1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Solarflare device configuration 4# 5 6config NET_VENDOR_SOLARFLARE 7 bool "Solarflare devices" 8 default y 9 ---help--- 10 If you have a network (Ethernet) card belonging to this class, say Y. 11 12 Note that the answer to this question doesn't directly affect the 13 kernel: saying N will just cause the configurator to skip all 14 the questions about Solarflare devices. If you say Y, you will be asked 15 for your specific card in the following questions. 16 17if NET_VENDOR_SOLARFLARE 18 19config SFC 20 tristate "Solarflare SFC9000/SFC9100-family support" 21 depends on PCI 22 select MDIO 23 select CRC32 24 select I2C 25 select I2C_ALGOBIT 26 imply PTP_1588_CLOCK 27 ---help--- 28 This driver supports 10/40-gigabit Ethernet cards based on 29 the Solarflare SFC9000-family and SFC9100-family controllers. 30 31 To compile this driver as a module, choose M here. The module 32 will be called sfc. 33config SFC_MTD 34 bool "Solarflare SFC9000/SFC9100-family MTD support" 35 depends on SFC && MTD && !(SFC=y && MTD=m) 36 default y 37 ---help--- 38 This exposes the on-board flash and/or EEPROM as MTD devices 39 (e.g. /dev/mtd1). This is required to update the firmware or 40 the boot configuration under Linux. 41config SFC_MCDI_MON 42 bool "Solarflare SFC9000/SFC9100-family hwmon support" 43 depends on SFC && HWMON && !(SFC=y && HWMON=m) 44 default y 45 ---help--- 46 This exposes the on-board firmware-managed sensors as a 47 hardware monitor device. 48config SFC_SRIOV 49 bool "Solarflare SFC9000-family SR-IOV support" 50 depends on SFC && PCI_IOV 51 default y 52 ---help--- 53 This enables support for the SFC9000 I/O Virtualization 54 features, allowing accelerated network performance in 55 virtualized environments. 56config SFC_MCDI_LOGGING 57 bool "Solarflare SFC9000/SFC9100-family MCDI logging support" 58 depends on SFC 59 default y 60 ---help--- 61 This enables support for tracing of MCDI (Management-Controller-to- 62 Driver-Interface) commands and responses, allowing debugging of 63 driver/firmware interaction. The tracing is actually enabled by 64 a sysfs file 'mcdi_logging' under the PCI device. 65 66source "drivers/net/ethernet/sfc/falcon/Kconfig" 67 68endif # NET_VENDOR_SOLARFLARE 69