1#
2# This config is an example usage of ktest.pl with a kvm guest
3#
4# The guest is called 'Guest' and this would be something that
5# could be run on the host to test a virtual machine target.
6
7MACHINE = Guest
8
9
10# Use virsh to read the serial console of the guest
11CONSOLE =  virsh console ${MACHINE}
12
13# Use SIGKILL to terminate virsh console. We can't kill virsh console
14# by the default signal, SIGINT.
15CLOSE_CONSOLE_SIGNAL = KILL
16
17#*************************************#
18# This part is the same as test.conf  #
19#*************************************#
20
21# The include files will set up the type of test to run. Just set TEST to
22# which test you want to run.
23#
24# TESTS = patchcheck, randconfig, boot, test, config-bisect, bisect, min-config
25#
26# See the include/*.conf files that define these tests
27#
28TEST := patchcheck
29
30# Some tests may have more than one test to run. Define MULTI := 1 to run
31# the extra tests.
32MULTI := 0
33
34# In case you want to differentiate which type of system you are testing
35BITS := 64
36
37# REBOOT = none, error, fail, empty
38#  See include/defaults.conf
39REBOOT := empty
40
41
42# The defaults file will set up various settings that can be used by all
43# machine configs.
44INCLUDE include/defaults.conf
45
46
47#*************************************#
48# Now we are different from test.conf #
49#*************************************#
50
51
52# The example here assumes that Guest is running a Fedora release
53# that uses dracut for its initfs. The POST_INSTALL will be executed
54# after the install of the kernel and modules are complete.
55#
56POST_INSTALL = ${SSH} /sbin/dracut -f /boot/initramfs-test.img $KERNEL_VERSION
57
58# Guests sometimes get stuck on reboot. We wait 3 seconds after running
59# the reboot command and then  do a full power-cycle of the guest.
60# This forces the guest to restart.
61#
62POWERCYCLE_AFTER_REBOOT = 3
63
64# We do the same after the halt command, but this time we wait 20 seconds.
65POWEROFF_AFTER_HALT = 20
66
67
68# As the defaults.conf file has a POWER_CYCLE option already defined,
69# and options can not be defined in the same section more than once
70# (all DEFAULTS sections are considered the same). We use the
71# DEFAULTS OVERRIDE to tell ktest.pl to ignore the previous defined
72# options, for the options set in the OVERRIDE section.
73#
74DEFAULTS OVERRIDE
75
76# Instead of using the default POWER_CYCLE option defined in
77# defaults.conf, we use virsh to cycle it. To do so, we destroy
78# the guest, wait 5 seconds, and then start it up again.
79# Crude, but effective.
80#
81POWER_CYCLE = virsh destroy ${MACHINE}; sleep 5; virsh start ${MACHINE}
82
83
84DEFAULTS
85
86# The following files each handle a different test case.
87# Having them included allows you to set up more than one machine and share
88# the same tests.
89INCLUDE include/patchcheck.conf
90INCLUDE include/tests.conf
91INCLUDE include/bisect.conf
92INCLUDE include/min-config.conf
93