1# 2# TI SOC drivers 3# 4menuconfig SOC_TI 5 bool "TI SOC drivers support" 6 7if SOC_TI 8 9config KEYSTONE_NAVIGATOR_QMSS 10 tristate "Keystone Queue Manager Sub System" 11 depends on ARCH_KEYSTONE 12 help 13 Say y here to support the Keystone multicore Navigator Queue 14 Manager support. The Queue Manager is a hardware module that 15 is responsible for accelerating management of the packet queues. 16 Packets are queued/de-queued by writing/reading descriptor address 17 to a particular memory mapped location in the Queue Manager module. 18 19 If unsure, say N. 20 21config KEYSTONE_NAVIGATOR_DMA 22 tristate "TI Keystone Navigator Packet DMA support" 23 depends on ARCH_KEYSTONE 24 help 25 Say y tp enable support for the Keystone Navigator Packet DMA on 26 on Keystone family of devices. It sets up the dma channels for the 27 Queue Manager Sub System. 28 29 If unsure, say N. 30 31config AMX3_PM 32 tristate "AMx3 Power Management" 33 depends on SOC_AM33XX || SOC_AM43XX 34 depends on WKUP_M3_IPC && TI_EMIF_SRAM && SRAM 35 help 36 Enable power management on AM335x and AM437x. Required for suspend to mem 37 and standby states on both AM335x and AM437x platforms and for deeper cpuidle 38 c-states on AM335x. 39 40config WKUP_M3_IPC 41 tristate "TI AMx3 Wkup-M3 IPC Driver" 42 depends on WKUP_M3_RPROC 43 depends on OMAP2PLUS_MBOX 44 help 45 TI AM33XX and AM43XX have a Cortex M3, the Wakeup M3, to handle 46 low power transitions. This IPC driver provides the necessary API 47 to communicate and use the Wakeup M3 for PM features like suspend 48 resume and boots it using wkup_m3_rproc driver. 49 50config TI_SCI_PM_DOMAINS 51 tristate "TI SCI PM Domains Driver" 52 depends on TI_SCI_PROTOCOL 53 depends on PM_GENERIC_DOMAINS 54 help 55 Generic power domain implementation for TI device implementing 56 the TI SCI protocol. 57 58 To compile this as a module, choose M here. The module will be 59 called ti_sci_pm_domains. Note this is needed early in boot before 60 rootfs may be available. 61 62endif # SOC_TI 63