1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */ 2 /* 3 * Copyright (C) 2012-2014, 2018-2019, 2023 Intel Corporation 4 * Copyright (C) 2013-2015 Intel Mobile Communications GmbH 5 * Copyright (C) 2016-2017 Intel Deutschland GmbH 6 */ 7 #ifndef __iwl_fw_api_config_h__ 8 #define __iwl_fw_api_config_h__ 9 10 /* 11 * struct iwl_dqa_enable_cmd 12 * @cmd_queue: the TXQ number of the command queue 13 */ 14 struct iwl_dqa_enable_cmd { 15 __le32 cmd_queue; 16 } __packed; /* DQA_CONTROL_CMD_API_S_VER_1 */ 17 18 /* 19 * struct iwl_tx_ant_cfg_cmd 20 * @valid: valid antenna configuration 21 */ 22 struct iwl_tx_ant_cfg_cmd { 23 __le32 valid; 24 } __packed; 25 26 /** 27 * struct iwl_calib_ctrl - Calibration control struct. 28 * Sent as part of the phy configuration command. 29 * @flow_trigger: bitmap for which calibrations to perform according to 30 * flow triggers, using &enum iwl_calib_cfg 31 * @event_trigger: bitmap for which calibrations to perform according to 32 * event triggers, using &enum iwl_calib_cfg 33 */ 34 struct iwl_calib_ctrl { 35 __le32 flow_trigger; 36 __le32 event_trigger; 37 } __packed; 38 39 /* This enum defines the bitmap of various calibrations to enable in both 40 * init ucode and runtime ucode through CALIBRATION_CFG_CMD. 41 */ 42 enum iwl_calib_cfg { 43 IWL_CALIB_CFG_XTAL_IDX = BIT(0), 44 IWL_CALIB_CFG_TEMPERATURE_IDX = BIT(1), 45 IWL_CALIB_CFG_VOLTAGE_READ_IDX = BIT(2), 46 IWL_CALIB_CFG_PAPD_IDX = BIT(3), 47 IWL_CALIB_CFG_TX_PWR_IDX = BIT(4), 48 IWL_CALIB_CFG_DC_IDX = BIT(5), 49 IWL_CALIB_CFG_BB_FILTER_IDX = BIT(6), 50 IWL_CALIB_CFG_LO_LEAKAGE_IDX = BIT(7), 51 IWL_CALIB_CFG_TX_IQ_IDX = BIT(8), 52 IWL_CALIB_CFG_TX_IQ_SKEW_IDX = BIT(9), 53 IWL_CALIB_CFG_RX_IQ_IDX = BIT(10), 54 IWL_CALIB_CFG_RX_IQ_SKEW_IDX = BIT(11), 55 IWL_CALIB_CFG_SENSITIVITY_IDX = BIT(12), 56 IWL_CALIB_CFG_CHAIN_NOISE_IDX = BIT(13), 57 IWL_CALIB_CFG_DISCONNECTED_ANT_IDX = BIT(14), 58 IWL_CALIB_CFG_ANT_COUPLING_IDX = BIT(15), 59 IWL_CALIB_CFG_DAC_IDX = BIT(16), 60 IWL_CALIB_CFG_ABS_IDX = BIT(17), 61 IWL_CALIB_CFG_AGC_IDX = BIT(18), 62 }; 63 64 /** 65 * struct iwl_phy_specific_cfg - specific PHY filter configuration 66 * 67 * Sent as part of the phy configuration command (v3) to configure specific FW 68 * defined PHY filters that can be applied to each antenna. 69 * 70 * @filter_cfg_chains: filter config id for LMAC1 chain A, LMAC1 chain B, 71 * LMAC2 chain A, LMAC2 chain B (in that order) 72 * values: 0: no filter; 0xffffffff: reserved; otherwise: filter id 73 */ 74 struct iwl_phy_specific_cfg { 75 __le32 filter_cfg_chains[4]; 76 } __packed; /* PHY_SPECIFIC_CONFIGURATION_API_VER_1*/ 77 78 /** 79 * struct iwl_phy_cfg_cmd - Phy configuration command 80 * 81 * @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg 82 * @calib_control: calibration control data 83 */ 84 struct iwl_phy_cfg_cmd_v1 { 85 __le32 phy_cfg; 86 struct iwl_calib_ctrl calib_control; 87 } __packed; 88 89 /** 90 * struct iwl_phy_cfg_cmd_v3 - Phy configuration command (v3) 91 * 92 * @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg 93 * @calib_control: calibration control data 94 * @phy_specific_cfg: configure predefined PHY filters 95 */ 96 struct iwl_phy_cfg_cmd_v3 { 97 __le32 phy_cfg; 98 struct iwl_calib_ctrl calib_control; 99 struct iwl_phy_specific_cfg phy_specific_cfg; 100 } __packed; /* PHY_CONFIGURATION_CMD_API_S_VER_3 */ 101 102 /* 103 * enum iwl_dc2dc_config_id - flag ids 104 * 105 * Ids of dc2dc configuration flags 106 */ 107 enum iwl_dc2dc_config_id { 108 DCDC_LOW_POWER_MODE_MSK_SET = 0x1, /* not used */ 109 DCDC_FREQ_TUNE_SET = 0x2, 110 }; /* MARKER_ID_API_E_VER_1 */ 111 112 #endif /* __iwl_fw_api_config_h__ */ 113