1# 2# USB Imaging devices configuration 3# 4comment "USB Imaging devices" 5 6config USB_MDC800 7 tristate "USB Mustek MDC800 Digital Camera support" 8 ---help--- 9 Say Y here if you want to connect this type of still camera to 10 your computer's USB port. This driver can be used with gphoto 0.4.3 11 and higher (look at <http://www.gphoto.org/>). 12 To use it create a device node with "mknod /dev/mustek c 180 32" and 13 configure it in your software. 14 15 To compile this driver as a module, choose M here: the 16 module will be called mdc800. 17 18config USB_MICROTEK 19 tristate "Microtek X6USB scanner support" 20 depends on SCSI 21 help 22 Say Y here if you want support for the Microtek X6USB and 23 possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. 24 Support for anything but the X6 is experimental. 25 Please report failures and successes. 26 The scanner will appear as a scsi generic device to the rest 27 of the system. Scsi support is required. 28 This driver can be compiled as a module, called microtek. 29