1# SPDX-License-Identifier: GPL-2.0-only 2menu "Broadcom SoC drivers" 3 4config BCM2835_POWER 5 bool "BCM2835 power domain driver" 6 depends on ARCH_BCM2835 || (COMPILE_TEST && OF) 7 default y if ARCH_BCM2835 8 select PM_GENERIC_DOMAINS if PM 9 select RESET_CONTROLLER 10 help 11 This enables support for the BCM2835 power domains and reset 12 controller. Any usage of power domains by the Raspberry Pi 13 firmware means that Linux usage of the same power domain 14 must be accessed using the RASPBERRYPI_POWER driver 15 16config RASPBERRYPI_POWER 17 bool "Raspberry Pi power domain driver" 18 depends on ARCH_BCM2835 || (COMPILE_TEST && OF) 19 depends on RASPBERRYPI_FIRMWARE=y 20 select PM_GENERIC_DOMAINS if PM 21 help 22 This enables support for the RPi power domains which can be enabled 23 or disabled via the RPi firmware. 24 25config SOC_BCM63XX 26 bool "Broadcom 63xx SoC drivers" 27 depends on BMIPS_GENERIC || COMPILE_TEST 28 help 29 Enables drivers for the Broadcom 63xx series of chips. 30 Drivers can be enabled individually within this menu. 31 32 If unsure, say N. 33 34config SOC_BRCMSTB 35 bool "Broadcom STB SoC drivers" 36 depends on ARM || ARM64 || BMIPS_GENERIC || COMPILE_TEST 37 select SOC_BUS 38 help 39 Enables drivers for the Broadcom Set-Top Box (STB) series of chips. 40 This option alone enables only some support code, while the drivers 41 can be enabled individually within this menu. 42 43 If unsure, say N. 44 45source "drivers/soc/bcm/bcm63xx/Kconfig" 46source "drivers/soc/bcm/brcmstb/Kconfig" 47 48endmenu 49