xref: /openbmc/linux/drivers/net/wireless/ath/ath10k/pci.h (revision 9cfc5c90)
1 /*
2  * Copyright (c) 2005-2011 Atheros Communications Inc.
3  * Copyright (c) 2011-2013 Qualcomm Atheros, Inc.
4  *
5  * Permission to use, copy, modify, and/or distribute this software for any
6  * purpose with or without fee is hereby granted, provided that the above
7  * copyright notice and this permission notice appear in all copies.
8  *
9  * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
10  * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
11  * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
12  * ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
13  * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
14  * ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
15  * OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
16  */
17 
18 #ifndef _PCI_H_
19 #define _PCI_H_
20 
21 #include <linux/interrupt.h>
22 
23 #include "hw.h"
24 #include "ce.h"
25 
26 /*
27  * maximum number of bytes that can be handled atomically by DiagRead/DiagWrite
28  */
29 #define DIAG_TRANSFER_LIMIT 2048
30 
31 /*
32  * maximum number of bytes that can be
33  * handled atomically by DiagRead/DiagWrite
34  */
35 #define DIAG_TRANSFER_LIMIT 2048
36 
37 struct bmi_xfer {
38 	bool tx_done;
39 	bool rx_done;
40 	bool wait_for_resp;
41 	u32 resp_len;
42 };
43 
44 /*
45  * PCI-specific Target state
46  *
47  * NOTE: Structure is shared between Host software and Target firmware!
48  *
49  * Much of this may be of interest to the Host so
50  * HOST_INTEREST->hi_interconnect_state points here
51  * (and all members are 32-bit quantities in order to
52  * facilitate Host access). In particular, Host software is
53  * required to initialize pipe_cfg_addr and svc_to_pipe_map.
54  */
55 struct pcie_state {
56 	/* Pipe configuration Target address */
57 	/* NB: ce_pipe_config[CE_COUNT] */
58 	u32 pipe_cfg_addr;
59 
60 	/* Service to pipe map Target address */
61 	/* NB: service_to_pipe[PIPE_TO_CE_MAP_CN] */
62 	u32 svc_to_pipe_map;
63 
64 	/* number of MSI interrupts requested */
65 	u32 msi_requested;
66 
67 	/* number of MSI interrupts granted */
68 	u32 msi_granted;
69 
70 	/* Message Signalled Interrupt address */
71 	u32 msi_addr;
72 
73 	/* Base data */
74 	u32 msi_data;
75 
76 	/*
77 	 * Data for firmware interrupt;
78 	 * MSI data for other interrupts are
79 	 * in various SoC registers
80 	 */
81 	u32 msi_fw_intr_data;
82 
83 	/* PCIE_PWR_METHOD_* */
84 	u32 power_mgmt_method;
85 
86 	/* PCIE_CONFIG_FLAG_* */
87 	u32 config_flags;
88 };
89 
90 /* PCIE_CONFIG_FLAG definitions */
91 #define PCIE_CONFIG_FLAG_ENABLE_L1  0x0000001
92 
93 /* Host software's Copy Engine configuration. */
94 #define CE_ATTR_FLAGS 0
95 
96 /*
97  * Configuration information for a Copy Engine pipe.
98  * Passed from Host to Target during startup (one per CE).
99  *
100  * NOTE: Structure is shared between Host software and Target firmware!
101  */
102 struct ce_pipe_config {
103 	__le32 pipenum;
104 	__le32 pipedir;
105 	__le32 nentries;
106 	__le32 nbytes_max;
107 	__le32 flags;
108 	__le32 reserved;
109 };
110 
111 /*
112  * Directions for interconnect pipe configuration.
113  * These definitions may be used during configuration and are shared
114  * between Host and Target.
115  *
116  * Pipe Directions are relative to the Host, so PIPEDIR_IN means
117  * "coming IN over air through Target to Host" as with a WiFi Rx operation.
118  * Conversely, PIPEDIR_OUT means "going OUT from Host through Target over air"
119  * as with a WiFi Tx operation. This is somewhat awkward for the "middle-man"
120  * Target since things that are "PIPEDIR_OUT" are coming IN to the Target
121  * over the interconnect.
122  */
123 #define PIPEDIR_NONE    0
124 #define PIPEDIR_IN      1  /* Target-->Host, WiFi Rx direction */
125 #define PIPEDIR_OUT     2  /* Host->Target, WiFi Tx direction */
126 #define PIPEDIR_INOUT   3  /* bidirectional */
127 
128 /* Establish a mapping between a service/direction and a pipe. */
129 struct service_to_pipe {
130 	__le32 service_id;
131 	__le32 pipedir;
132 	__le32 pipenum;
133 };
134 
135 /* Per-pipe state. */
136 struct ath10k_pci_pipe {
137 	/* Handle of underlying Copy Engine */
138 	struct ath10k_ce_pipe *ce_hdl;
139 
140 	/* Our pipe number; facilitiates use of pipe_info ptrs. */
141 	u8 pipe_num;
142 
143 	/* Convenience back pointer to hif_ce_state. */
144 	struct ath10k *hif_ce_state;
145 
146 	size_t buf_sz;
147 
148 	/* protects compl_free and num_send_allowed */
149 	spinlock_t pipe_lock;
150 
151 	struct ath10k_pci *ar_pci;
152 	struct tasklet_struct intr;
153 };
154 
155 struct ath10k_pci_supp_chip {
156 	u32 dev_id;
157 	u32 rev_id;
158 };
159 
160 struct ath10k_pci {
161 	struct pci_dev *pdev;
162 	struct device *dev;
163 	struct ath10k *ar;
164 	void __iomem *mem;
165 	size_t mem_len;
166 
167 	/*
168 	 * Number of MSI interrupts granted, 0 --> using legacy PCI line
169 	 * interrupts.
