1menu "Dallas's 1-wire bus" 2 3config W1 4 tristate "Dallas's 1-wire support" 5 ---help--- 6 Dallas's 1-wire bus is usefull to connect slow 1-pin devices 7 such as iButtons and thermal sensors. 8 9 If you want W1 support, you should say Y here. 10 11 This W1 support can also be built as a module. If so, the module 12 will be called wire.ko. 13 14config W1_MATROX 15 tristate "Matrox G400 transport layer for 1-wire" 16 depends on W1 && PCI 17 help 18 Say Y here if you want to communicate with your 1-wire devices 19 using Matrox's G400 GPIO pins. 20 21 This support is also available as a module. If so, the module 22 will be called matrox_w1.ko. 23 24config W1_DS9490 25 tristate "DS9490R transport layer driver" 26 depends on W1 && USB 27 help 28 Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge. 29 30 This support is also available as a module. If so, the module 31 will be called ds9490r.ko. 32 33config W1_DS9490R_BRIDGE 34 tristate "DS9490R USB <-> W1 transport layer for 1-wire" 35 depends on W1_DS9490 36 help 37 Say Y here if you want to communicate with your 1-wire devices 38 using DS9490R USB bridge. 39 40 This support is also available as a module. If so, the module 41 will be called ds_w1_bridge.ko. 42 43config W1_THERM 44 tristate "Thermal family implementation" 45 depends on W1 46 help 47 Say Y here if you want to connect 1-wire thermal sensors to you 48 wire. 49 50config W1_SMEM 51 tristate "Simple 64bit memory family implementation" 52 depends on W1 53 help 54 Say Y here if you want to connect 1-wire 55 simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire. 56 57endmenu 58