1 /* 2 * MTD map driver for BIOS Flash on Intel SCB2 boards 3 * $Id: scb2_flash.c,v 1.12 2005/03/18 14:04:35 gleixner Exp $ 4 * Copyright (C) 2002 Sun Microsystems, Inc. 5 * Tim Hockin <thockin@sun.com> 6 * 7 * A few notes on this MTD map: 8 * 9 * This was developed with a small number of SCB2 boards to test on. 10 * Hopefully, Intel has not introducted too many unaccounted variables in the 11 * making of this board. 12 * 13 * The BIOS marks its own memory region as 'reserved' in the e820 map. We 14 * try to request it here, but if it fails, we carry on anyway. 15 * 16 * This is how the chip is attached, so said the schematic: 17 * * a 4 MiB (32 Mib) 16 bit chip 18 * * a 1 MiB memory region 19 * * A20 and A21 pulled up 20 * * D8-D15 ignored 21 * What this means is that, while we are addressing bytes linearly, we are 22 * really addressing words, and discarding the other byte. This means that 23 * the chip MUST BE at least 2 MiB. This also means that every block is 24 * actually half as big as the chip reports. It also means that accesses of 25 * logical address 0 hit higher-address sections of the chip, not physical 0. 26 * One can only hope that these 4MiB x16 chips were a lot cheaper than 1MiB x8 27 * chips. 28 * 29 * This driver assumes the chip is not write-protected by an external signal. 30 * As of the this writing, that is true, but may change, just to spite me. 31 * 32 * The actual BIOS layout has been mostly reverse engineered. Intel BIOS 33 * updates for this board include 10 related (*.bio - &.bi9) binary files and 34 * another separate (*.bbo) binary file. The 10 files are 64k of data + a 35 * small header. If the headers are stripped off, the 10 64k files can be 36 * concatenated into a 640k image. This is your BIOS image, proper. The 37 * separate .bbo file also has a small header. It is the 'Boot Block' 38 * recovery BIOS. Once the header is stripped, no further prep is needed. 39 * As best I can tell, the BIOS is arranged as such: 40 * offset 0x00000 to 0x4ffff (320k): unknown - SCSI BIOS, etc? 41 * offset 0x50000 to 0xeffff (640k): BIOS proper 42 * offset 0xf0000 ty 0xfffff (64k): Boot Block region 43 * 44 * Intel's BIOS update program flashes the BIOS and Boot Block in separate 45 * steps. Probably a wise thing to do. 46 */ 47 48 #include <linux/module.h> 49 #include <linux/types.h> 50 #include <linux/kernel.h> 51 #include <linux/init.h> 52 #include <asm/io.h> 53 #include <linux/mtd/mtd.h> 54 #include <linux/mtd/map.h> 55 #include <linux/mtd/cfi.h> 56 #include <linux/pci.h> 57 #include <linux/pci_ids.h> 58 59 #define MODNAME "scb2_flash" 60 #define SCB2_ADDR 0xfff00000 61 #define SCB2_WINDOW 0x00100000 62 63 64 static void __iomem *scb2_ioaddr; 65 static struct mtd_info *scb2_mtd; 66 static struct map_info scb2_map = { 67 .name = "SCB2 BIOS Flash", 68 .size = 0, 69 .bankwidth = 1, 70 }; 71 static int region_fail; 72 73 static int __devinit 74 scb2_fixup_mtd(struct mtd_info *mtd) 75 { 76 int i; 77 int done = 0; 78 struct map_info *map = mtd->priv; 79 struct cfi_private *cfi = map->fldrv_priv; 80 81 /* barf if this doesn't look right */ 82 if (cfi->cfiq->InterfaceDesc != CFI_INTERFACE_X16_ASYNC) { 83 printk(KERN_ERR MODNAME ": unsupported InterfaceDesc: %#x\n", 84 cfi->cfiq->InterfaceDesc); 85 return -1; 86 } 87 88 /* I wasn't here. I didn't see. dwmw2. */ 89 90 /* the chip is sometimes bigger than the map - what a waste */ 91 mtd->size = map->size; 92 93 /* 94 * We only REALLY get half the chip, due to the way it is 95 * wired up - D8-D15 are tossed away. We read linear bytes, 96 * but in reality we are getting 1/2 of each 16-bit read, 97 * which LOOKS linear to us. Because CFI code accounts for 98 * things like lock/unlock/erase by eraseregions, we need to 99 * fudge them to reflect this. Erases go like this: 100 * * send an erase to an address 101 * * the chip samples the address and erases the block 102 * * add the block erasesize to the address and repeat 103 * -- the problem is that addresses are 16-bit addressable 104 * -- we end up erasing every-other block 105 */ 106 mtd->erasesize /= 2; 107 for (i = 0; i < mtd->numeraseregions; i++) { 108 struct mtd_erase_region_info *region = &mtd->eraseregions[i]; 109 region->erasesize /= 2; 110 } 111 112 /* 113 * If the chip is bigger than the map, it is wired with the high 114 * address lines pulled up. This makes us access the top portion of 115 * the chip, so all our erase-region info is wrong. Start cutting from 116 * the bottom. 