1# 64-bit ARM SoCs from TI 2if ARM64 3 4if ARCH_K3 5 6config ARCH_K3_AM6_SOC 7 bool "K3 AM6 SoC" 8 help 9 Enable support for TI's AM6 SoC Family support 10 11endif 12 13endif 14 15# 16# TI SOC drivers 17# 18menuconfig SOC_TI 19 bool "TI SOC drivers support" 20 21if SOC_TI 22 23config KEYSTONE_NAVIGATOR_QMSS 24 tristate "Keystone Queue Manager Sub System" 25 depends on ARCH_KEYSTONE 26 help 27 Say y here to support the Keystone multicore Navigator Queue 28 Manager support. The Queue Manager is a hardware module that 29 is responsible for accelerating management of the packet queues. 30 Packets are queued/de-queued by writing/reading descriptor address 31 to a particular memory mapped location in the Queue Manager module. 32 33 If unsure, say N. 34 35config KEYSTONE_NAVIGATOR_DMA 36 tristate "TI Keystone Navigator Packet DMA support" 37 depends on ARCH_KEYSTONE 38 help 39 Say y tp enable support for the Keystone Navigator Packet DMA on 40 on Keystone family of devices. It sets up the dma channels for the 41 Queue Manager Sub System. 42 43 If unsure, say N. 44 45config AMX3_PM 46 tristate "AMx3 Power Management" 47 depends on SOC_AM33XX || SOC_AM43XX 48 depends on WKUP_M3_IPC && TI_EMIF_SRAM && SRAM && RTC_DRV_OMAP 49 help 50 Enable power management on AM335x and AM437x. Required for suspend to mem 51 and standby states on both AM335x and AM437x platforms and for deeper cpuidle 52 c-states on AM335x. Also required for rtc and ddr in self-refresh low 53 power mode on AM437x platforms. 54 55config WKUP_M3_IPC 56 tristate "TI AMx3 Wkup-M3 IPC Driver" 57 depends on WKUP_M3_RPROC 58 depends on OMAP2PLUS_MBOX 59 help 60 TI AM33XX and AM43XX have a Cortex M3, the Wakeup M3, to handle 61 low power transitions. This IPC driver provides the necessary API 62 to communicate and use the Wakeup M3 for PM features like suspend 63 resume and boots it using wkup_m3_rproc driver. 64 65config TI_SCI_PM_DOMAINS 66 tristate "TI SCI PM Domains Driver" 67 depends on TI_SCI_PROTOCOL 68 depends on PM_GENERIC_DOMAINS 69 help 70 Generic power domain implementation for TI device implementing 71 the TI SCI protocol. 72 73 To compile this as a module, choose M here. The module will be 74 called ti_sci_pm_domains. Note this is needed early in boot before 75 rootfs may be available. 76 77config TI_SCI_INTA_MSI_DOMAIN 78 bool 79 select GENERIC_MSI_IRQ_DOMAIN 80 help 81 Driver to enable Interrupt Aggregator specific MSI Domain. 82 83endif # SOC_TI 84