1# 2# HIPPI network device configuration 3# 4 5config HIPPI 6 bool "HIPPI driver support (EXPERIMENTAL)" 7 depends on EXPERIMENTAL && INET && PCI 8 ---help--- 9 HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and 10 1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI 11 can run over copper (25m) or fiber (300m on multi-mode or 10km on 12 single-mode). HIPPI networks are commonly used for clusters and to 13 connect to super computers. If you are connected to a HIPPI network 14 and have a HIPPI network card in your computer that you want to use 15 under Linux, say Y here (you must also remember to enable the driver 16 for your HIPPI card below). Most people will say N here. 17 18if HIPPI 19 20config ROADRUNNER 21 tristate "Essential RoadRunner HIPPI PCI adapter support (EXPERIMENTAL)" 22 depends on PCI 23 ---help--- 24 Say Y here if this is your PCI HIPPI network card. 25 26 To compile this driver as a module, choose M here: the module 27 will be called rrunner. If unsure, say N. 28 29config ROADRUNNER_LARGE_RINGS 30 bool "Use large TX/RX rings (EXPERIMENTAL)" 31 depends on ROADRUNNER 32 ---help--- 33 If you say Y here, the RoadRunner driver will preallocate up to 2 MB 34 of additional memory to allow for fastest operation, both for 35 transmitting and receiving. This memory cannot be used by any other 36 kernel code or by user space programs. Say Y here only if you have 37 the memory. 38 39endif /* HIPPI */ 40