xref: /openbmc/linux/drivers/watchdog/via_wdt.c (revision a06c488d)
1 /*
2  * VIA Chipset Watchdog Driver
3  *
4  * Copyright (C) 2011 Sigfox
5  * License terms: GNU General Public License (GPL) version 2
6  * Author: Marc Vertes <marc.vertes@sigfox.com>
7  * Based on a preliminary version from Harald Welte <HaraldWelte@viatech.com>
8  * Timer code by Wim Van Sebroeck <wim@iguana.be>
9  *
10  * Caveat: PnP must be enabled in BIOS to allow full access to watchdog
11  * control registers. If not, the watchdog must be configured in BIOS manually.
12  */
13 
14 #define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
15 
16 #include <linux/device.h>
17 #include <linux/io.h>
18 #include <linux/jiffies.h>
19 #include <linux/module.h>
20 #include <linux/pci.h>
21 #include <linux/timer.h>
22 #include <linux/watchdog.h>
23 
24 /* Configuration registers relative to the pci device */
25 #define VIA_WDT_MMIO_BASE	0xe8	/* MMIO region base address */
26 #define VIA_WDT_CONF		0xec	/* watchdog enable state */
27 
28 /* Relevant bits for the VIA_WDT_CONF register */
29 #define VIA_WDT_CONF_ENABLE	0x01	/* 1: enable watchdog */
30 #define VIA_WDT_CONF_MMIO	0x02	/* 1: enable watchdog MMIO */
31 
32 /*
33  * The MMIO region contains the watchog control register and the
34  * hardware timer counter.
35  */
36 #define VIA_WDT_MMIO_LEN	8	/* MMIO region length in bytes */
37 #define VIA_WDT_CTL		0	/* MMIO addr+0: state/control reg. */
38 #define VIA_WDT_COUNT		4	/* MMIO addr+4: timer counter reg. */
39 
40 /* Bits for the VIA_WDT_CTL register */
41 #define VIA_WDT_RUNNING		0x01	/* 0: stop, 1: running */
42 #define VIA_WDT_FIRED		0x02	/* 1: restarted by expired watchdog */
43 #define VIA_WDT_PWROFF		0x04	/* 0: reset, 1: poweroff */
44 #define VIA_WDT_DISABLED	0x08	/* 1: timer is disabled */
45 #define VIA_WDT_TRIGGER		0x80	/* 1: start a new countdown */
46 
47 /* Hardware heartbeat in seconds */
48 #define WDT_HW_HEARTBEAT 1
49 
50 /* Timer heartbeat (500ms) */
51 #define WDT_HEARTBEAT	(HZ/2)	/* should be <= ((WDT_HW_HEARTBEAT*HZ)/2) */
52 
53 /* User space timeout in seconds */
54 #define WDT_TIMEOUT_MAX	1023	/* approx. 17 min. */
55 #define WDT_TIMEOUT	60
56 static int timeout = WDT_TIMEOUT;
57 module_param(timeout, int, 0);
58 MODULE_PARM_DESC(timeout, "Watchdog timeout in seconds, between 1 and 1023 "
59 	"(default = " __MODULE_STRING(WDT_TIMEOUT) ")");
60 
61 static bool nowayout = WATCHDOG_NOWAYOUT;
62 module_param(nowayout, bool, 0);
63 MODULE_PARM_DESC(nowayout, "Watchdog cannot be stopped once started "
64 	"(default = " __MODULE_STRING(WATCHDOG_NOWAYOUT) ")");
65 
66 static struct watchdog_device wdt_dev;
67 static struct resource wdt_res;
68 static void __iomem *wdt_mem;
69 static unsigned int mmio;
70 static void wdt_timer_tick(unsigned long data);
71 static DEFINE_TIMER(timer, wdt_timer_tick, 0, 0);
72 					/* The timer that pings the watchdog */
73 static unsigned long next_heartbeat;	/* the next_heartbeat for the timer */
74 
75 static inline void wdt_reset(void)
76 {
77 	unsigned int ctl = readl(wdt_mem);
78 
79 	writel(ctl | VIA_WDT_TRIGGER, wdt_mem);
80 }
81 
82 /*
83  * Timer tick: the timer will make sure that the watchdog timer hardware
84  * is being reset in time. The conditions to do this are:
85  *  1) the watchog timer has been started and /dev/watchdog is open
86  *     and there is still time left before userspace should send the
87  *     next heartbeat/ping. (note: the internal heartbeat is much smaller
88  *     then the external/userspace heartbeat).
