1menu "Broadcom SoC drivers" 2 3config BCM2835_POWER 4 bool "BCM2835 power domain driver" 5 depends on ARCH_BCM2835 || (COMPILE_TEST && OF) 6 default y if ARCH_BCM2835 7 select PM_GENERIC_DOMAINS if PM 8 select RESET_CONTROLLER 9 help 10 This enables support for the BCM2835 power domains and reset 11 controller. Any usage of power domains by the Raspberry Pi 12 firmware means that Linux usage of the same power domain 13 must be accessed using the RASPBERRYPI_POWER driver 14 15config RASPBERRYPI_POWER 16 bool "Raspberry Pi power domain driver" 17 depends on ARCH_BCM2835 || (COMPILE_TEST && OF) 18 depends on RASPBERRYPI_FIRMWARE=y 19 select PM_GENERIC_DOMAINS if PM 20 help 21 This enables support for the RPi power domains which can be enabled 22 or disabled via the RPi firmware. 23 24config SOC_BRCMSTB 25 bool "Broadcom STB SoC drivers" 26 depends on ARM || ARM64 || BMIPS_GENERIC || COMPILE_TEST 27 select SOC_BUS 28 help 29 Enables drivers for the Broadcom Set-Top Box (STB) series of chips. 30 This option alone enables only some support code, while the drivers 31 can be enabled individually within this menu. 32 33 If unsure, say N. 34 35source "drivers/soc/bcm/brcmstb/Kconfig" 36 37endmenu 38