xref: /openbmc/linux/drivers/net/phy/bcm87xx.c (revision 32ced09d)
1 // SPDX-License-Identifier: GPL-2.0
2 /*
3  * Copyright (C) 2011 - 2012 Cavium, Inc.
4  */
5 
6 #include <linux/module.h>
7 #include <linux/phy.h>
8 #include <linux/of.h>
9 
10 #define PHY_ID_BCM8706	0x0143bdc1
11 #define PHY_ID_BCM8727	0x0143bff0
12 
13 #define BCM87XX_PMD_RX_SIGNAL_DETECT	(MII_ADDR_C45 | 0x1000a)
14 #define BCM87XX_10GBASER_PCS_STATUS	(MII_ADDR_C45 | 0x30020)
15 #define BCM87XX_XGXS_LANE_STATUS	(MII_ADDR_C45 | 0x40018)
16 
17 #define BCM87XX_LASI_CONTROL (MII_ADDR_C45 | 0x39002)
18 #define BCM87XX_LASI_STATUS (MII_ADDR_C45 | 0x39005)
19 
20 #if IS_ENABLED(CONFIG_OF_MDIO)
21 /* Set and/or override some configuration registers based on the
22  * broadcom,c45-reg-init property stored in the of_node for the phydev.
23  *
24  * broadcom,c45-reg-init = <devid reg mask value>,...;
25  *
26  * There may be one or more sets of <devid reg mask value>:
27  *
28  * devid: which sub-device to use.
29  * reg: the register.
30  * mask: if non-zero, ANDed with existing register value.
31  * value: ORed with the masked value and written to the regiser.
32  *
33  */
34 static int bcm87xx_of_reg_init(struct phy_device *phydev)
35 {
36 	const __be32 *paddr;
37 	const __be32 *paddr_end;
38 	int len, ret;
39 
40 	if (!phydev->mdio.dev.of_node)
41 		return 0;
42 
43 	paddr = of_get_property(phydev->mdio.dev.of_node,
44 				"broadcom,c45-reg-init", &len);
45 	if (!paddr)
46 		return 0;
47 
48 	paddr_end = paddr + (len /= sizeof(*paddr));
49 
50 	ret = 0;
51 
52 	while (paddr + 3 < paddr_end) {
53 		u16 devid	= be32_to_cpup(paddr++);
54 		u16 reg		= be32_to_cpup(paddr++);
55 		u16 mask	= be32_to_cpup(paddr++);
56 		u16 val_bits	= be32_to_cpup(paddr++);
57 		int val;
58 		u32 regnum = MII_ADDR_C45 | (devid << 16) | reg;
59 		val = 0;
60 		if (mask) {
61 			val = phy_read(phydev, regnum);
62 			if (val < 0) {
63 				ret = val;
64 				goto err;
65 			}
66 			val &= mask;
67 		}
68 		val |= val_bits;
69 
70 		ret = phy_write(phydev, regnum, val);
71 		if (ret < 0)
72 			goto err;
73 	}
74 err:
75 	return ret;
76 }
77 #else
78 static int bcm87xx_of_reg_init(struct phy_device *phydev)
79 {
80 	return 0;
81 }
82 #endif /* CONFIG_OF_MDIO */
83 
84 static int bcm87xx_get_features(struct phy_device *phydev)
85 {
86 	linkmode_set_bit(ETHTOOL_LINK_MODE_10000baseR_FEC_BIT,
87 			 phydev->supported);
88 	return 0;
89 }
90 
91 static int bcm87xx_config_init(struct phy_device *phydev)
92 {
93 	return bcm87xx_of_reg_init(phydev);
94 }
95 
96 static int bcm87xx_config_aneg(struct phy_device *phydev)
97 {
98 	return -EINVAL;
99 }
100 
101 static int bcm87xx_read_status(struct phy_device *phydev)
102 {
103 	int rx_signal_detect;
104 	int pcs_status;
105 	int xgxs_lane_status;
106 
107 	rx_signal_detect = phy_read(phydev, BCM87XX_PMD_RX_SIGNAL_DETECT);
108 	if (rx_signal_detect < 0)
