1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Solarflare device configuration 4# 5 6config NET_VENDOR_SOLARFLARE 7 bool "Solarflare devices" 8 default y 9 help 10 If you have a network (Ethernet) card belonging to this class, say Y. 11 12 Note that the answer to this question doesn't directly affect the 13 kernel: saying N will just cause the configurator to skip all 14 the questions about Solarflare devices. If you say Y, you will be asked 15 for your specific card in the following questions. 16 17if NET_VENDOR_SOLARFLARE 18 19config SFC 20 tristate "Solarflare SFC9100/EF100-family support" 21 depends on PCI 22 depends on PTP_1588_CLOCK_OPTIONAL 23 select MDIO 24 select CRC32 25 select NET_DEVLINK 26 help 27 This driver supports 10/40-gigabit Ethernet cards based on 28 the Solarflare SFC9100-family controllers. 29 30 It also supports 10/25/40/100-gigabit Ethernet cards based 31 on the Solarflare EF100 networking IP in Xilinx FPGAs. 32 33 To compile this driver as a module, choose M here. The module 34 will be called sfc. 35config SFC_MTD 36 bool "Solarflare SFC9100-family MTD support" 37 depends on SFC && MTD && !(SFC=y && MTD=m) 38 default y 39 help 40 This exposes the on-board flash and/or EEPROM as MTD devices 41 (e.g. /dev/mtd1). This is required to update the firmware or 42 the boot configuration under Linux. 43config SFC_MCDI_MON 44 bool "Solarflare SFC9100-family hwmon support" 45 depends on SFC && HWMON && !(SFC=y && HWMON=m) 46 default y 47 help 48 This exposes the on-board firmware-managed sensors as a 49 hardware monitor device. 50config SFC_SRIOV 51 bool "Solarflare SFC9100-family SR-IOV support" 52 depends on SFC && PCI_IOV 53 default y 54 help 55 This enables support for the Single Root I/O Virtualization 56 features, allowing accelerated network performance in 57 virtualized environments. 58config SFC_MCDI_LOGGING 59 bool "Solarflare SFC9100-family MCDI logging support" 60 depends on SFC 61 default y 62 help 63 This enables support for tracing of MCDI (Management-Controller-to- 64 Driver-Interface) commands and responses, allowing debugging of 65 driver/firmware interaction. The tracing is actually enabled by 66 a sysfs file 'mcdi_logging' under the PCI device. 67 68source "drivers/net/ethernet/sfc/falcon/Kconfig" 69source "drivers/net/ethernet/sfc/siena/Kconfig" 70 71endif # NET_VENDOR_SOLARFLARE 72