xref: /openbmc/linux/drivers/mfd/ti-lmu.c (revision f2a55d08)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * TI LMU (Lighting Management Unit) Core Driver
4  *
5  * Copyright 2017 Texas Instruments
6  *
7  * Author: Milo Kim <milo.kim@ti.com>
8  */
9 
10 #include <linux/delay.h>
11 #include <linux/err.h>
12 #include <linux/gpio/consumer.h>
13 #include <linux/i2c.h>
14 #include <linux/kernel.h>
15 #include <linux/mfd/core.h>
16 #include <linux/mfd/ti-lmu.h>
17 #include <linux/mfd/ti-lmu-register.h>
18 #include <linux/module.h>
19 #include <linux/of.h>
20 #include <linux/slab.h>
21 
22 struct ti_lmu_data {
23 	const struct mfd_cell *cells;
24 	int num_cells;
25 	unsigned int max_register;
26 };
27 
28 static int ti_lmu_enable_hw(struct ti_lmu *lmu, enum ti_lmu_id id)
29 {
30 	if (lmu->en_gpio)
31 		gpiod_set_value(lmu->en_gpio, 1);
32 
33 	/* Delay about 1ms after HW enable pin control */
34 	usleep_range(1000, 1500);
35 
36 	/* LM3631 has additional power up sequence - enable LCD_EN bit. */
37 	if (id == LM3631) {
38 		return regmap_update_bits(lmu->regmap, LM3631_REG_DEVCTRL,
39 					  LM3631_LCD_EN_MASK,
40 					  LM3631_LCD_EN_MASK);
41 	}
42 
43 	return 0;
44 }
45 
46 static void ti_lmu_disable_hw(void *data)
47 {
48 	struct ti_lmu *lmu = data;
49 	if (lmu->en_gpio)
50 		gpiod_set_value(lmu->en_gpio, 0);
51 }
52 
53 #define LM363X_REGULATOR(_id)			\
54 {						\
55 	.name          = "lm363x-regulator",	\
56 	.id            = _id,			\
57 	.of_compatible = "ti,lm363x-regulator",	\
58 }						\
59 
60 static const struct mfd_cell lm3631_devices[] = {
61 	LM363X_REGULATOR(LM3631_BOOST),
62 	LM363X_REGULATOR(LM3631_LDO_CONT),
63 	LM363X_REGULATOR(LM3631_LDO_OREF),
64 	LM363X_REGULATOR(LM3631_LDO_POS),
65 	LM363X_REGULATOR(LM3631_LDO_NEG),
66 	{
67 		.name          = "ti-lmu-backlight",
68 		.id            = LM3631,
69 		.of_compatible = "ti,lm3631-backlight",
70 	},
71 };
72 
73 static const struct mfd_cell lm3632_devices[] = {
74 	LM363X_REGULATOR(LM3632_BOOST),
75 	LM363X_REGULATOR(LM3632_LDO_POS),
76 	LM363X_REGULATOR(LM3632_LDO_NEG),
77 	{
78 		.name          = "ti-lmu-backlight",
79 		.id            = LM3632,
80 		.of_compatible = "ti,lm3632-backlight",
81 	},
82 };
83 
84 static const struct mfd_cell lm3633_devices[] = {
85 	{
86 		.name          = "ti-lmu-backlight",
87 		.id            = LM3633,
88 		.of_compatible = "ti,lm3633-backlight",
89 	},
90 	{
91 		.name          = "lm3633-leds",
92 		.of_compatible = "ti,lm3633-leds",
93 	},
94 	/* Monitoring driver for open/short circuit detection */
95 	{
96 		.name          = "ti-lmu-fault-monitor",
97 		.id            = LM3633,
98 		.of_compatible = "ti,lm3633-fault-monitor",
99 	},
100 };
101 
102 static const struct mfd_cell lm3695_devices[] = {
103 	{
104 		.name          = "ti-lmu-backlight",
105 		.id            = LM3695,
106 		.of_compatible = "ti,lm3695-backlight",
107 	},
108 };
109 
110 static const struct mfd_cell lm36274_devices[] = {
111 	LM363X_REGULATOR(LM36274_BOOST),
112 	LM363X_REGULATOR(LM36274_LDO_POS),
113 	LM363X_REGULATOR(LM36274_LDO_NEG),
114 	{
115 		.name          = "lm36274-leds",
116 		.id            = LM36274,
117 		.of_compatible = "ti,lm36274-backlight",
118 	},
119 };
120 
121 #define TI_LMU_DATA(chip, max_reg)		\
122 static const struct ti_lmu_data chip##_data =	\
123 {						\
124 	.cells = chip##_devices,		\
125 	.num_cells = ARRAY_SIZE(chip##_devices),\
126 	.max_register = max_reg,		\
127 }						\
128 
129 TI_LMU_DATA(lm3631, LM3631_MAX_REG);
130 TI_LMU_DATA(lm3632, LM3632_MAX_REG);
131 TI_LMU_DATA(lm3633, LM3633_MAX_REG);
132 TI_LMU_DATA(lm3695, LM3695_MAX_REG);
133 TI_LMU_DATA(lm36274, LM36274_MAX_REG);
134 
135 static int ti_lmu_probe(struct i2c_client *cl)
136 {
137 	const struct i2c_device_id *id = i2c_client_get_device_id(cl);
138 	struct device *dev = &cl->dev;
139 	const struct ti_lmu_data *data;
140 	struct regmap_config regmap_cfg;
141 	struct ti_lmu *lmu;
142 	int ret;
143 
144 	/*
145 	 * Get device specific data from of_match table.
