 0x%08"PRIx32")" 40pl330_hexdump(uint32_t offset, char *str) " 0x%04"PRIx32":%s" 41pl330_exec(void) "pl330_exec" 42pl330_debug_exec(uint8_t ch) "chan id: 0x%"PRIx8 43pl330_debug_exec_stall(void) "stall of debug instruction not implemented" 44pl330_iomem_write(uint32_t offset, uint32_t value) "addr: 0x%08"PRIx32" data: 0x%08"PRIx32 45pl330_iomem_write_clr(int i) "event interrupt lowered %d" 46pl330_iomem_read(uint32_t addr, uint32_t data) "addr: 0x%08"PRIx32" data: 0x%08"PRIx32 47