89  *  2) the watchdog timer has been stopped by userspace.
90  */
91 static void wdt_timer_tick(unsigned long data)
92 {
93 	if (time_before(jiffies, next_heartbeat) ||
94 	   (!watchdog_active(&wdt_dev))) {
95 		wdt_reset();
96 		mod_timer(&timer, jiffies + WDT_HEARTBEAT);
97 	} else
98 		pr_crit("I will reboot your machine !\n");
99 }
100 
101 static int wdt_ping(struct watchdog_device *wdd)
102 {
103 	/* calculate when the next userspace timeout will be */
104 	next_heartbeat = jiffies + wdd->timeout * HZ;
105 	return 0;
106 }
107 
108 static int wdt_start(struct watchdog_device *wdd)
109 {
110 	unsigned int ctl = readl(wdt_mem);
111 
112 	writel(wdd->timeout, wdt_mem + VIA_WDT_COUNT);
113 	writel(ctl | VIA_WDT_RUNNING | VIA_WDT_TRIGGER, wdt_mem);
114 	wdt_ping(wdd);
115 	mod_timer(&timer, jiffies + WDT_HEARTBEAT);
116 	return 0;
117 }
118 
119 static int wdt_stop(struct watchdog_device *wdd)
120 {
121 	unsigned int ctl = readl(wdt_mem);
122 
123 	writel(ctl & ~VIA_WDT_RUNNING, wdt_mem);
124 	return 0;
125 }
126 
127 static int wdt_set_timeout(struct watchdog_device *wdd,
128 			   unsigned int new_timeout)
129 {
130 	writel(new_timeout, wdt_mem + VIA_WDT_COUNT);
131 	wdd->timeout = new_timeout;
132 	return 0;
133 }
134 
135 static const struct watchdog_info wdt_info = {
136 	.identity =	"VIA watchdog",
137 	.options =	WDIOF_CARDRESET |
138 			WDIOF_SETTIMEOUT |
139 			WDIOF_MAGICCLOSE |
140 			WDIOF_KEEPALIVEPING,
141 };
142 
143 static const struct watchdog_ops wdt_ops = {
144 	.owner =	THIS_MODULE,
145 	.start =	wdt_start,
146 	.stop =		wdt_stop,
147 	.ping =		wdt_ping,
148 	.set_timeout =	wdt_set_timeout,
149 };
150 
151 static struct watchdog_device wdt_dev = {
152 	.info =		&wdt_info,
153 	.ops =		&wdt_ops,
154 	.min_timeout =	1,
155 	.max_timeout =	WDT_TIMEOUT_MAX,
156 };
157 
158 static int wdt_probe(struct pci_dev *pdev,
159 			       const struct pci_device_id *ent)
160 {
161 	unsigned char conf;
162 	int ret = -ENODEV;
163 
164 	if (pci_enable_device(pdev)) {
165 		dev_err(&pdev->dev, "cannot enable PCI device\n");
166 		return -ENODEV;
167 	}
168 
169 	/*
170 	 * Allocate a MMIO region which contains watchdog control register
171 	 * and counter, then configure the watchdog to use this region.
172 	 * This is possible only if PnP is properly enabled in BIOS.
173 	 * If not, the watchdog must be configured in BIOS manually.
