xref: /openbmc/linux/drivers/mtd/maps/scb2_flash.c (revision 36fa3e50)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * MTD map driver for BIOS Flash on Intel SCB2 boards
4  * Copyright (C) 2002 Sun Microsystems, Inc.
5  * Tim Hockin <thockin@sun.com>
6  *
7  * A few notes on this MTD map:
8  *
9  * This was developed with a small number of SCB2 boards to test on.
10  * Hopefully, Intel has not introducted too many unaccounted variables in the
11  * making of this board.
12  *
13  * The BIOS marks its own memory region as 'reserved' in the e820 map.  We
14  * try to request it here, but if it fails, we carry on anyway.
15  *
16  * This is how the chip is attached, so said the schematic:
17  * * a 4 MiB (32 Mib) 16 bit chip
18  * * a 1 MiB memory region
19  * * A20 and A21 pulled up
20  * * D8-D15 ignored
21  * What this means is that, while we are addressing bytes linearly, we are
22  * really addressing words, and discarding the other byte.  This means that
23  * the chip MUST BE at least 2 MiB.  This also means that every block is
24  * actually half as big as the chip reports.  It also means that accesses of
25  * logical address 0 hit higher-address sections of the chip, not physical 0.
26  * One can only hope that these 4MiB x16 chips were a lot cheaper than 1MiB x8
27  * chips.
28  *
29  * This driver assumes the chip is not write-protected by an external signal.
30  * As of the this writing, that is true, but may change, just to spite me.
31  *
32  * The actual BIOS layout has been mostly reverse engineered.  Intel BIOS
33  * updates for this board include 10 related (*.bio - &.bi9) binary files and
34  * another separate (*.bbo) binary file.  The 10 files are 64k of data + a
35  * small header.  If the headers are stripped off, the 10 64k files can be
36  * concatenated into a 640k image.  This is your BIOS image, proper.  The
37  * separate .bbo file also has a small header.  It is the 'Boot Block'
38  * recovery BIOS.  Once the header is stripped, no further prep is needed.
39  * As best I can tell, the BIOS is arranged as such:
40  * offset 0x00000 to 0x4ffff (320k):  unknown - SCSI BIOS, etc?
41  * offset 0x50000 to 0xeffff (640k):  BIOS proper
42  * offset 0xf0000 ty 0xfffff (64k):   Boot Block region
43  *
44  * Intel's BIOS update program flashes the BIOS and Boot Block in separate
45  * steps.  Probably a wise thing to do.
46  */
47 
48 #include <linux/module.h>
49 #include <linux/types.h>
50 #include <linux/kernel.h>
51 #include <asm/io.h>
52 #include <linux/mtd/mtd.h>
53 #include <linux/mtd/map.h>
54 #include <linux/mtd/cfi.h>
55 #include <linux/pci.h>
56 #include <linux/pci_ids.h>
57 
58 #define MODNAME		"scb2_flash"
59 #define SCB2_ADDR	0xfff00000
60 #define SCB2_WINDOW	0x00100000
61 
62 
63 static void __iomem *scb2_ioaddr;
64 static struct mtd_info *scb2_mtd;
65 static struct map_info scb2_map = {
66 	.name =      "SCB2 BIOS Flash",
67 	.size =      0,
68 	.bankwidth =  1,
69 };
70 static int region_fail;
71 
72 static int scb2_fixup_mtd(struct mtd_info *mtd)
73 {
74 	int i;
75 	int done = 0;
76 	struct map_info *map = mtd->priv;
77 	struct cfi_private *cfi = map->fldrv_priv;
78 
79 	/* barf if this doesn't look right */
80 	if (cfi->cfiq->InterfaceDesc != CFI_INTERFACE_X16_ASYNC) {
81 		printk(KERN_ERR MODNAME ": unsupported InterfaceDesc: %#x\n",
82 		    cfi->cfiq->InterfaceDesc);
83 		return -1;
84 	}
85 
86 	/* I wasn't here. I didn't see. dwmw2. */
87 
88 	/* the chip is sometimes bigger than the map - what a waste */
89 	mtd->size = map->size;
90 
91 	/*
92 	 * We only REALLY get half the chip, due to the way it is
93 	 * wired up - D8-D15 are tossed away.  We read linear bytes,
94 	 * but in reality we are getting 1/2 of each 16-bit read,
95 	 * which LOOKS linear to us.  Because CFI code accounts for
96 	 * things like lock/unlock/erase by eraseregions, we need to
97 	 * fudge them to reflect this.  Erases go like this:
98 	 *   * send an erase to an address
99 	 *   * the chip samples the address and erases the block
100 	 *   * add the block erasesize to the address and repeat
101 	 *   -- the problem is that addresses are 16-bit addressable
102 	 *   -- we end up erasing every-other block
103 	 */
104 	mtd->erasesize /= 2;
105 	for (i = 0; i < mtd->numeraseregions; i++) {
106 		struct mtd_erase_region_info *region = &mtd->eraseregions[i];
107 		region->erasesize /= 2;
108 	}
109 
110 	/*
111 	 * If the chip is bigger than the map, it is wired with the high
112 	 * address lines pulled up.  This makes us access the top portion of
113 	 * the chip, so all our erase-region info is wrong.  Start cutting from
114 	 * the bottom.
