1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3 * ehci-omap.c - driver for USBHOST on OMAP3/4 processors
4 *
5 * Bus Glue for the EHCI controllers in OMAP3/4
6 * Tested on several OMAP3 boards, and OMAP4 Pandaboard
7 *
8 * Copyright (C) 2007-2013 Texas Instruments, Inc.
9 * Author: Vikram Pandita <vikram.pandita@ti.com>
10 * Author: Anand Gadiyar <gadiyar@ti.com>
11 * Author: Keshava Munegowda <keshava_mgowda@ti.com>
12 * Author: Roger Quadros <rogerq@ti.com>
13 *
14 * Copyright (C) 2009 Nokia Corporation
15 * Contact: Felipe Balbi <felipe.balbi@nokia.com>
16 *
17 * Based on "ehci-fsl.c" and "ehci-au1xxx.c" ehci glue layers
18 */
19
20 #include <linux/kernel.h>
21 #include <linux/module.h>
22 #include <linux/io.h>
23 #include <linux/platform_device.h>
24 #include <linux/slab.h>
25 #include <linux/usb/ulpi.h>
26 #include <linux/pm_runtime.h>
27 #include <linux/clk.h>
28 #include <linux/usb.h>
29 #include <linux/usb/hcd.h>
30 #include <linux/of.h>
31 #include <linux/dma-mapping.h>
32
33 #include "ehci.h"
34
35 #include <linux/platform_data/usb-omap.h>
36
37 /* EHCI Register Set */
38 #define EHCI_INSNREG04 (0xA0)
39 #define EHCI_INSNREG04_DISABLE_UNSUSPEND (1 << 5)
40 #define EHCI_INSNREG05_ULPI (0xA4)
41 #define EHCI_INSNREG05_ULPI_CONTROL_SHIFT 31
42 #define EHCI_INSNREG05_ULPI_PORTSEL_SHIFT 24
43 #define EHCI_INSNREG05_ULPI_OPSEL_SHIFT 22
44 #define EHCI_INSNREG05_ULPI_REGADD_SHIFT 16
45 #define EHCI_INSNREG05_ULPI_EXTREGADD_SHIFT 8
46 #define EHCI_INSNREG05_ULPI_WRDATA_SHIFT 0
47
48 #define DRIVER_DESC "OMAP-EHCI Host Controller driver"
49
50 static const char hcd_name[] = "ehci-omap";
51
52 /*-------------------------------------------------------------------------*/
53
54 struct omap_hcd {
55 struct usb_phy *phy[OMAP3_HS_USB_PORTS]; /* one PHY for each port */
56 int nports;
57 };
58
ehci_write(void __iomem * base,u32 reg,u32 val)59 static inline void ehci_write(void __iomem *base, u32 reg, u32 val)
60 {
61 __raw_writel(val, base + reg);
62 }
63
64 /* configure so an HC device and id are always provided */
65 /* always called with process context; sleeping is OK */
66
67 static struct hc_driver __read_mostly ehci_omap_hc_driver;
68
69 static const struct ehci_driver_overrides ehci_omap_overrides __initconst = {
70 .extra_priv_size = sizeof(struct omap_hcd),
71 };
72
73 /**
74 * ehci_hcd_omap_probe - initialize TI-based HCDs
75 * @pdev: Pointer to this platform device's information
76 *
77 * Allocates basic resources for this USB host controller, and
78 * then invokes the start() method for the HCD associated with it
79 * through the hotplug entry's driver_data.
80 */
ehci_hcd_omap_probe(struct platform_device * pdev)81 static int ehci_hcd_omap_probe(struct platform_device *pdev)
82 {
83 struct device *dev = &pdev->dev;
84 struct usbhs_omap_platform_data *pdata = dev_get_platdata(dev);
85 struct resource *res;
86 struct usb_hcd *hcd;
87 void __iomem *regs;
88 int ret;
89 int irq;
90 int i;
91 struct omap_hcd *omap;
92
93 if (usb_disabled())
94 return -ENODEV;
95
96 if (!dev->parent) {
97 dev_err(dev, "Missing parent device\n");
98 return -ENODEV;
99 }
100
101 /* For DT boot, get platform data from parent. i.e. usbhshost */
102 if (dev->of_node) {
103 pdata = dev_get_platdata(dev->parent);
104 dev->platform_data = pdata;
105 }
106
107 if (!pdata) {
108 dev_err(dev, "Missing platform data\n");
109 return -ENODEV;
110 }
111
112 irq = platform_get_irq(pdev, 0);
113 if (irq < 0)
114 return irq;
115
116 regs = devm_platform_get_and_ioremap_resource(pdev, 0, &res);
117 if (IS_ERR(regs))
118 return PTR_ERR(regs);
119
120 /*
121 * Right now device-tree probed devices don't get dma_mask set.
122 * Since shared usb code relies on it, set it here for now.
123 * Once we have dma capability bindings this can go away.
