1# 2# PHY Layer Configuration 3# 4 5menuconfig MDIO_DEVICE 6 tristate "MDIO bus device drivers" 7 help 8 MDIO devices and driver infrastructure code. 9 10if MDIO_DEVICE 11 12config MDIO_BCM_IPROC 13 tristate "Broadcom iProc MDIO bus controller" 14 depends on ARCH_BCM_IPROC || COMPILE_TEST 15 depends on HAS_IOMEM && OF_MDIO 16 help 17 This module provides a driver for the MDIO busses found in the 18 Broadcom iProc SoC's. 19 20config MDIO_BCM_UNIMAC 21 tristate "Broadcom UniMAC MDIO bus controller" 22 depends on HAS_IOMEM && OF_MDIO 23 help 24 This module provides a driver for the Broadcom UniMAC MDIO busses. 25 This hardware can be found in the Broadcom GENET Ethernet MAC 26 controllers as well as some Broadcom Ethernet switches such as the 27 Starfighter 2 switches. 28 29config MDIO_BITBANG 30 tristate "Bitbanged MDIO buses" 31 depends on !(MDIO_DEVICE=y && PHYLIB=m) 32 help 33 This module implements the MDIO bus protocol in software, 34 for use by low level drivers that export the ability to 35 drive the relevant pins. 36 37 If in doubt, say N. 38 39config MDIO_BUS_MUX 40 tristate 41 depends on OF_MDIO 42 help 43 This module provides a driver framework for MDIO bus 44 multiplexers which connect one of several child MDIO busses 45 to a parent bus. Switching between child busses is done by 46 device specific drivers. 47 48config MDIO_BUS_MUX_BCM_IPROC 49 tristate "Broadcom iProc based MDIO bus multiplexers" 50 depends on OF && OF_MDIO && (ARCH_BCM_IPROC || COMPILE_TEST) 51 select MDIO_BUS_MUX 52 default ARCH_BCM_IPROC 53 help 54 This module provides a driver for MDIO bus multiplexers found in 55 iProc based Broadcom SoCs. This multiplexer connects one of several 56 child MDIO bus to a parent bus. Buses could be internal as well as 57 external and selection logic lies inside the same multiplexer. 58 59config MDIO_BUS_MUX_GPIO 60 tristate "GPIO controlled MDIO bus multiplexers" 61 depends on OF_GPIO && OF_MDIO 62 select MDIO_BUS_MUX 63 help 64 This module provides a driver for MDIO bus multiplexers that 65 are controlled via GPIO lines. The multiplexer connects one of 66 several child MDIO busses to a parent bus. Child bus 67 selection is under the control of GPIO lines. 68 69config MDIO_BUS_MUX_MMIOREG 70 tristate "MMIO device-controlled MDIO bus multiplexers" 71 depends on OF_MDIO && HAS_IOMEM 72 select MDIO_BUS_MUX 73 help 74 This module provides a driver for MDIO bus multiplexers that 75 are controlled via a simple memory-mapped device, like an FPGA. 76 The multiplexer connects one of several child MDIO busses to a 77 parent bus. Child bus selection is under the control of one of 78 the FPGA's registers. 79 80 Currently, only 8-bit registers are supported. 81 82config MDIO_CAVIUM 83 tristate 84 85config MDIO_GPIO 86 tristate "GPIO lib-based bitbanged MDIO buses" 87 depends on MDIO_BITBANG && GPIOLIB 88 ---help--- 89 Supports GPIO lib-based MDIO busses. 90 91 To compile this driver as a module, choose M here: the module 92 will be called mdio-gpio. 93 94config MDIO_HISI_FEMAC 95 tristate "Hisilicon FEMAC MDIO bus controller" 96 depends on HAS_IOMEM && OF_MDIO 97 help 98 This module provides a driver for the MDIO busses found in the 99 Hisilicon SoC that have an Fast Ethernet MAC. 100 101config MDIO_MOXART 102 tristate "MOXA ART MDIO interface support" 103 depends on ARCH_MOXART 104 help 105 This driver supports the MDIO interface found in the network 106 interface units of the MOXA ART SoC 107 108config MDIO_OCTEON 109 tristate "Octeon and some ThunderX SOCs MDIO buses" 110 depends on 64BIT 111 depends on HAS_IOMEM 112 select MDIO_CAVIUM 113 help 114 This module provides a driver for the Octeon and ThunderX MDIO 115 buses. It is required by the Octeon and ThunderX ethernet device 116 drivers on some systems. 