1 /* lasi_82596.c -- driver for the intel 82596 ethernet controller, as
2    munged into HPPA boxen .
3 
4    This driver is based upon 82596.c, original credits are below...
5    but there were too many hoops which HP wants jumped through to
6    keep this code in there in a sane manner.
7 
8    3 primary sources of the mess --
9    1) hppa needs *lots* of cacheline flushing to keep this kind of
10    MMIO running.
11 
12    2) The 82596 needs to see all of its pointers as their physical
13    address.  Thus virt_to_bus/bus_to_virt are *everywhere*.
14 
15    3) The implementation HP is using seems to be significantly pickier
16    about when and how the command and RX units are started.  some
17    command ordering was changed.
18 
19    Examination of the mach driver leads one to believe that there
20    might be a saner way to pull this off...  anyone who feels like a
21    full rewrite can be my guest.
22 
23    Split 02/13/2000 Sam Creasey (sammy@oh.verio.com)
24 
25    02/01/2000  Initial modifications for parisc by Helge Deller (deller@gmx.de)
26    03/02/2000  changes for better/correct(?) cache-flushing (deller)
27 */
28 
29 /* 82596.c: A generic 82596 ethernet driver for linux. */
30 /*
31    Based on Apricot.c
32    Written 1994 by Mark Evans.
33    This driver is for the Apricot 82596 bus-master interface
34 
35    Modularised 12/94 Mark Evans
36 
37 
38    Modified to support the 82596 ethernet chips on 680x0 VME boards.
39    by Richard Hirst <richard@sleepie.demon.co.uk>
40    Renamed to be 82596.c
41 
42    980825:  Changed to receive directly in to sk_buffs which are
43    allocated at open() time.  Eliminates copy on incoming frames
44    (small ones are still copied).  Shared data now held in a
45    non-cached page, so we can run on 68060 in copyback mode.
46 
47    TBD:
48    * look at deferring rx frames rather than discarding (as per tulip)
49    * handle tx ring full as per tulip
50    * performance test to tune rx_copybreak
51 
52    Most of my modifications relate to the braindead big-endian
53    implementation by Intel.  When the i596 is operating in
54    'big-endian' mode, it thinks a 32 bit value of 0x12345678
55    should be stored as 0x56781234.  This is a real pain, when
56    you have linked lists which are shared by the 680x0 and the
57    i596.
58 
59    Driver skeleton
60    Written 1993 by Donald Becker.
61    Copyright 1993 United States Government as represented by the Director,
62    National Security Agency. This software may only be used and distributed
63    according to the terms of the GNU General Public License as modified by SRC,
64    incorporated herein by reference.
65 
66    The author may be reached as becker@scyld.com, or C/O
67    Scyld Computing Corporation, 410 Severn Ave., Suite 210, Annapolis MD 21403
68 
69  */
70 
71 #include <linux/module.h>
72 #include <linux/kernel.h>
73 #include <linux/string.h>
74 #include <linux/ptrace.h>
75 #include <linux/errno.h>
76 #include <linux/ioport.h>
77 #include <linux/interrupt.h>
78 #include <linux/delay.h>
79 #include <linux/netdevice.h>
80 #include <linux/etherdevice.h>
81 #include <linux/skbuff.h>
82 #include <linux/types.h>
83 #include <linux/bitops.h>
84 #include <linux/dma-mapping.h>
85 
86 #include <asm/io.h>
87 #include <asm/irq.h>
88 #include <asm/pdc.h>
89 #include <asm/parisc-device.h>
90 
91 #define LASI_82596_DRIVER_VERSION "LASI 82596 driver - Revision: 1.30"
92 
93 #define PA_I82596_RESET		0	/* Offsets relative to LASI-LAN-Addr.*/
94 #define PA_CPU_PORT_L_ACCESS	4
95 #define PA_CHANNEL_ATTENTION	8
96 
97 #define OPT_SWAP_PORT	0x0001	/* Need to wordswp on the MPU port */
98 
99 #define DMA_ALLOC                        dma_alloc_noncoherent
100 #define DMA_FREE                         dma_free_noncoherent
101 #define DMA_WBACK(ndev, addr, len) \
