1# 2# 1-wire bus master configuration 3# 4 5menu "1-wire Bus Masters" 6 depends on W1 7 8config W1_MASTER_MATROX 9 tristate "Matrox G400 transport layer for 1-wire" 10 depends on W1 && PCI 11 help 12 Say Y here if you want to communicate with your 1-wire devices 13 using Matrox's G400 GPIO pins. 14 15 This support is also available as a module. If so, the module 16 will be called matrox_w1.ko. 17 18config W1_MASTER_DS2490 19 tristate "DS2490 USB <-> W1 transport layer for 1-wire" 20 depends on W1 && USB 21 help 22 Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges, 23 for example DS9490*. 24 25 This support is also available as a module. If so, the module 26 will be called ds2490.ko. 27 28config W1_MASTER_DS2482 29 tristate "Maxim DS2482 I2C to 1-Wire bridge" 30 depends on I2C && W1 && EXPERIMENTAL 31 help 32 If you say yes here you get support for the Maxim DS2482 33 I2C to 1-Wire bridge. 34 35 This driver can also be built as a module. If so, the module 36 will be called ds2482. 37 38config W1_MASTER_DS1WM 39 tristate "Maxim DS1WM 1-wire busmaster" 40 depends on W1 && ARM 41 help 42 Say Y here to enable the DS1WM 1-wire driver, such as that 43 in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like 44 hx4700. 45 46endmenu 47 48