1 // SPDX-License-Identifier: GPL-2.0-or-later 2 /* 3 Copyright (C) 2004 - 2009 Ivo van Doorn <IvDoorn@gmail.com> 4 <http://rt2x00.serialmonkey.com> 5 6 */ 7 8 /* 9 Module: rt2x00lib 10 Abstract: rt2x00 generic configuration routines. 11 */ 12 13 #include <linux/kernel.h> 14 #include <linux/module.h> 15 16 #include "rt2x00.h" 17 #include "rt2x00lib.h" 18 19 void rt2x00lib_config_intf(struct rt2x00_dev *rt2x00dev, 20 struct rt2x00_intf *intf, 21 enum nl80211_iftype type, 22 const u8 *mac, const u8 *bssid) 23 { 24 struct rt2x00intf_conf conf; 25 unsigned int flags = 0; 26 27 conf.type = type; 28 29 switch (type) { 30 case NL80211_IFTYPE_ADHOC: 31 conf.sync = TSF_SYNC_ADHOC; 32 break; 33 case NL80211_IFTYPE_AP: 34 case NL80211_IFTYPE_MESH_POINT: 35 case NL80211_IFTYPE_WDS: 36 conf.sync = TSF_SYNC_AP_NONE; 37 break; 38 case NL80211_IFTYPE_STATION: 39 conf.sync = TSF_SYNC_INFRA; 40 break; 41 default: 42 conf.sync = TSF_SYNC_NONE; 43 break; 44 } 45 46 /* 47 * Note that when NULL is passed as address we will send 48 * 00:00:00:00:00 to the device to clear the address. 49 * This will prevent the device being confused when it wants 50 * to ACK frames or considers itself associated. 51 */ 52 memset(conf.mac, 0, sizeof(conf.mac)); 53 if (mac) 54 memcpy(conf.mac, mac, ETH_ALEN); 55 56 memset(conf.bssid, 0, sizeof(conf.bssid)); 57 if (bssid) 58 memcpy(conf.bssid, bssid, ETH_ALEN); 59 60 flags |= CONFIG_UPDATE_TYPE; 61 if (mac || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count)) 62 flags |= CONFIG_UPDATE_MAC; 63 if (bssid || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count)) 64 flags |= CONFIG_UPDATE_BSSID; 65 66 rt2x00dev->ops->lib->config_intf(rt2x00dev, intf, &conf, flags); 67 } 68 69 void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev, 70 struct rt2x00_intf *intf, 71 struct ieee80211_bss_conf *bss_conf, 72 u32 changed) 73 { 74 struct rt2x00lib_erp erp; 75 76 memset(&erp, 0, sizeof(erp)); 77 78 erp.short_preamble = bss_conf->use_short_preamble; 79 erp.cts_protection = bss_conf->use_cts_prot; 80 81 erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME; 82 erp.sifs = SIFS; 83 erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS; 84 erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS; 85 erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS; 86 87 erp.basic_rates = bss_conf->basic_rates; 88 erp.beacon_int = bss_conf->beacon_int; 89 90 /* Update the AID, this is needed for dynamic PS support */ 91 rt2x00dev->aid = bss_conf->assoc ? bss_conf->aid : 0; 92 rt2x00dev->last_beacon = bss_conf->sync_tsf; 93 94 /* Update global beacon interval time, this is needed for PS support */ 95 rt2x00dev->beacon_int = bss_conf->beacon_int; 96 97 if (changed & BSS_CHANGED_HT) 98 erp.ht_opmode = bss_conf->ht_operation_mode; 99 100 rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp, changed); 101 } 102 103 void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev, 104 struct antenna_setup config) 105 { 106 struct link_ant *ant = &rt2x00dev->link.ant; 107 struct antenna_setup *def = &rt2x00dev->default_ant; 108 struct antenna_setup *active = &rt2x00dev->link.ant.active; 109 110 /* 111 * When the caller tries to send the SW diversity, 112 * we must update the ANTENNA_RX_DIVERSITY flag to 113 * enable the antenna diversity in the link tuner. 114 * 115 * Secondly, we must guarentee we never send the 116 * software antenna diversity command to the driver. 117 */ 118 if (!(ant->flags & ANTENNA_RX_DIVERSITY)) { 119 if (config.rx == ANTENNA_SW_DIVERSITY) { 120 ant->flags |= ANTENNA_RX_DIVERSITY; 121 122 if (def->rx == ANTENNA_SW_DIVERSITY) 123 config.rx = ANTENNA_B; 124 else 125 config.rx = def->rx; 126 } 127 } else if (config.rx == ANTENNA_SW_DIVERSITY) 128 config.rx = active->rx; 129 130 if (!(ant->flags & ANTENNA_TX_DIVERSITY)) { 131 if (config.tx == ANTENNA_SW_DIVERSITY) { 132 ant->flags |= ANTENNA_TX_DIVERSITY; 133 134 if (def->tx == ANTENNA_SW_DIVERSITY) 135 config.tx = ANTENNA_B; 136 else 137 config.tx = def->tx; 138 } 139 } else if (config.tx == ANTENNA_SW_DIVERSITY) 140 config.tx = active->tx; 141 142 /* 143 * Antenna setup changes require the RX to be disabled, 144 * else the changes will be ignored by the device. 