1# 2# TI SOC drivers 3# 4menuconfig SOC_TI 5 bool "TI SOC drivers support" 6 7if SOC_TI 8 9config KEYSTONE_NAVIGATOR_QMSS 10 tristate "Keystone Queue Manager Sub System" 11 depends on ARCH_KEYSTONE 12 help 13 Say y here to support the Keystone multicore Navigator Queue 14 Manager support. The Queue Manager is a hardware module that 15 is responsible for accelerating management of the packet queues. 16 Packets are queued/de-queued by writing/reading descriptor address 17 to a particular memory mapped location in the Queue Manager module. 18 19 If unsure, say N. 20 21config KEYSTONE_NAVIGATOR_DMA 22 tristate "TI Keystone Navigator Packet DMA support" 23 depends on ARCH_KEYSTONE 24 help 25 Say y tp enable support for the Keystone Navigator Packet DMA on 26 on Keystone family of devices. It sets up the dma channels for the 27 Queue Manager Sub System. 28 29 If unsure, say N. 30 31config WKUP_M3_IPC 32 tristate "TI AMx3 Wkup-M3 IPC Driver" 33 depends on WKUP_M3_RPROC 34 depends on OMAP2PLUS_MBOX 35 help 36 TI AM33XX and AM43XX have a Cortex M3, the Wakeup M3, to handle 37 low power transitions. This IPC driver provides the necessary API 38 to communicate and use the Wakeup M3 for PM features like suspend 39 resume and boots it using wkup_m3_rproc driver. 40 41config TI_SCI_PM_DOMAINS 42 tristate "TI SCI PM Domains Driver" 43 depends on TI_SCI_PROTOCOL 44 depends on PM_GENERIC_DOMAINS 45 help 46 Generic power domain implementation for TI device implementing 47 the TI SCI protocol. 48 49 To compile this as a module, choose M here. The module will be 50 called ti_sci_pm_domains. Note this is needed early in boot before 51 rootfs may be available. 52 53endif # SOC_TI 54