102 	do { dma_cache_sync((ndev)->dev.parent, (void *)addr, len, DMA_TO_DEVICE); } while (0)
103 
104 #define DMA_INV(ndev, addr, len) \
105 	do { dma_cache_sync((ndev)->dev.parent, (void *)addr, len, DMA_FROM_DEVICE); } while (0)
106 
107 #define DMA_WBACK_INV(ndev, addr, len) \
108 	do { dma_cache_sync((ndev)->dev.parent, (void *)addr, len, DMA_BIDIRECTIONAL); } while (0)
109 
110 #define SYSBUS      0x0000006c;
111 
112 /* big endian CPU, 82596 "big" endian mode */
113 #define SWAP32(x)   (((u32)(x)<<16) | ((((u32)(x)))>>16))
114 #define SWAP16(x)   (x)
115 
116 #include "lib82596.c"
117 
118 MODULE_AUTHOR("Richard Hirst");
119 MODULE_DESCRIPTION("i82596 driver");
120 MODULE_LICENSE("GPL");
121 module_param(i596_debug, int, 0);
122 MODULE_PARM_DESC(i596_debug, "lasi_82596 debug mask");
123 
124 static inline void ca(struct net_device *dev)
125 {
126 	gsc_writel(0, dev->base_addr + PA_CHANNEL_ATTENTION);
127 }
128 
129 
130 static void mpu_port(struct net_device *dev, int c, dma_addr_t x)
131 {
132 	struct i596_private *lp = netdev_priv(dev);
133 
134 	u32 v = (u32) (c) | (u32) (x);
135 	u16 a, b;
136 
137 	if (lp->options & OPT_SWAP_PORT) {
138 		a = v >> 16;
139 		b = v & 0xffff;
140 	} else {
141 		a = v & 0xffff;
142 		b = v >> 16;
143 	}
144 
145 	gsc_writel(a, dev->base_addr + PA_CPU_PORT_L_ACCESS);
146 	udelay(1);
147 	gsc_writel(b, dev->base_addr + PA_CPU_PORT_L_ACCESS);
148 }
149 
150 #define LAN_PROM_ADDR	0xF0810000
151 
152 static int
153 lan_init_chip(struct parisc_device *dev)
154 {
155 	struct	net_device *netdevice;
156 	struct i596_private *lp;
157 	int	retval;
158 	int i;
159 
160 	if (!dev->irq) {
161 		printk(KERN_ERR "%s: IRQ not found for i82596 at 0x%lx\n",
162 			__FILE__, (unsigned long)dev->hpa.start);
163 		return -ENODEV;
164 	}
165 
166 	printk(KERN_INFO "Found i82596 at 0x%lx, IRQ %d\n",
167 			(unsigned long)dev->hpa.start, dev->irq);
168 
169 	netdevice = alloc_etherdev(sizeof(struct i596_private));
170 	if (!netdevice)
171 		return -ENOMEM;
172 	SET_NETDEV_DEV(netdevice, &dev->dev);
173 	parisc_set_drvdata (dev, netdevice);
174 
175 	netdevice->base_addr = dev->hpa.start;
176 	netdevice->irq = dev->irq;
177 
178 	if (pdc_lan_station_id(netdevice->dev_addr, netdevice->base_addr)) {
179 		for (i = 0; i < 6; i++) {
180 			netdevice->dev_addr[i] = gsc_readb(LAN_PROM_ADDR + i);
181 		}
182 		printk(KERN_INFO
183 		       "%s: MAC of HP700 LAN read from EEPROM\n", __FILE__);
184 	}
185 
186 	lp = netdev_priv(netdevice);
187 	lp->options = dev->id.sversion == 0x72 ? OPT_SWAP_PORT : 0;
188 
189 	retval = i82596_probe(netdevice);
190 	if (retval) {
191 		free_netdev(netdevice);
192 		return -ENODEV;
193 	}
194 	return retval;
195 }
196 
197 static int lan_remove_chip(struct parisc_device *pdev)
198 {
199 	struct net_device *dev = parisc_get_drvdata(pdev);
200 	struct i596_private *lp = netdev_priv(dev);
201 
202 	unregister_netdev (dev);
203 	DMA_FREE(&pdev->dev, sizeof(struct i596_private),
204 		 (void *)lp->dma, lp->dma_addr);
205 	free_netdev (dev);
206 	return 0;
207 }
208 
209 static struct parisc_device_id lan_tbl[] = {
210 	{ HPHW_FIO, HVERSION_REV_ANY_ID, HVERSION_ANY_ID, 0x0008a },
211 	{ HPHW_FIO, HVERSION_REV_ANY_ID, HVERSION_ANY_ID, 0x00072 },
212 	{ 0, }
213 };
214 
215 MODULE_DEVICE_TABLE(parisc, lan_tbl);
216 
217 static struct parisc_driver lan_driver = {
218 	.name		= "lasi_82596",
219 	.id_table	= lan_tbl,
220 	.probe		= lan_init_chip,
221 	.remove         = lan_remove_chip,
222 };
223 
224 static int lasi_82596_init(void)
225 {
226 	printk(KERN_INFO LASI_82596_DRIVER_VERSION "\n");
227 	return register_parisc_driver(&lan_driver);
228 }
229 
230 module_init(lasi_82596_init);
231 
232 static void __exit lasi_82596_exit(void)
233 {
234 	unregister_parisc_driver(&lan_driver);
235 }
236 
237 module_exit(lasi_82596_exit);
238