124 */
125 ret = dma_coerce_mask_and_coherent(dev, DMA_BIT_MASK(32));
126 if (ret)
127 return ret;
128
129 ret = -ENODEV;
130 hcd = usb_create_hcd(&ehci_omap_hc_driver, dev,
131 dev_name(dev));
132 if (!hcd) {
133 dev_err(dev, "Failed to create HCD\n");
134 return -ENOMEM;
135 }
136
137 hcd->rsrc_start = res->start;
138 hcd->rsrc_len = resource_size(res);
139 hcd->regs = regs;
140 hcd_to_ehci(hcd)->caps = regs;
141
142 omap = (struct omap_hcd *)hcd_to_ehci(hcd)->priv;
143 omap->nports = pdata->nports;
144
145 platform_set_drvdata(pdev, hcd);
146
147 /* get the PHY devices if needed */
148 for (i = 0 ; i < omap->nports ; i++) {
149 struct usb_phy *phy;
150
151 /* get the PHY device */
152 phy = devm_usb_get_phy_by_phandle(dev, "phys", i);
153 if (IS_ERR(phy)) {
154 ret = PTR_ERR(phy);
155 if (ret == -ENODEV) { /* no PHY */
156 phy = NULL;
157 continue;
158 }
159
160 if (ret != -EPROBE_DEFER)
161 dev_err(dev, "Can't get PHY for port %d: %d\n",
162 i, ret);
163 goto err_phy;
164 }
165
166 omap->phy[i] = phy;
167
168 if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) {
169 usb_phy_init(omap->phy[i]);
170 /* bring PHY out of suspend */
171 usb_phy_set_suspend(omap->phy[i], 0);
172 }
173 }
174
175 pm_runtime_enable(dev);
176 pm_runtime_get_sync(dev);
177
178 /*
179 * An undocumented "feature" in the OMAP3 EHCI controller,
180 * causes suspended ports to be taken out of suspend when
181 * the USBCMD.Run/Stop bit is cleared (for example when
182 * we do ehci_bus_suspend).
183 * This breaks suspend-resume if the root-hub is allowed
184 * to suspend. Writing 1 to this undocumented register bit
185 * disables this feature and restores normal behavior.
186 */
187 ehci_write(regs, EHCI_INSNREG04,
188 EHCI_INSNREG04_DISABLE_UNSUSPEND);
189
190 ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
191 if (ret) {
192 dev_err(dev, "failed to add hcd with err %d\n", ret);
193 goto err_pm_runtime;
194 }
195 device_wakeup_enable(hcd->self.controller);
196
197 /*
198 * Bring PHYs out of reset for non PHY modes.
199 * Even though HSIC mode is a PHY-less mode, the reset
200 * line exists between the chips and can be modelled
201 * as a PHY device for reset control.
202 */
203 for (i = 0; i < omap->nports; i++) {
204 if (!omap->phy[i] ||
205 pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY)
206 continue;
207
208 usb_phy_init(omap->phy[i]);
209 /* bring PHY out of suspend */
210 usb_phy_set_suspend(omap->phy[i], 0);
211 }
212
213 return 0;
214
215 err_pm_runtime:
216 pm_runtime_put_sync(dev);
217 pm_runtime_disable(dev);
218
219 err_phy:
220 for (i = 0; i < omap->nports; i++) {
221 if (omap->phy[i])
222 usb_phy_shutdown(omap->phy[i]);
223 }
224
225 usb_put_hcd(hcd);
226
227 return ret;
228 }
229
230
231 /**
232 * ehci_hcd_omap_remove - shutdown processing for EHCI HCDs
233 * @pdev: USB Host Controller being removed
234 *
235 * Reverses the effect of usb_ehci_hcd_omap_probe(), first invoking
236 * the HCD's stop() method. It is always called from a thread
237 * context, normally "rmmod", "apmd", or something similar.
238 */
ehci_hcd_omap_remove(struct platform_device * pdev)239 static void ehci_hcd_omap_remove(struct platform_device *pdev)
240 {
241 struct device *dev = &pdev->dev;
242 struct usb_hcd *hcd = dev_get_drvdata(dev);
243 struct omap_hcd *omap = (struct omap_hcd *)hcd_to_ehci(hcd)->priv;
244 int i;
245
246 usb_remove_hcd(hcd);
247
248 for (i = 0; i < omap->nports; i++) {
249 if (omap->phy[i])
250 usb_phy_shutdown(omap->phy[i]);
251 }
252
253 usb_put_hcd(hcd);
254 pm_runtime_put_sync(dev);
255 pm_runtime_disable(dev);
256 }
257
258 static const struct of_device_id omap_ehci_dt_ids[] = {
259 { .compatible = "ti,ehci-omap" },
260 { }
261 };
262
263 MODULE_DEVICE_TABLE(of, omap_ehci_dt_ids);
264
265 static struct platform_driver ehci_hcd_omap_driver = {
266 .probe = ehci_hcd_omap_probe,
267 .remove_new = ehci_hcd_omap_remove,
268 .shutdown = usb_hcd_platform_shutdown,
269 /*.suspend = ehci_hcd_omap_suspend, */
270 /*.resume = ehci_hcd_omap_resume, */
271 .driver = {
272 .name = hcd_name,
273 .of_match_table = omap_ehci_dt_ids,
274 }
275 };
276
277 /*-------------------------------------------------------------------------*/
278
ehci_omap_init(void)279 static int __init ehci_omap_init(void)
280 {
281 if (usb_disabled())
282 return -ENODEV;
283
284 ehci_init_driver(&ehci_omap_hc_driver, &ehci_omap_overrides);
285 return platform_driver_register(&ehci_hcd_omap_driver);
286 }
287 module_init(ehci_omap_init);
288
ehci_omap_cleanup(void)289 static void __exit ehci_omap_cleanup(void)
290 {
291 platform_driver_unregister(&ehci_hcd_omap_driver);
292 }
293 module_exit(ehci_omap_cleanup);
294
295 MODULE_ALIAS("platform:ehci-omap");
296 MODULE_AUTHOR("Texas Instruments, Inc.");
297 MODULE_AUTHOR("Felipe Balbi <felipe.balbi@nokia.com>");
298 MODULE_AUTHOR("Roger Quadros <rogerq@ti.com>");
299
300 MODULE_DESCRIPTION(DRIVER_DESC);
301 MODULE_LICENSE("GPL");
302