1# 2# Physical Layer USB driver configuration 3# 4menu "USB Physical Layer drivers" 5 6config USB_PHY 7 select EXTCON 8 def_bool n 9 10# 11# USB Transceiver Drivers 12# 13config AB8500_USB 14 tristate "AB8500 USB Transceiver Driver" 15 depends on AB8500_CORE 16 select USB_PHY 17 help 18 Enable this to support the USB OTG transceiver in AB8500 chip. 19 This transceiver supports high and full speed devices plus, 20 in host mode, low speed. 21 22config FSL_USB2_OTG 23 bool "Freescale USB OTG Transceiver Driver" 24 depends on USB_EHCI_FSL && USB_FSL_USB2 && USB_OTG_FSM && PM 25 depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, this can't be 'y' 26 select USB_PHY 27 help 28 Enable this to support Freescale USB OTG transceiver. 29 30config ISP1301_OMAP 31 tristate "Philips ISP1301 with OMAP OTG" 32 depends on I2C && ARCH_OMAP_OTG 33 depends on USB 34 depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, this can't be 'y' 35 select USB_PHY 36 help 37 If you say yes here you get support for the Philips ISP1301 38 USB-On-The-Go transceiver working with the OMAP OTG controller. 39 The ISP1301 is a full speed USB transceiver which is used in 40 products including H2, H3, and H4 development boards for Texas 41 Instruments OMAP processors. 42 43 This driver can also be built as a module. If so, the module 44 will be called phy-isp1301-omap. 45 46config KEYSTONE_USB_PHY 47 tristate "Keystone USB PHY Driver" 48 depends on ARCH_KEYSTONE || COMPILE_TEST 49 depends on NOP_USB_XCEIV 50 help 51 Enable this to support Keystone USB phy. This driver provides 52 interface to interact with USB 2.0 and USB 3.0 PHY that is part 53 of the Keystone SOC. 54 55config NOP_USB_XCEIV 56 tristate "NOP USB Transceiver Driver" 57 depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, NOP can't be built-in 58 select USB_PHY 59 help 60 This driver is to be used by all the usb transceiver which are either 61 built-in with usb ip or which are autonomous and doesn't require any 62 phy programming such as ISP1x04 etc. 63 64config AM335X_CONTROL_USB 65 tristate 66 67config AM335X_PHY_USB 68 tristate "AM335x USB PHY Driver" 69 depends on ARM || COMPILE_TEST 70 depends on NOP_USB_XCEIV 71 select USB_PHY 72 select AM335X_CONTROL_USB 73 select USB_COMMON 74 help 75 This driver provides PHY support for that phy which part for the 76 AM335x SoC. 77 78config TWL6030_USB 79 tristate "TWL6030 USB Transceiver Driver" 80 depends on TWL4030_CORE && OMAP_USB2 && USB_MUSB_OMAP2PLUS 81 depends on OF 82 help 83 Enable this to support the USB OTG transceiver on TWL6030 84 family chips. This TWL6030 transceiver has the VBUS and ID GND 85 and OTG SRP events capabilities. For all other transceiver functionality 86 UTMI PHY is embedded in OMAP4430. The internal PHY configurations APIs 87 are hooked to this driver through platform_data structure. 88 The definition of internal PHY APIs are in the mach-omap2 layer. 89 90config USB_GPIO_VBUS 91 tristate "GPIO based peripheral-only VBUS sensing 'transceiver'" 92 depends on GPIOLIB || COMPILE_TEST 93 depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, this can't be 'y' 94 select USB_PHY 95 help 96 Provides simple GPIO VBUS sensing for controllers with an 97 internal transceiver via the usb_phy interface, and 98 optionally control of a D+ pullup GPIO as well as a VBUS 99 current limit regulator. 100 101config OMAP_OTG 102 tristate "OMAP USB OTG controller driver" 103 depends on ARCH_OMAP_OTG && EXTCON 104 help 105 Enable this to support some transceivers on OMAP1 platforms. OTG 106 controller is needed to switch between host and peripheral modes. 107 108 This driver can also be built as a module. If so, the module 109 will be called phy-omap-otg. 110 111config TAHVO_USB 112 tristate "Tahvo USB transceiver driver" 113 depends on MFD_RETU 114 depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, this can't be 'y' 115 select USB_PHY 116 help 117 Enable this to support USB transceiver on Tahvo. This is used 118 at least on Nokia 770. 119 120config TAHVO_USB_HOST_BY_DEFAULT 121 depends on TAHVO_USB 122 bool "Device in USB host mode by default" 123 help 124 Say Y here, if you want the device to enter USB host mode 125 by default on bootup. 126 127config USB_ISP1301 128 tristate "NXP ISP1301 USB transceiver support" 129 depends on USB || USB_GADGET 130 depends on I2C 131 select USB_PHY 132 help 133 Say Y here to add support for the NXP ISP1301 USB transceiver driver. 134 This chip is typically used as USB transceiver for USB host, gadget 135 and OTG drivers (to be selected separately). 136 137 To compile this driver as a module, choose M here: the 138 module will be called phy-isp1301. 139 140config USB_MV_OTG 141 tristate "Marvell USB OTG support" 142 depends on USB_EHCI_MV && USB_MV_UDC && PM && USB_OTG 143 depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, this can't be 'y' 144 select USB_PHY 145 help 146 Say Y here if you want to build Marvell USB OTG transciever 147 driver in kernel (including PXA and MMP series). This driver 148 implements role switch between EHCI host driver and gadget driver. 149 150 To compile this driver as a module, choose M here. 151 152config USB_MXS_PHY 153 tristate "Freescale MXS USB PHY support" 154 depends on ARCH_MXC || ARCH_MXS 155 select STMP_DEVICE 156 select USB_PHY 157 help 158 Enable this to support the Freescale MXS USB PHY. 159 160 MXS Phy is used by some of the i.MX SoCs, for example imx23/28/6x. 161 162config USB_TEGRA_PHY 163 tristate "NVIDIA Tegra USB PHY Driver" 164 depends on ARCH_TEGRA 165 select USB_COMMON 166 select USB_PHY 167 select USB_ULPI 168 help 169 This driver provides PHY support for the USB controllers found 170 on NVIDIA Tegra SoC's. 171 172config USB_ULPI 173 bool "Generic ULPI Transceiver Driver" 174 depends on ARM || ARM64 175 select USB_ULPI_VIEWPORT 176 help 177 Enable this to support ULPI connected USB OTG transceivers which 178 are likely found on embedded boards. 179 180config USB_ULPI_VIEWPORT 181 bool 182 help 183 Provides read/write operations to the ULPI phy register set for 184 controllers with a viewport register (e.g. Chipidea/ARC controllers). 185 186endmenu 187