xref: /openbmc/linux/drivers/phy/st/Kconfig (revision ba61bb17)
1#
2# Phy drivers for STMicro platforms
3#
4config PHY_MIPHY28LP
5	tristate "STMicroelectronics MIPHY28LP PHY driver for STiH407"
6	depends on ARCH_STI
7	select GENERIC_PHY
8	help
9	  Enable this to support the miphy transceiver (for SATA/PCIE/USB3)
10	  that is part of STMicroelectronics STiH407 SoC.
11
12config PHY_ST_SPEAR1310_MIPHY
13	tristate "ST SPEAR1310-MIPHY driver"
14	select GENERIC_PHY
15	depends on MACH_SPEAR1310 || COMPILE_TEST
16	help
17	  Support for ST SPEAr1310 MIPHY which can be used for PCIe and SATA.
18
19config PHY_ST_SPEAR1340_MIPHY
20	tristate "ST SPEAR1340-MIPHY driver"
21	select GENERIC_PHY
22	depends on MACH_SPEAR1340 || COMPILE_TEST
23	help
24	  Support for ST SPEAr1340 MIPHY which can be used for PCIe and SATA.
25
26config PHY_STIH407_USB
27	tristate "STMicroelectronics USB2 picoPHY driver for STiH407 family"
28	depends on RESET_CONTROLLER
29	depends on ARCH_STI || COMPILE_TEST
30	select GENERIC_PHY
31	help
32	  Enable this support to enable the picoPHY device used by USB2
33	  and USB3 controllers on STMicroelectronics STiH407 SoC families.
34
35config PHY_STM32_USBPHYC
36	tristate "STMicroelectronics STM32 USB HS PHY Controller driver"
37	depends on ARCH_STM32 || COMPILE_TEST
38	select GENERIC_PHY
39	help
40	  Enable this to support the High-Speed USB transceivers that are part
41	  of some STMicroelectronics STM32 SoCs.
42
43	  This driver controls the entire USB PHY block: the USB PHY controller
44	  (USBPHYC) and the two 8-bit wide UTMI+ interfaces. First interface is
45	  used by an HS USB Host controller, and the second one is shared
46	  between an HS USB OTG controller and an HS USB Host controller,
47	  selected by a USB switch.
48