117 */ 118 for (i = 0; !done && i < mtd->numeraseregions; i++) { 119 struct mtd_erase_region_info *region = &mtd->eraseregions[i]; 120 121 if (region->numblocks * region->erasesize > mtd->size) { 122 region->numblocks = (mtd->size / region->erasesize); 123 done = 1; 124 } else { 125 region->numblocks = 0; 126 } 127 region->offset = 0; 128 } 129 130 return 0; 131 } 132 133 /* CSB5's 'Function Control Register' has bits for decoding @ >= 0xffc00000 */ 134 #define CSB5_FCR 0x41 135 #define CSB5_FCR_DECODE_ALL 0x0e 136 static int __devinit 137 scb2_flash_probe(struct pci_dev *dev, const struct pci_device_id *ent) 138 { 139 u8 reg; 140 141 /* enable decoding of the flash region in the south bridge */ 142 pci_read_config_byte(dev, CSB5_FCR, ®); 143 pci_write_config_byte(dev, CSB5_FCR, reg | CSB5_FCR_DECODE_ALL); 144 145 if (!request_mem_region(SCB2_ADDR, SCB2_WINDOW, scb2_map.name)) { 146 /* 147 * The BIOS seems to mark the flash region as 'reserved' 148 * in the e820 map. Warn and go about our business. 149 */ 150 printk(KERN_WARNING MODNAME 151 ": warning - can't reserve rom window, continuing\n"); 152 region_fail = 1; 153 } 154 155 /* remap the IO window (w/o caching) */ 156 scb2_ioaddr = ioremap_nocache(SCB2_ADDR, SCB2_WINDOW); 157 if (!scb2_ioaddr) { 158 printk(KERN_ERR MODNAME ": Failed to ioremap window!\n"); 159 if (!region_fail) 160 release_mem_region(SCB2_ADDR, SCB2_WINDOW); 161 return -ENOMEM; 162 } 163 164 scb2_map.phys = SCB2_ADDR; 165 scb2_map.virt = scb2_ioaddr; 166 scb2_map.size = SCB2_WINDOW; 167 168 simple_map_init(&scb2_map); 169 170 /* try to find a chip */ 171 scb2_mtd = do_map_probe("cfi_probe", &scb2_map); 172 173 if (!scb2_mtd) { 174 printk(KERN_ERR MODNAME ": flash probe failed!\n"); 175 iounmap(scb2_ioaddr); 176 if (!region_fail) 177 release_mem_region(SCB2_ADDR, SCB2_WINDOW); 178 return -ENODEV; 179 } 180 181 scb2_mtd->owner = THIS_MODULE; 182 if (scb2_fixup_mtd(scb2_mtd) < 0) { 183 del_mtd_device(scb2_mtd); 184 map_destroy(scb2_mtd); 185 iounmap(scb2_ioaddr); 186 if (!region_fail) 187 release_mem_region(SCB2_ADDR, SCB2_WINDOW); 188 return -ENODEV; 189 } 190 191 printk(KERN_NOTICE MODNAME ": chip size 0x%x at offset 0x%x\n", 192 scb2_mtd->size, SCB2_WINDOW - scb2_mtd->size); 193 194 add_mtd_device(scb2_mtd); 195 196 return 0; 197 } 198 199 static void __devexit 200 scb2_flash_remove(struct pci_dev *dev) 201 { 202 if (!scb2_mtd) 203 return; 204 205 /* disable flash writes */ 206 if (scb2_mtd->lock) 207 scb2_mtd->lock(scb2_mtd, 0, scb2_mtd->size); 208 209 del_mtd_device(scb2_mtd); 210 map_destroy(scb2_mtd); 211 212 iounmap(scb2_ioaddr); 213 scb2_ioaddr = NULL; 214 215 if (!region_fail) 216 release_mem_region(SCB2_ADDR, SCB2_WINDOW); 217 pci_set_drvdata(dev, NULL); 218 } 219 220 static struct pci_device_id scb2_flash_pci_ids[] = { 221 { 222 .vendor = PCI_VENDOR_ID_SERVERWORKS, 223 .device = PCI_DEVICE_ID_SERVERWORKS_CSB5, 224 .subvendor = PCI_ANY_ID, 225 .subdevice = PCI_ANY_ID 226 }, 227 { 0, } 228 }; 229 230 static struct pci_driver scb2_flash_driver = { 231 .name = "Intel SCB2 BIOS Flash", 232 .id_table = scb2_flash_pci_ids, 233 .probe = scb2_flash_probe, 234 .remove = __devexit_p(scb2_flash_remove), 235 }; 236 237 static int __init 238 scb2_flash_init(void) 239 { 240 return pci_register_driver(&scb2_flash_driver); 241 } 242 243 static void __exit 244 scb2_flash_exit(void) 245 { 246 pci_unregister_driver(&scb2_flash_driver); 247 } 248 249 module_init(scb2_flash_init); 250 module_exit(scb2_flash_exit); 251 252 MODULE_LICENSE("GPL"); 253 MODULE_AUTHOR("Tim Hockin <thockin@sun.com>"); 254 MODULE_DESCRIPTION("MTD map driver for Intel SCB2 BIOS Flash"); 255 MODULE_DEVICE_TABLE(pci, scb2_flash_pci_ids); 256