117 118config MDIO_SUN4I 119 tristate "Allwinner sun4i MDIO interface support" 120 depends on ARCH_SUNXI 121 help 122 This driver supports the MDIO interface found in the network 123 interface units of the Allwinner SoC that have an EMAC (A10, 124 A12, A10s, etc.) 125 126config MDIO_THUNDER 127 tristate "ThunderX SOCs MDIO buses" 128 depends on 64BIT 129 depends on PCI 130 select MDIO_CAVIUM 131 help 132 This driver supports the MDIO interfaces found on Cavium 133 ThunderX SoCs when the MDIO bus device appears as a PCI 134 device. 135 136config MDIO_XGENE 137 tristate "APM X-Gene SoC MDIO bus controller" 138 depends on ARCH_XGENE || COMPILE_TEST 139 help 140 This module provides a driver for the MDIO busses found in the 141 APM X-Gene SoC's. 142 143endif 144 145menuconfig PHYLIB 146 tristate "PHY Device support and infrastructure" 147 depends on NETDEVICES 148 select MDIO_DEVICE 149 help 150 Ethernet controllers are usually attached to PHY 151 devices. This option provides infrastructure for 152 managing PHY devices. 153 154if PHYLIB 155 156config SWPHY 157 bool 158 159config LED_TRIGGER_PHY 160 bool "Support LED triggers for tracking link state" 161 depends on LEDS_TRIGGERS 162 ---help--- 163 Adds support for a set of LED trigger events per-PHY. Link 164 state change will trigger the events, for consumption by an 165 LED class driver. There are triggers for each link speed currently 166 supported by the phy, and are of the form: 167 <mii bus id>:<phy>:<speed> 168 169 Where speed is in the form: 170 <Speed in megabits>Mbps or <Speed in gigabits>Gbps 171 172 173comment "MII PHY device drivers" 174 175config AMD_PHY 176 tristate "AMD PHYs" 177 ---help--- 178 Currently supports the am79c874 179 180config AQUANTIA_PHY 181 tristate "Aquantia PHYs" 182 ---help--- 183 Currently supports the Aquantia AQ1202, AQ2104, AQR105, AQR405 184 185config AT803X_PHY 186 tristate "AT803X PHYs" 187 ---help--- 188 Currently supports the AT8030 and AT8035 model 189 190config BCM63XX_PHY 191 tristate "Broadcom 63xx SOCs internal PHY" 192 depends on BCM63XX 193 select BCM_NET_PHYLIB 194 ---help--- 195 Currently supports the 6348 and 6358 PHYs. 196 197config BCM7XXX_PHY 198 tristate "Broadcom 7xxx SOCs internal PHYs" 199 select BCM_NET_PHYLIB 200 ---help--- 201 Currently supports the BCM7366, BCM7439, BCM7445, and 202 40nm and 65nm generation of BCM7xxx Set Top Box SoCs. 203 204config BCM87XX_PHY 205 tristate "Broadcom BCM8706 and BCM8727 PHYs" 206 help 207 Currently supports the BCM8706 and BCM8727 10G Ethernet PHYs. 208 209config BCM_CYGNUS_PHY 210 tristate "Broadcom Cygnus SoC internal PHY" 211 depends on ARCH_BCM_CYGNUS || COMPILE_TEST 212 depends on MDIO_BCM_IPROC 213 select BCM_NET_PHYLIB 214 ---help--- 215 This PHY driver is for the 1G internal PHYs of the Broadcom 216 Cygnus Family SoC. 217 218 Currently supports internal PHY's used in the BCM11300, 219 BCM11320, BCM11350, BCM11360, BCM58300, BCM58302, 220 BCM58303 & BCM58305 Broadcom Cygnus SoCs. 221 222config BCM_NET_PHYLIB 223 tristate 224 225config BROADCOM_PHY 226 tristate "Broadcom PHYs" 227 select BCM_NET_PHYLIB 228 ---help--- 229 Currently supports