xref: /openbmc/linux/sound/soc/amd/acp.h (revision 41415b8a)
1 /* SPDX-License-Identifier: GPL-2.0 */
2 #ifndef __ACP_HW_H
3 #define __ACP_HW_H
4 
5 #include "include/acp_2_2_d.h"
6 #include "include/acp_2_2_sh_mask.h"
7 
8 #define ACP_PAGE_SIZE_4K_ENABLE			0x02
9 
10 #define ACP_PLAYBACK_PTE_OFFSET			10
11 #define ACP_CAPTURE_PTE_OFFSET			0
12 
13 /* Playback and Capture Offset for Stoney */
14 #define ACP_ST_PLAYBACK_PTE_OFFSET	0x04
15 #define ACP_ST_CAPTURE_PTE_OFFSET	0x00
16 #define ACP_ST_BT_PLAYBACK_PTE_OFFSET	0x08
17 #define ACP_ST_BT_CAPTURE_PTE_OFFSET	0x0c
18 
19 #define ACP_GARLIC_CNTL_DEFAULT			0x00000FB4
20 #define ACP_ONION_CNTL_DEFAULT			0x00000FB4
21 
22 #define ACP_PHYSICAL_BASE			0x14000
23 
24 /*
25  * In case of I2S SP controller instance, Stoney uses SRAM bank 1 for
26  * playback and SRAM Bank 2 for capture where as in case of BT I2S
27  * Instance, Stoney uses SRAM Bank 3 for playback & SRAM Bank 4 will
28  * be used for capture. Carrizo uses I2S SP controller instance. SRAM Banks
29  * 1, 2, 3, 4 will be used for playback & SRAM Banks 5, 6, 7, 8 will be used
30  * for capture scenario.
31  */
32 #define ACP_SRAM_BANK_1_ADDRESS		0x4002000
33 #define ACP_SRAM_BANK_2_ADDRESS		0x4004000
34 #define ACP_SRAM_BANK_3_ADDRESS		0x4006000
35 #define ACP_SRAM_BANK_4_ADDRESS		0x4008000
36 #define ACP_SRAM_BANK_5_ADDRESS		0x400A000
37 
38 #define ACP_DMA_RESET_TIME			10000
39 #define ACP_CLOCK_EN_TIME_OUT_VALUE		0x000000FF
40 #define ACP_SOFT_RESET_DONE_TIME_OUT_VALUE	0x000000FF
41 #define ACP_DMA_COMPLETE_TIME_OUT_VALUE		0x000000FF
42 
43 #define ACP_SRAM_BASE_ADDRESS			0x4000000
44 #define ACP_DAGB_GRP_SRAM_BASE_ADDRESS		0x4001000
45 #define ACP_DAGB_GRP_SRBM_SRAM_BASE_OFFSET	0x1000
46 #define ACP_INTERNAL_APERTURE_WINDOW_0_ADDRESS	0x00000000
47 #define ACP_INTERNAL_APERTURE_WINDOW_4_ADDRESS	0x01800000
48 
49 #define TO_ACP_I2S_1   0x2
50 #define TO_ACP_I2S_2   0x4
51 #define TO_BLUETOOTH   0x3
52 #define FROM_ACP_I2S_1 0xa
53 #define FROM_ACP_I2S_2 0xb
54 #define FROM_BLUETOOTH 0xb
55 
56 #define I2S_SP_INSTANCE                 0x01
57 #define I2S_BT_INSTANCE                 0x02
58 #define CAP_CHANNEL0			0x00
59 #define CAP_CHANNEL1			0x01
60 
61 #define ACP_TILE_ON_MASK                0x03
62 #define ACP_TILE_OFF_MASK               0x02
63 #define ACP_TILE_ON_RETAIN_REG_MASK     0x1f
64 #define ACP_TILE_OFF_RETAIN_REG_MASK    0x20
65 
66 #define ACP_TILE_P1_MASK                0x3e
67 #define ACP_TILE_P2_MASK                0x3d
68 #define ACP_TILE_DSP0_MASK              0x3b
69 #define ACP_TILE_DSP1_MASK              0x37
70 
71 #define ACP_TILE_DSP2_MASK              0x2f
72 /* Playback DMA channels */
73 #define SYSRAM_TO_ACP_CH_NUM 12
74 #define ACP_TO_I2S_DMA_CH_NUM 13
75 
76 /* Capture DMA channels */
77 #define I2S_TO_ACP_DMA_CH_NUM 14
78 #define ACP_TO_SYSRAM_CH_NUM 15
79 
80 /* Playback DMA Channels for I2S BT instance */
81 #define SYSRAM_TO_ACP_BT_INSTANCE_CH_NUM  8
82 #define ACP_TO_I2S_DMA_BT_INSTANCE_CH_NUM 9
83 
84 /* Capture DMA Channels for I2S BT Instance */
85 #define I2S_TO_ACP_DMA_BT_INSTANCE_CH_NUM 10
86 #define ACP_TO_SYSRAM_BT_INSTANCE_CH_NUM 11
87 
88 #define NUM_DSCRS_PER_CHANNEL 2
89 
90 #define PLAYBACK_START_DMA_DESCR_CH12 0
91 #define PLAYBACK_END_DMA_DESCR_CH12 1
92 #define PLAYBACK_START_DMA_DESCR_CH13 2