115 	 */
116 	for (i = 0; !done && i < mtd->numeraseregions; i++) {
117 		struct mtd_erase_region_info *region = &mtd->eraseregions[i];
118 
119 		if (region->numblocks * region->erasesize > mtd->size) {
120 			region->numblocks = ((unsigned long)mtd->size /
121 						region->erasesize);
122 			done = 1;
123 		} else {
124 			region->numblocks = 0;
125 		}
126 		region->offset = 0;
127 	}
128 
129 	return 0;
130 }
131 
132 /* CSB5's 'Function Control Register' has bits for decoding @ >= 0xffc00000 */
133 #define CSB5_FCR	0x41
134 #define CSB5_FCR_DECODE_ALL 0x0e
135 static int scb2_flash_probe(struct pci_dev *dev,
136 			    const struct pci_device_id *ent)
137 {
138 	u8 reg;
139 
140 	/* enable decoding of the flash region in the south bridge */
141 	pci_read_config_byte(dev, CSB5_FCR, &reg);
142 	pci_write_config_byte(dev, CSB5_FCR, reg | CSB5_FCR_DECODE_ALL);
143 
144 	if (!request_mem_region(SCB2_ADDR, SCB2_WINDOW, scb2_map.name)) {
145 		/*
146 		 * The BIOS seems to mark the flash region as 'reserved'
147 		 * in the e820 map.  Warn and go about our business.
148 		 */
149 		printk(KERN_WARNING MODNAME
150 		    ": warning - can't reserve rom window, continuing\n");
151 		region_fail = 1;
152 	}
153 
154 	/* remap the IO window (w/o caching) */
155 	scb2_ioaddr = ioremap(SCB2_ADDR, SCB2_WINDOW);
156 	if (!scb2_ioaddr) {
157 		printk(KERN_ERR MODNAME ": Failed to ioremap window!\n");
158 		if (!region_fail)
159 			release_mem_region(SCB2_ADDR, SCB2_WINDOW);
160 		return -ENOMEM;
161 	}
162 
163 	scb2_map.phys = SCB2_ADDR;
164 	scb2_map.virt = scb2_ioaddr;
165 	scb2_map.size = SCB2_WINDOW;
166 
167 	simple_map_init(&scb2_map);
168 
169 	/* try to find a chip */
170 	scb2_mtd = do_map_probe("cfi_probe", &scb2_map);
171 
172 	if (!scb2_mtd) {
173 		printk(KERN_ERR MODNAME ": flash probe failed!\n");
174 		iounmap(scb2_ioaddr);
175 		if (!region_fail)
176 			release_mem_region(SCB2_ADDR, SCB2_WINDOW);
177 		return -ENODEV;
178 	}
179 
180 	scb2_mtd->owner = THIS_MODULE;
181 	if (scb2_fixup_mtd(scb2_mtd) < 0) {
182 		mtd_device_unregister(scb2_mtd);
183 		map_destroy(scb2_mtd);
184 		iounmap(scb2_ioaddr);
185 		if (!region_fail)
186 			release_mem_region(SCB2_ADDR, SCB2_WINDOW);
187 		return -ENODEV;
188 	}
189 
190 	printk(KERN_NOTICE MODNAME ": chip size 0x%llx at offset 0x%llx\n",
191 	       (unsigned long long)scb2_mtd->size,
192 	       (unsigned long long)(SCB2_WINDOW - scb2_mtd->size));
193 
194 	mtd_device_register(scb2_mtd, NULL, 0);
195 
196 	return 0;
197 }
198 
199 static void scb2_flash_remove(struct pci_dev *dev)
200 {
201 	if (!scb2_mtd)
202 		return;
203 
204 	/* disable flash writes */
205 	mtd_lock(scb2_mtd, 0, scb2_mtd->size);
206 
207 	mtd_device_unregister(scb2_mtd);
208 	map_destroy(scb2_mtd);
209 
210 	iounmap(scb2_ioaddr);
211 	scb2_ioaddr = NULL;
212 
213 	if (!region_fail)
214 		release_mem_region(SCB2_ADDR, SCB2_WINDOW);
215 }
216 
217 static struct pci_device_id scb2_flash_pci_ids[] = {
218 	{
219 	  .vendor = PCI_VENDOR_ID_SERVERWORKS,
220 	  .device = PCI_DEVICE_ID_SERVERWORKS_CSB5,
221 	  .subvendor = PCI_ANY_ID,
222 	  .subdevice = PCI_ANY_ID
223 	},
224 	{ 0, }
225 };
226 
227 static struct pci_driver scb2_flash_driver = {
228 	.name =     "Intel SCB2 BIOS Flash",
229 	.id_table = scb2_flash_pci_ids,
230 	.probe =    scb2_flash_probe,
231 	.remove =   scb2_flash_remove,
232 };
233 
234 module_pci_driver(scb2_flash_driver);
235 
236 MODULE_LICENSE("GPL");
237 MODULE_AUTHOR("Tim Hockin <thockin@sun.com>");
238 MODULE_DESCRIPTION("MTD map driver for Intel SCB2 BIOS Flash");
239 MODULE_DEVICE_TABLE(pci, scb2_flash_pci_ids);
240