xref: /openbmc/linux/drivers/net/dsa/b53/b53_serdes.h (revision 85250a24)
1 /* SPDX-License-Identifier: GPL-2.0 or BSD-3-Clause */
2 /*
3  * Northstar Plus switch SerDes/SGMII PHY definitions
4  *
5  * Copyright (C) 2018 Florian Fainelli <f.fainelli@gmail.com>
6  */
7 
8 #include <linux/phy.h>
9 #include <linux/types.h>
10 
11 /* Non-standard page used to access SerDes PHY registers on NorthStar Plus */
12 #define B53_SERDES_PAGE			0x16
13 #define B53_SERDES_BLKADDR		0x3e
14 #define B53_SERDES_LANE			0x3c
15 
16 #define B53_SERDES_ID0			0x20
17 #define  SERDES_ID0_MODEL_MASK		0x3f
18 #define  SERDES_ID0_REV_NUM_SHIFT	11
19 #define  SERDES_ID0_REV_NUM_MASK	0x7
20 #define  SERDES_ID0_REV_LETTER_SHIFT	14
21 
22 #define B53_SERDES_MII_REG(x)		(0x20 + (x) * 2)
23 #define B53_SERDES_DIGITAL_CONTROL(x)	(0x1e + (x) * 2)
24 #define B53_SERDES_DIGITAL_STATUS	0x28
25 
26 /* SERDES_DIGITAL_CONTROL1 */
27 #define  FIBER_MODE_1000X		BIT(0)
28 #define  TBI_INTERFACE			BIT(1)
29 #define  SIGNAL_DETECT_EN		BIT(2)
30 #define  INVERT_SIGNAL_DETECT		BIT(3)
31 #define  AUTODET_EN			BIT(4)
32 #define  SGMII_MASTER_MODE		BIT(5)
33 #define  DISABLE_DLL_PWRDOWN		BIT(6)
34 #define  CRC_CHECKER_DIS		BIT(7)
35 #define  COMMA_DET_EN			BIT(8)
36 #define  ZERO_COMMA_DET_EN		BIT(9)
37 #define  REMOTE_LOOPBACK		BIT(10)
38 #define  SEL_RX_PKTS_FOR_CNTR		BIT(11)
39 #define  MASTER_MDIO_PHY_SEL		BIT(13)
40 #define  DISABLE_SIGNAL_DETECT_FLT	BIT(14)
41 
42 /* SERDES_DIGITAL_CONTROL2 */
43 #define  EN_PARALLEL_DET		BIT(0)
44 #define  DIS_FALSE_LINK			BIT(1)
45 #define  FLT_FORCE_LINK			BIT(2)
46 #define  EN_AUTONEG_ERR_TIMER		BIT(3)
47 #define  DIS_REMOTE_FAULT_SENSING	BIT(4)
48 #define  FORCE_XMIT_DATA		BIT(5)
49 #define  AUTONEG_FAST_TIMERS		BIT(6)
50 #define  DIS_CARRIER_EXTEND		BIT(7)
51 #define  DIS_TRRR_GENERATION		BIT(8)
52 #define  BYPASS_PCS_RX			BIT(9)
53 #define  BYPASS_PCS_TX			BIT(10)
54 #define  TEST_CNTR_EN			BIT(11)
55 #define  TX_PACKET_SEQ_TEST		BIT(12)
56 #define  TX_IDLE_JAM_SEQ_TEST		BIT(13)
57 #define  CLR_BER_CNTR			BIT(14)
58 
59 /* SERDES_DIGITAL_CONTROL3 */
60 #define  TX_FIFO_RST			BIT(0)
61 #define  FIFO_ELAST_TX_RX_SHIFT		1
62 #define  FIFO_ELAST_TX_RX_5K		0
63 #define  FIFO_ELAST_TX_RX_10K		1
64 #define  FIFO_ELAST_TX_RX_13_5K		2
65 #define  FIFO_ELAST_TX_RX_18_5K		3
66 #define  BLOCK_TXEN_MODE		BIT(9)
67 #define  JAM_FALSE_CARRIER_MODE		BIT(10)
68 #define  EXT_PHY_CRS_MODE		BIT(11)
69 #define  INVERT_EXT_PHY_CRS		BIT(12)
70 #define  DISABLE_TX_CRS			BIT(13)
71 
72 /* SERDES_DIGITAL_STATUS */
73 #define  SGMII_MODE			BIT(0)
74 #define  LINK_STATUS			BIT(1)
75 #define  DUPLEX_STATUS			BIT(2)
76 #define  SPEED_STATUS_SHIFT		3
77 #define  SPEED_STATUS_10		0
78 #define  SPEED_STATUS_100		1
79 #define  SPEED_STATUS_1000		2
80 #define  SPEED_STATUS_2500		3
81 #define  SPEED_STATUS_MASK		SPEED_STATUS_2500
82 #define  PAUSE_RESOLUTION_TX_SIDE	BIT(5)
83 #define  PAUSE_RESOLUTION_RX_SIDE	BIT(6)
84 #define  LINK_STATUS_CHANGE		BIT(7)
85 #define  EARLY_END_EXT_DET		BIT(8)
86 #define  CARRIER_EXT_ERR_DET		BIT(9)
87 #define  RX_ERR_DET			BIT(10)
88 #define  TX_ERR_DET			BIT(11)
89 #define  CRC_ERR_DET			BIT(12)
90 #define  FALSE_CARRIER_ERR_DET		BIT(13)
91 #define  RXFIFO_ERR_DET			BIT(14)
92 #define  TXFIFO_ERR_DET			BIT(15)
93 
94 /* Block offsets */
95 #define SERDES_DIGITAL_BLK		0x8300
96 #define SERDES_ID0			0x8310
97 #define SERDES_MII_BLK			0xffe0
98 #define SERDES_XGXSBLK0_BLOCKADDRESS	0xffd0
99 
100 struct phylink_link_state;
101 
102 static inline u8 b53_serdes_map_lane(struct b53_device *dev, int port)
103 {
104 	if (!dev->ops->serdes_map_lane)
105 		return B53_INVALID_LANE;
106 
107 	return dev->ops->serdes_map_lane(dev, port);
108 }
109 
110 void b53_serdes_link_set(struct b53_device *dev, int port, unsigned int mode,
111 			 phy_interface_t interface, bool link_up);
112 struct phylink_pcs *b53_serdes_phylink_mac_select_pcs(struct b53_device *dev,
113 						      int port,
114 						      phy_interface_t interface);
115 void b53_serdes_phylink_get_caps(struct b53_device *dev, int port,
116 				 struct phylink_config *config);
117 #if IS_ENABLED(CONFIG_B53_SERDES)
118 int b53_serdes_init(struct b53_device *dev, int port);
119 #else
120 static inline int b53_serdes_init(struct b53_device *dev, int port)
121 {
122 	return -ENODEV;
123 }
124 #endif
125