1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Solarflare device configuration 4# 5 6config NET_VENDOR_SOLARFLARE 7 bool "Solarflare devices" 8 default y 9 ---help--- 10 If you have a network (Ethernet) card belonging to this class, say Y. 11 12 Note that the answer to this question doesn't directly affect the 13 kernel: saying N will just cause the configurator to skip all 14 the questions about Solarflare devices. If you say Y, you will be asked 15 for your specific card in the following questions. 16 17if NET_VENDOR_SOLARFLARE 18 19config SFC 20 tristate "Solarflare SFC9000/SFC9100-family support" 21 depends on PCI 22 select MDIO 23 select CRC32 24 imply PTP_1588_CLOCK 25 ---help--- 26 This driver supports 10/40-gigabit Ethernet cards based on 27 the Solarflare SFC9000-family and SFC9100-family controllers. 28 29 To compile this driver as a module, choose M here. The module 30 will be called sfc. 31config SFC_MTD 32 bool "Solarflare SFC9000/SFC9100-family MTD support" 33 depends on SFC && MTD && !(SFC=y && MTD=m) 34 default y 35 ---help--- 36 This exposes the on-board flash and/or EEPROM as MTD devices 37 (e.g. /dev/mtd1). This is required to update the firmware or 38 the boot configuration under Linux. 39config SFC_MCDI_MON 40 bool "Solarflare SFC9000/SFC9100-family hwmon support" 41 depends on SFC && HWMON && !(SFC=y && HWMON=m) 42 default y 43 ---help--- 44 This exposes the on-board firmware-managed sensors as a 45 hardware monitor device. 46config SFC_SRIOV 47 bool "Solarflare SFC9000-family SR-IOV support" 48 depends on SFC && PCI_IOV 49 default y 50 ---help--- 51 This enables support for the SFC9000 I/O Virtualization 52 features, allowing accelerated network performance in 53 virtualized environments. 54config SFC_MCDI_LOGGING 55 bool "Solarflare SFC9000/SFC9100-family MCDI logging support" 56 depends on SFC 57 default y 58 ---help--- 59 This enables support for tracing of MCDI (Management-Controller-to- 60 Driver-Interface) commands and responses, allowing debugging of 61 driver/firmware interaction. The tracing is actually enabled by 62 a sysfs file 'mcdi_logging' under the PCI device. 63 64source "drivers/net/ethernet/sfc/falcon/Kconfig" 65 66endif # NET_VENDOR_SOLARFLARE 67