1#Example fan monitor definitions for phosphor-fan-monitor
2
3#List the fans that need to be monitored, along with some
4#properties that define how much slack is allowed in the actual
5#tach value as compared to the target tach value.
6
7#- inventory:
8#    [The system inventory location for the fan]
9#  allowed_out_of_range_time:
10#    [Time (in secs) actual speed can be outside of deviation of
11#     target speed]
12#  deviation:
13#    [Percentage that actual speed must be within target speed]
14#  num_sensors_nonfunc_for_fan_nonfunc:
15#    [How many sensors on the fan must be faulted before fan
16#     will be considered faulted]
17#  sensors: [array of speed sensors for the fan]
18#    - name [The name of the fan sensor]
19#      has_target [true|false  If this sensor has a Target property for
20#                  setting a fan speed (otherwise just for reads)]
21
22#The code uses these parameters as follows:
23#  After a speed reading of a sensor is outside of the allowed deviation of
24#  the target speed for the allowed out of range time, if at least
25#  num_sensors_nonfunc_for_fan_nonfunc sensors meet this condition,
26#  the fan will be set to nonfunctional in the inventory.
27
28#Example entries for 1 fan system:
29#  - inventory: /system/chassis/motherboard/fan0
30#    allowed_out_of_range_time: 15
31#    deviation: 15
32#    num_sensors_nonfunc_for_fan_nonfunc: 1
33#    sensors:
34#      - name: fan0
35#        has_target: true
36