the BCM5411, BCM5421, BCM5461, BCM54616S, BCM5464, 230 BCM5481, BCM54810 and BCM5482 PHYs. 231 232config CICADA_PHY 233 tristate "Cicada PHYs" 234 ---help--- 235 Currently supports the cis8204 236 237config DAVICOM_PHY 238 tristate "Davicom PHYs" 239 ---help--- 240 Currently supports dm9161e and dm9131 241 242config DP83848_PHY 243 tristate "Texas Instruments DP83848 PHY" 244 ---help--- 245 Supports the DP83848 PHY. 246 247config DP83867_PHY 248 tristate "Texas Instruments DP83867 Gigabit PHY" 249 ---help--- 250 Currently supports the DP83867 PHY. 251 252config FIXED_PHY 253 tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs" 254 depends on PHYLIB 255 select SWPHY 256 ---help--- 257 Adds the platform "fixed" MDIO Bus to cover the boards that use 258 PHYs that are not connected to the real MDIO bus. 259 260 Currently tested with mpc866ads and mpc8349e-mitx. 261 262config ICPLUS_PHY 263 tristate "ICPlus PHYs" 264 ---help--- 265 Currently supports the IP175C and IP1001 PHYs. 266 267config INTEL_XWAY_PHY 268 tristate "Intel XWAY PHYs" 269 ---help--- 270 Supports the Intel XWAY (former Lantiq) 11G and 22E PHYs. 271 These PHYs are marked as standalone chips under the names 272 PEF 7061, PEF 7071 and PEF 7072 or integrated into the Intel 273 SoCs xRX200, xRX300, xRX330, xRX350 and xRX550. 274 275config LSI_ET1011C_PHY 276 tristate "LSI ET1011C PHY" 277 ---help--- 278 Supports the LSI ET1011C PHY. 279 280config LXT_PHY 281 tristate "Intel LXT PHYs" 282 ---help--- 283 Currently supports the lxt970, lxt971 284 285config MARVELL_PHY 286 tristate "Marvell PHYs" 287 ---help--- 288 Currently has a driver for the 88E1011S 289 290config MESON_GXL_PHY 291 tristate "Amlogic Meson GXL Internal PHY" 292 depends on ARCH_MESON || COMPILE_TEST 293 ---help--- 294 Currently has a driver for the Amlogic Meson GXL Internal PHY 295 296config MICREL_PHY 297 tristate "Micrel PHYs" 298 ---help--- 299 Supports the KSZ9021, VSC8201, KS8001 PHYs. 300 301config MICROCHIP_PHY 302 tristate "Microchip PHYs" 303 help 304 Supports the LAN88XX PHYs. 305 306config MICROSEMI_PHY 307 tristate "Microsemi PHYs" 308 ---help--- 309 Currently supports VSC8530, VSC8531, VSC8540 and VSC8541 PHYs 310 311config NATIONAL_PHY 312 tristate "National Semiconductor PHYs" 313 ---help--- 314 Currently supports the DP83865 PHY. 315 316config QSEMI_PHY 317 tristate "Quality Semiconductor PHYs" 318 ---help--- 319 Currently supports the qs6612 320 321config REALTEK_PHY 322 tristate "Realtek PHYs" 323 ---help--- 324 Supports the Realtek 821x PHY. 325 326config SMSC_PHY 327 tristate "SMSC PHYs" 328 ---help--- 329 Currently supports the LAN83C185, LAN8187 and LAN8700 PHYs 330 331config STE10XP 332 tristate "STMicroelectronics STe10Xp PHYs" 333 ---help--- 334 This is the driver for the STe100p and STe101p PHYs. 335 336config TERANETICS_PHY 337 tristate "Teranetics PHYs" 338 ---help--- 339 Currently supports the Teranetics TN2020 340 341config VITESSE_PHY 342 tristate "Vitesse PHYs" 343 ---help--- 344 Currently supports the vsc8244 345 346config XILINX_GMII2RGMII 347 tristate "Xilinx GMII2RGMII converter driver" 348 ---help--- 349 This driver support xilinx GMII to RGMII IP core it provides 350 the Reduced Gigabit Media Independent Interface(RGMII) between 351 Ethernet physical media devices and the Gigabit Ethernet controller. 352 353endif # PHYLIB 354 355config MICREL_KS8995MA 356 tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch" 357 depends on SPI 358