1#!/bin/sh 2# For each AVSBus attached power rail set the default boot voltage and then 3# program the OPERATION register to switch to AVSBus mode and update default 4# start voltage to what was last programmed in VOUT_COMMAND. This should be run 5# before power-on. This is platform specific settings that must be 6# updated/removed if not Swift. 7 8i2cset -y 9 0x70 0x00 0x00 b # VDD 0 - PAGE set 9i2cset -y 9 0x70 0x01 0xB0 b # VDD 0 10i2cset -y 9 0x71 0x00 0x01 b # VCS 0 - PAGE set 11i2cset -y 9 0x71 0x01 0xB0 b # VCS 0 12i2cset -y 9 0x71 0x00 0x00 b # VDN 0 - PAGE set 13i2cset -y 9 0x71 0x01 0xB0 b # VDN 0 14 15i2cset -y 10 0x70 0x00 0x00 b # VDD 1 - PAGE set 16i2cset -y 10 0x70 0x01 0xB0 b # VDD 1 17i2cset -y 10 0x71 0x00 0x01 b # VCS 1 - PAGE set 18i2cset -y 10 0x71 0x01 0xB0 b # VCS 1 19i2cset -y 10 0x71 0x00 0x00 b # VDN 1 - PAGE set 20i2cset -y 10 0x71 0x01 0xB0 b # VDN 1 21