1# 2# USB Imaging devices configuration 3# 4comment "USB Imaging devices" 5 depends on USB 6 7config USB_MDC800 8 tristate "USB Mustek MDC800 Digital Camera support" 9 depends on USB 10 ---help--- 11 Say Y here if you want to connect this type of still camera to 12 your computer's USB port. This driver can be used with gphoto 0.4.3 13 and higher (look at <http://www.gphoto.org/>). 14 To use it create a device node with "mknod /dev/mustek c 180 32" and 15 configure it in your software. 16 17 To compile this driver as a module, choose M here: the 18 module will be called mdc800. 19 20config USB_MICROTEK 21 tristate "Microtek X6USB scanner support" 22 depends on USB && SCSI 23 help 24 Say Y here if you want support for the Microtek X6USB and 25 possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. 26 Support for anything but the X6 is experimental. 27 Please report failures and successes. 28 The scanner will appear as a scsi generic device to the rest 29 of the system. Scsi support is required. 30 This driver can be compiled as a module, called microtek. 31