174 	 */
175 	if (allocate_resource(&iomem_resource, &wdt_res, VIA_WDT_MMIO_LEN,
176 			      0xf0000000, 0xffffff00, 0xff, NULL, NULL)) {
177 		dev_err(&pdev->dev, "MMIO allocation failed\n");
178 		goto err_out_disable_device;
179 	}
180 
181 	pci_write_config_dword(pdev, VIA_WDT_MMIO_BASE, wdt_res.start);
182 	pci_read_config_byte(pdev, VIA_WDT_CONF, &conf);
183 	conf |= VIA_WDT_CONF_ENABLE | VIA_WDT_CONF_MMIO;
184 	pci_write_config_byte(pdev, VIA_WDT_CONF, conf);
185 
186 	pci_read_config_dword(pdev, VIA_WDT_MMIO_BASE, &mmio);
187 	if (mmio) {
188 		dev_info(&pdev->dev, "VIA Chipset watchdog MMIO: %x\n", mmio);
189 	} else {
190 		dev_err(&pdev->dev, "MMIO setting failed. Check BIOS.\n");
191 		goto err_out_resource;
192 	}
193 
194 	if (!request_mem_region(mmio, VIA_WDT_MMIO_LEN, "via_wdt")) {
195 		dev_err(&pdev->dev, "MMIO region busy\n");
196 		goto err_out_resource;
197 	}
198 
199 	wdt_mem = ioremap(mmio, VIA_WDT_MMIO_LEN);
200 	if (wdt_mem == NULL) {
201 		dev_err(&pdev->dev, "cannot remap VIA wdt MMIO registers\n");
202 		goto err_out_release;
203 	}
204 
205 	if (timeout < 1 || timeout > WDT_TIMEOUT_MAX)
206 		timeout = WDT_TIMEOUT;
207 
208 	wdt_dev.timeout = timeout;
209 	wdt_dev.parent = &pdev->dev;
210 	watchdog_set_nowayout(&wdt_dev, nowayout);
211 	if (readl(wdt_mem) & VIA_WDT_FIRED)
212 		wdt_dev.bootstatus |= WDIOF_CARDRESET;
213 
214 	ret = watchdog_register_device(&wdt_dev);
215 	if (ret)
216 		goto err_out_iounmap;
217 
218 	/* start triggering, in case of watchdog already enabled by BIOS */
219 	mod_timer(&timer, jiffies + WDT_HEARTBEAT);
220 	return 0;
221 
222 err_out_iounmap:
223 	iounmap(wdt_mem);
224 err_out_release:
225 	release_mem_region(mmio, VIA_WDT_MMIO_LEN);
226 err_out_resource:
227 	release_resource(&wdt_res);
228 err_out_disable_device:
229 	pci_disable_device(pdev);
230 	return ret;
231 }
232 
233 static void wdt_remove(struct pci_dev *pdev)
234 {
235 	watchdog_unregister_device(&wdt_dev);
236 	del_timer_sync(&timer);
237 	iounmap(wdt_mem);
238 	release_mem_region(mmio, VIA_WDT_MMIO_LEN);
239 	release_resource(&wdt_res);
240 	pci_disable_device(pdev);
241 }
242 
243 static const struct pci_device_id wdt_pci_table[] = {
244 	{ PCI_DEVICE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_CX700) },
245 	{ PCI_DEVICE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_VX800) },
246 	{ PCI_DEVICE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_VX855) },
247 	{ 0 }
248 };
249 
250 static struct pci_driver wdt_driver = {
251 	.name		= "via_wdt",
252 	.id_table	= wdt_pci_table,
253 	.probe		= wdt_probe,
254 	.remove		= wdt_remove,
255 };
256 
257 module_pci_driver(wdt_driver);
258 
259 MODULE_AUTHOR("Marc Vertes");
260 MODULE_DESCRIPTION("Driver for watchdog timer on VIA chipset");
261 MODULE_LICENSE("GPL");
262