1#
2# Micrel device configuration
3#
4
5config NET_VENDOR_MICREL
6	bool "Micrel devices"
7	default y
8	depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \
9		   (ARM && ARCH_KS8695)
10	---help---
11	  If you have a network (Ethernet) card belonging to this class, say Y.
12
13	  Note that the answer to this question doesn't directly affect the
14	  kernel: saying N will just cause the configurator to skip all
15	  the questions about Micrel devices. If you say Y, you will be asked
16	  for your specific card in the following questions.
17
18if NET_VENDOR_MICREL
19
20config ARM_KS8695_ETHER
21	tristate "KS8695 Ethernet support"
22	depends on ARM && ARCH_KS8695
23	select MII
24	---help---
25	  If you wish to compile a kernel for the KS8695 and want to
26	  use the internal ethernet then you should answer Y to this.
27
28config KS8842
29	tristate "Micrel KSZ8841/42 with generic bus interface"
30	depends on HAS_IOMEM && DMA_ENGINE
31	---help---
32	  This platform driver is for KSZ8841(1-port) / KS8842(2-port)
33	  ethernet switch chip (managed, VLAN, QoS) from Micrel or
34	  Timberdale(FPGA).
35
36config KS8851
37	tristate "Micrel KS8851 SPI"
38	depends on SPI
39	select MII
40	select CRC32
41	select EEPROM_93CX6
42	---help---
43	  SPI driver for Micrel KS8851 SPI attached network chip.
44
45config KS8851_MLL
46	tristate "Micrel KS8851 MLL"
47	depends on HAS_IOMEM
48	select MII
49	---help---
50	  This platform driver is for Micrel KS8851 Address/data bus
51	  multiplexed network chip.
52
53config KSZ884X_PCI
54	tristate "Micrel KSZ8841/2 PCI"
55	depends on PCI
56	select MII
57	select CRC32
58	---help---
59	  This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip.
60
61	  To compile this driver as a module, choose M here. The module
62	  will be called ksz884x.
63
64endif # NET_VENDOR_MICREL
65