170 	 */
171 	int num_msi_intrs;
172 
173 	struct tasklet_struct intr_tq;
174 	struct tasklet_struct msi_fw_err;
175 
176 	struct ath10k_pci_pipe pipe_info[CE_COUNT_MAX];
177 
178 	/* Copy Engine used for Diagnostic Accesses */
179 	struct ath10k_ce_pipe *ce_diag;
180 
181 	/* FIXME: document what this really protects */
182 	spinlock_t ce_lock;
183 
184 	/* Map CE id to ce_state */
185 	struct ath10k_ce_pipe ce_states[CE_COUNT_MAX];
186 	struct timer_list rx_post_retry;
187 
188 	/* Due to HW quirks it is recommended to disable ASPM during device
189 	 * bootup. To do that the original PCI-E Link Control is stored before
190 	 * device bootup is executed and re-programmed later.
191 	 */
192 	u16 link_ctl;
193 
194 	/* Protects ps_awake and ps_wake_refcount */
195 	spinlock_t ps_lock;
196 
197 	/* The device has a special powersave-oriented register. When device is
198 	 * considered asleep it drains less power and driver is forbidden from
199 	 * accessing most MMIO registers. If host were to access them without
200 	 * waking up the device might scribble over host memory or return
201 	 * 0xdeadbeef readouts.
202 	 */
203 	unsigned long ps_wake_refcount;
204 
205 	/* Waking up takes some time (up to 2ms in some cases) so it can be bad
206 	 * for latency. To mitigate this the device isn't immediately allowed
207 	 * to sleep after all references are undone - instead there's a grace
208 	 * period after which the powersave register is updated unless some
209 	 * activity to/from device happened in the meantime.
210 	 *
211 	 * Also see comments on ATH10K_PCI_SLEEP_GRACE_PERIOD_MSEC.
212 	 */
213 	struct timer_list ps_timer;
214 
215 	/* MMIO registers are used to communicate with the device. With
216 	 * intensive traffic accessing powersave register would be a bit
217 	 * wasteful overhead and would needlessly stall CPU. It is far more
218 	 * efficient to rely on a variable in RAM and update it only upon
219 	 * powersave register state changes.
220 	 */
221 	bool ps_awake;
222 
223 	/* pci power save, disable for QCA988X and QCA99X0.
224 	 * Writing 'false' to this variable avoids frequent locking
225 	 * on MMIO read/write.
226 	 */
227 	bool pci_ps;
228 };
229 
230 static inline struct ath10k_pci *ath10k_pci_priv(struct ath10k *ar)
231 {
232 	return (struct ath10k_pci *)ar->drv_priv;
233 }
234 
235 #define ATH10K_PCI_RX_POST_RETRY_MS 50
236 #define ATH_PCI_RESET_WAIT_MAX 10 /* ms */
237 #define PCIE_WAKE_TIMEOUT 30000	/* 30ms */
238 #define PCIE_WAKE_LATE_US 10000	/* 10ms */
239 
240 #define BAR_NUM 0
241 
242 #define CDC_WAR_MAGIC_STR   0xceef0000
243 #define CDC_WAR_DATA_CE     4
244 
245 /* Wait up to this many Ms for a Diagnostic Access CE operation to complete */
246 #define DIAG_ACCESS_CE_TIMEOUT_MS 10
247 
248 void ath10k_pci_write32(struct ath10k *ar, u32 offset, u32 value);
249 void ath10k_pci_soc_write32(struct ath10k *ar, u32 addr, u32 val);
250 void ath10k_pci_reg_write32(struct ath10k *ar, u32 addr, u32 val);
251 
252 u32 ath10k_pci_read32(struct ath10k *ar, u32 offset);
253 u32 ath10k_pci_soc_read32(struct ath10k *ar, u32 addr);
254 u32 ath10k_pci_reg_read32(struct ath10k *ar, u32 addr);
255 
256 /* QCA6174 is known to have Tx/Rx issues when SOC_WAKE register is poked too
257  * frequently. To avoid this put SoC to sleep after a very conservative grace
258  * period. Adjust with great care.
259  */
260 #define ATH10K_PCI_SLEEP_GRACE_PERIOD_MSEC 60
261 
262 #endif /* _PCI_H_ */
263