145 */ 146 if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags)) 147 rt2x00queue_stop_queue(rt2x00dev->rx); 148 149 /* 150 * Write new antenna setup to device and reset the link tuner. 151 * The latter is required since we need to recalibrate the 152 * noise-sensitivity ratio for the new setup. 153 */ 154 rt2x00dev->ops->lib->config_ant(rt2x00dev, &config); 155 156 rt2x00link_reset_tuner(rt2x00dev, true); 157 158 memcpy(active, &config, sizeof(config)); 159 160 if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags)) 161 rt2x00queue_start_queue(rt2x00dev->rx); 162 } 163 164 static u16 rt2x00ht_center_channel(struct rt2x00_dev *rt2x00dev, 165 struct ieee80211_conf *conf) 166 { 167 struct hw_mode_spec *spec = &rt2x00dev->spec; 168 int center_channel; 169 u16 i; 170 171 /* 172 * Initialize center channel to current channel. 173 */ 174 center_channel = spec->channels[conf->chandef.chan->hw_value].channel; 175 176 /* 177 * Adjust center channel to HT40+ and HT40- operation. 178 */ 179 if (conf_is_ht40_plus(conf)) 180 center_channel += 2; 181 else if (conf_is_ht40_minus(conf)) 182 center_channel -= (center_channel == 14) ? 1 : 2; 183 184 for (i = 0; i < spec->num_channels; i++) 185 if (spec->channels[i].channel == center_channel) 186 return i; 187 188 WARN_ON(1); 189 return conf->chandef.chan->hw_value; 190 } 191 192 void rt2x00lib_config(struct rt2x00_dev *rt2x00dev, 193 struct ieee80211_conf *conf, 194 unsigned int ieee80211_flags) 195 { 196 struct rt2x00lib_conf libconf; 197 u16 hw_value; 198 u16 autowake_timeout; 199 u16 beacon_int; 200 u16 beacon_diff; 201 202 memset(&libconf, 0, sizeof(libconf)); 203 204 libconf.conf = conf; 205 206 if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) { 207 if (!conf_is_ht(conf)) 208 set_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags); 209 else 210 clear_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags); 211 212 if (conf_is_ht40(conf)) { 213 set_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags); 214 hw_value = rt2x00ht_center_channel(rt2x00dev, conf); 215 } else { 216 clear_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags); 217 hw_value = conf->chandef.chan->hw_value; 218 } 219 220 memcpy(&libconf.rf, 221 &rt2x00dev->spec.channels[hw_value], 222 sizeof(libconf.rf)); 223 224 memcpy(&libconf.channel, 225 &rt2x00dev->spec.channels_info[hw_value], 226 sizeof(libconf.channel)); 227 228 /* Used for VCO periodic calibration */ 229 rt2x00dev->rf_channel = libconf.rf.channel; 230 } 231 232 if (rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) && 233 (ieee80211_flags & IEEE80211_CONF_CHANGE_PS)) 234 cancel_delayed_work_sync(&rt2x00dev->autowakeup_work); 235 236 /* 237 * Start configuration. 238 */ 239 rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags); 240 241 if (conf->flags & IEEE80211_CONF_PS) 242 set_bit(CONFIG_POWERSAVING, &rt2x00dev->flags); 243 else 244 clear_bit(CONFIG_POWERSAVING, &rt2x00dev->flags); 245 246 if (conf->flags & IEEE80211_CONF_MONITOR) 247 set_bit(CONFIG_MONITORING, &rt2x00dev->flags); 248 else 249 clear_bit(CONFIG_MONITORING, &rt2x00dev->flags); 250 251 rt2x00dev->curr_band = conf->chandef.chan->band; 252 rt2x00dev->curr_freq = conf->chandef.chan->center_freq; 253 rt2x00dev->tx_power = conf->power_level; 254 rt2x00dev->short_retry = conf->short_frame_max_tx_count; 255 rt2x00dev->long_retry = conf->long_frame_max_tx_count; 256 257 /* 258 * Some configuration changes affect the link quality 259 * which means we need to reset the link tuner. 260 */ 261 if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) 262 rt2x00link_reset_tuner(rt2x00dev, false); 263 264 if (test_bit(DEVICE_STATE_PRESENT, &rt2x00dev->flags) && 265 rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) && 266 (ieee80211_flags & IEEE80211_CONF_CHANGE_PS) && 267 (conf->flags & IEEE80211_CONF_PS)) { 268 beacon_diff = (long)jiffies - (long)rt2x00dev->last_beacon; 269 beacon_int = msecs_to_jiffies(rt2x00dev->beacon_int); 270 271 if (beacon_diff > beacon_int) 272 beacon_diff = 0; 273 274 autowake_timeout = (conf->ps_dtim_period * beacon_int) - beacon_diff; 275 queue_delayed_work(rt2x00dev->workqueue, 276 &rt2x00dev->autowakeup_work, 277 autowake_timeout - 15); 278 } 279 } 280