109 		return rx_signal_detect;
110 
111 	if ((rx_signal_detect & 1) == 0)
112 		goto no_link;
113 
114 	pcs_status = phy_read(phydev, BCM87XX_10GBASER_PCS_STATUS);
115 	if (pcs_status < 0)
116 		return pcs_status;
117 
118 	if ((pcs_status & 1) == 0)
119 		goto no_link;
120 
121 	xgxs_lane_status = phy_read(phydev, BCM87XX_XGXS_LANE_STATUS);
122 	if (xgxs_lane_status < 0)
123 		return xgxs_lane_status;
124 
125 	if ((xgxs_lane_status & 0x1000) == 0)
126 		goto no_link;
127 
128 	phydev->speed = 10000;
129 	phydev->link = 1;
130 	phydev->duplex = 1;
131 	return 0;
132 
133 no_link:
134 	phydev->link = 0;
135 	return 0;
136 }
137 
138 static int bcm87xx_config_intr(struct phy_device *phydev)
139 {
140 	int reg, err;
141 
142 	reg = phy_read(phydev, BCM87XX_LASI_CONTROL);
143 
144 	if (reg < 0)
145 		return reg;
146 
147 	if (phydev->interrupts == PHY_INTERRUPT_ENABLED)
148 		reg |= 1;
149 	else
150 		reg &= ~1;
151 
152 	err = phy_write(phydev, BCM87XX_LASI_CONTROL, reg);
153 	return err;
154 }
155 
156 static int bcm87xx_did_interrupt(struct phy_device *phydev)
157 {
158 	int reg;
159 
160 	reg = phy_read(phydev, BCM87XX_LASI_STATUS);
161 
162 	if (reg < 0) {
163 		phydev_err(phydev,
164 			   "Error: Read of BCM87XX_LASI_STATUS failed: %d\n",
165 			   reg);
166 		return 0;
167 	}
168 	return (reg & 1) != 0;
169 }
170 
171 static int bcm87xx_ack_interrupt(struct phy_device *phydev)
172 {
173 	/* Reading the LASI status clears it. */
174 	bcm87xx_did_interrupt(phydev);
175 	return 0;
176 }
177 
178 static int bcm8706_match_phy_device(struct phy_device *phydev)
179 {
180 	return phydev->c45_ids.device_ids[4] == PHY_ID_BCM8706;
181 }
182 
183 static int bcm8727_match_phy_device(struct phy_device *phydev)
184 {
185 	return phydev->c45_ids.device_ids[4] == PHY_ID_BCM8727;
186 }
187 
188 static struct phy_driver bcm87xx_driver[] = {
189 {
190 	.phy_id		= PHY_ID_BCM8706,
191 	.phy_id_mask	= 0xffffffff,
192 	.name		= "Broadcom BCM8706",
193 	.get_features	= bcm87xx_get_features,
194 	.config_init	= bcm87xx_config_init,
195 	.config_aneg	= bcm87xx_config_aneg,
196 	.read_status	= bcm87xx_read_status,
197 	.ack_interrupt	= bcm87xx_ack_interrupt,
198 	.config_intr	= bcm87xx_config_intr,
199 	.did_interrupt	= bcm87xx_did_interrupt,
200 	.match_phy_device = bcm8706_match_phy_device,
201 }, {
202 	.phy_id		= PHY_ID_BCM8727,
203 	.phy_id_mask	= 0xffffffff,
204 	.name		= "Broadcom BCM8727",
205 	.get_features	= bcm87xx_get_features,
206 	.config_init	= bcm87xx_config_init,
207 	.config_aneg	= bcm87xx_config_aneg,
208 	.read_status	= bcm87xx_read_status,
209 	.ack_interrupt	= bcm87xx_ack_interrupt,
210 	.config_intr	= bcm87xx_config_intr,
211 	.did_interrupt	= bcm87xx_did_interrupt,
212 	.match_phy_device = bcm8727_match_phy_device,
213 } };
214 
215 module_phy_driver(bcm87xx_driver);
216 
217 MODULE_LICENSE("GPL v2");
218