146 	 * This data is defined by using TI_LMU_DATA() macro.
147 	 */
148 	data = of_device_get_match_data(dev);
149 	if (!data)
150 		return -ENODEV;
151 
152 	lmu = devm_kzalloc(dev, sizeof(*lmu), GFP_KERNEL);
153 	if (!lmu)
154 		return -ENOMEM;
155 
156 	lmu->dev = &cl->dev;
157 
158 	/* Setup regmap */
159 	memset(&regmap_cfg, 0, sizeof(struct regmap_config));
160 	regmap_cfg.reg_bits = 8;
161 	regmap_cfg.val_bits = 8;
162 	regmap_cfg.name = id->name;
163 	regmap_cfg.max_register = data->max_register;
164 
165 	lmu->regmap = devm_regmap_init_i2c(cl, &regmap_cfg);
166 	if (IS_ERR(lmu->regmap))
167 		return PTR_ERR(lmu->regmap);
168 
169 	/* HW enable pin control and additional power up sequence if required */
170 	lmu->en_gpio = devm_gpiod_get_optional(dev, "enable", GPIOD_OUT_HIGH);
171 	if (IS_ERR(lmu->en_gpio)) {
172 		ret = PTR_ERR(lmu->en_gpio);
173 		dev_err(dev, "Can not request enable GPIO: %d\n", ret);
174 		return ret;
175 	}
176 
177 	ret = ti_lmu_enable_hw(lmu, id->driver_data);
178 	if (ret)
179 		return ret;
180 
181 	ret = devm_add_action_or_reset(dev, ti_lmu_disable_hw, lmu);
182 	if (ret)
183 		return ret;
184 
185 	/*
186 	 * Fault circuit(open/short) can be detected by ti-lmu-fault-monitor.
187 	 * After fault detection is done, some devices should re-initialize
188 	 * configuration. The notifier enables such kind of handling.
189 	 */
190 	BLOCKING_INIT_NOTIFIER_HEAD(&lmu->notifier);
191 
192 	i2c_set_clientdata(cl, lmu);
193 
194 	return devm_mfd_add_devices(lmu->dev, 0, data->cells,
195 				    data->num_cells, NULL, 0, NULL);
196 }
197 
198 static const struct of_device_id ti_lmu_of_match[] = {
199 	{ .compatible = "ti,lm3631", .data = &lm3631_data },
200 	{ .compatible = "ti,lm3632", .data = &lm3632_data },
201 	{ .compatible = "ti,lm3633", .data = &lm3633_data },
202 	{ .compatible = "ti,lm3695", .data = &lm3695_data },
203 	{ .compatible = "ti,lm36274", .data = &lm36274_data },
204 	{ }
205 };
206 MODULE_DEVICE_TABLE(of, ti_lmu_of_match);
207 
208 static const struct i2c_device_id ti_lmu_ids[] = {
209 	{ "lm3631", LM3631 },
210 	{ "lm3632", LM3632 },
211 	{ "lm3633", LM3633 },
212 	{ "lm3695", LM3695 },
213 	{ "lm36274", LM36274 },
214 	{ }
215 };
216 MODULE_DEVICE_TABLE(i2c, ti_lmu_ids);
217 
218 static struct i2c_driver ti_lmu_driver = {
219 	.probe = ti_lmu_probe,
220 	.driver = {
221 		.name = "ti-lmu",
222 		.of_match_table = ti_lmu_of_match,
223 	},
224 	.id_table = ti_lmu_ids,
225 };
226 
227 module_i2c_driver(ti_lmu_driver);
228 
229 MODULE_DESCRIPTION("TI LMU MFD Core Driver");
230 MODULE_AUTHOR("Milo Kim");
231 MODULE_LICENSE("GPL v2");
232