1#!/bin/sh 2 3findmtd() { 4 m=$(grep -xl "$1" /sys/class/mtd/*/name) 5 m=${m%/name} 6 m=${m##*/} 7 echo "$m" 8} 9 10hostPrime=$(findmtd host-prime) 11if test -z "$hostPrime" 12then 13 echo "Unable to find mtd partition for ${hostPrime}" 14 exit 1 15fi 16 17hostSecond=$(findmtd host-second) 18if test -z "$hostSecond" 19then 20 echo "Unable to find mtd partition for ${hostSecond}" 21 exit 1 22fi 23 24vromPrime=$(findmtd vrom-prime) 25if test -z "$vromPrime" 26then 27 echo "Unable to find mtd partition for ${vromPrime}" 28 exit 1 29fi 30 31vromSecond=$(findmtd vrom-second) 32if test -z "$vromSecond" 33then 34 echo "Unable to find mtd partition for ${vromSecond}" 35 exit 1 36fi 37 38 39#enable vrom 40# host-prime to vrom-prime 41dd if=/dev/"${hostPrime}" of=/dev/"${vromPrime}" 42# host-second to vrom-second 43dd if=/dev/"${hostSecond}" of=/dev/"${vromSecond}" 44 45# enable UART on rl300 46systemctl start obmc-console@ttyS3.service 47 48echo 0x1800008a > /sys/class/soc/srom/vromoff 49 50devmem 0xd1000008 8 128 51devmem 0xd1000009 8 36 52devmem 0xd1000041 8 255 53devmem 0xd100004b 8 8 54# setup PCIe ID 55devmem 0x802f002e 16 0x03d8 56#enable debug vsp output 57devmem 0x80fc0230 8 0x1 58 59# Check the current power status 60 61currentstate=$(busctl get-property xyz.openbmc_project.State.Chassis0 /xyz/openbmc_project/state/chassis0 xyz.openbmc_project.State.Chassis CurrentPowerState | awk '{ print $2 }') 62 63 64if [ "$currentstate" = "\"xyz.openbmc_project.State.Chassis.PowerState.On\"" ] 65then 66 systemctl stop phosphor-virtual-sensor.service 67 sleep 2 68 devmem 0x80fc0230 8 0x1 69 systemctl start phosphor-virtual-sensor.service 70fi 71 72while 'true' 73do 74 sleep 1 75done