93 #define PLAYBACK_END_DMA_DESCR_CH13 3
94 
95 #define CAPTURE_START_DMA_DESCR_CH14 4
96 #define CAPTURE_END_DMA_DESCR_CH14 5
97 #define CAPTURE_START_DMA_DESCR_CH15 6
98 #define CAPTURE_END_DMA_DESCR_CH15 7
99 
100 /* I2S BT Instance DMA Descriptors */
101 #define PLAYBACK_START_DMA_DESCR_CH8 8
102 #define PLAYBACK_END_DMA_DESCR_CH8 9
103 #define PLAYBACK_START_DMA_DESCR_CH9 10
104 #define PLAYBACK_END_DMA_DESCR_CH9 11
105 
106 #define CAPTURE_START_DMA_DESCR_CH10 12
107 #define CAPTURE_END_DMA_DESCR_CH10 13
108 #define CAPTURE_START_DMA_DESCR_CH11 14
109 #define CAPTURE_END_DMA_DESCR_CH11 15
110 
111 #define mmACP_I2S_16BIT_RESOLUTION_EN       0x5209
112 #define ACP_I2S_MIC_16BIT_RESOLUTION_EN 0x01
113 #define ACP_I2S_SP_16BIT_RESOLUTION_EN	0x02
114 #define ACP_I2S_BT_16BIT_RESOLUTION_EN	0x04
115 #define ACP_BT_UART_PAD_SELECT_MASK	0x1
116 
117 enum acp_dma_priority_level {
118 	/* 0x0 Specifies the DMA channel is given normal priority */
119 	ACP_DMA_PRIORITY_LEVEL_NORMAL = 0x0,
120 	/* 0x1 Specifies the DMA channel is given high priority */
121 	ACP_DMA_PRIORITY_LEVEL_HIGH = 0x1,
122 	ACP_DMA_PRIORITY_LEVEL_FORCESIZE = 0xFF
123 };
124 
125 struct audio_substream_data {
126 	dma_addr_t dma_addr;
127 	unsigned int order;
128 	u16 num_of_pages;
129 	u16 i2s_instance;
130 	u16 capture_channel;
131 	u16 direction;
132 	u16 ch1;
133 	u16 ch2;
134 	u16 destination;
135 	u16 dma_dscr_idx_1;
136 	u16 dma_dscr_idx_2;
137 	u32 pte_offset;
138 	u32 sram_bank;
139 	u32 byte_cnt_high_reg_offset;
140 	u32 byte_cnt_low_reg_offset;
141 	u32 dma_curr_dscr;
142 	uint64_t size;
143 	u64 bytescount;
144 	void __iomem *acp_mmio;
145 };
146 
147 struct audio_drv_data {
148 	struct snd_pcm_substream *play_i2ssp_stream;
149 	struct snd_pcm_substream *capture_i2ssp_stream;
150 	struct snd_pcm_substream *play_i2sbt_stream;
151 	struct snd_pcm_substream *capture_i2sbt_stream;
152 	void __iomem *acp_mmio;
153 	u32 asic_type;
154 	snd_pcm_sframes_t delay;
155 };
156 
157 /*
158  * this structure used for platform data transfer between machine driver
159  * and dma driver
160  */
161 struct acp_platform_info {
162 	u16 play_i2s_instance;
163 	u16 cap_i2s_instance;
164 	u16 capture_channel;
165 };
166 
167 union acp_dma_count {
168 	struct {
169 	u32 low;
170 	u32 high;
171 	} bcount;
172 	u64 bytescount;
173 };
174 
175 enum {
176 	ACP_TILE_P1 = 0,
177 	ACP_TILE_P2,
178 	ACP_TILE_DSP0,
179 	ACP_TILE_DSP1,
180 	ACP_TILE_DSP2,
181 };
182 
183 enum {
184 	ACP_DMA_ATTR_SHAREDMEM_TO_DAGB_ONION = 0x0,
185 	ACP_DMA_ATTR_SHARED_MEM_TO_DAGB_GARLIC = 0x1,
186 	ACP_DMA_ATTR_DAGB_ONION_TO_SHAREDMEM = 0x8,
187 	ACP_DMA_ATTR_DAGB_GARLIC_TO_SHAREDMEM = 0x9,
188 	ACP_DMA_ATTR_FORCE_SIZE = 0xF
189 };
190 
191 typedef struct acp_dma_dscr_transfer {
192 	/* Specifies the source memory location for the DMA data transfer. */
193 	u32 src;
194 	/*
195 	 * Specifies the destination memory location to where the data will
196 	 * be transferred.
197 	 */
198 	u32 dest;
199 	/*
200 	 * Specifies the number of bytes need to be transferred
201 	 * from source to destination memory.Transfer direction & IOC enable
202 	 */
203 	u32 xfer_val;
204 	/* Reserved for future use */
205 	u32 reserved;
206 } acp_dma_dscr_transfer_t;
207 
208 extern bool acp_bt_uart_enable;
209 
210 #endif /*__ACP_HW_H */
211