1# 2# 1-wire bus master configuration 3# 4 5menu "1-wire Bus Masters" 6 7config W1_MASTER_MATROX 8 tristate "Matrox G400 transport layer for 1-wire" 9 depends on PCI 10 help 11 Say Y here if you want to communicate with your 1-wire devices 12 using Matrox's G400 GPIO pins. 13 14 This support is also available as a module. If so, the module 15 will be called matrox_w1.ko. 16 17config W1_MASTER_DS2490 18 tristate "DS2490 USB <-> W1 transport layer for 1-wire" 19 depends on USB 20 help 21 Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges, 22 for example DS9490*. 23 24 This support is also available as a module. If so, the module 25 will be called ds2490.ko. 26 27config W1_MASTER_DS2482 28 tristate "Maxim DS2482 I2C to 1-Wire bridge" 29 depends on I2C && EXPERIMENTAL 30 help 31 If you say yes here you get support for the Maxim DS2482 32 I2C to 1-Wire bridge. 33 34 This driver can also be built as a module. If so, the module 35 will be called ds2482. 36 37config W1_MASTER_DS1WM 38 tristate "Maxim DS1WM 1-wire busmaster" 39 depends on W1 && ARM 40 help 41 Say Y here to enable the DS1WM 1-wire driver, such as that 42 in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like 43 hx4700. 44 45endmenu 46 47