xref: /openbmc/linux/drivers/mfd/ti-lmu.c (revision f125e2d4)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * TI LMU (Lighting Management Unit) Core Driver
4  *
5  * Copyright 2017 Texas Instruments
6  *
7  * Author: Milo Kim <milo.kim@ti.com>
8  */
9 
10 #include <linux/delay.h>
11 #include <linux/err.h>
12 #include <linux/gpio/consumer.h>
13 #include <linux/i2c.h>
14 #include <linux/kernel.h>
15 #include <linux/mfd/core.h>
16 #include <linux/mfd/ti-lmu.h>
17 #include <linux/mfd/ti-lmu-register.h>
18 #include <linux/module.h>
19 #include <linux/of.h>
20 #include <linux/of_device.h>
21 #include <linux/slab.h>
22 
23 struct ti_lmu_data {
24 	const struct mfd_cell *cells;
25 	int num_cells;
26 	unsigned int max_register;
27 };
28 
29 static int ti_lmu_enable_hw(struct ti_lmu *lmu, enum ti_lmu_id id)
30 {
31 	if (lmu->en_gpio)
32 		gpiod_set_value(lmu->en_gpio, 1);
33 
34 	/* Delay about 1ms after HW enable pin control */
35 	usleep_range(1000, 1500);
36 
37 	/* LM3631 has additional power up sequence - enable LCD_EN bit. */
38 	if (id == LM3631) {
39 		return regmap_update_bits(lmu->regmap, LM3631_REG_DEVCTRL,
40 					  LM3631_LCD_EN_MASK,
41 					  LM3631_LCD_EN_MASK);
42 	}
43 
44 	return 0;
45 }
46 
47 static void ti_lmu_disable_hw(void *data)
48 {
49 	struct ti_lmu *lmu = data;
50 	if (lmu->en_gpio)
51 		gpiod_set_value(lmu->en_gpio, 0);
52 }
53 
54 #define LM363X_REGULATOR(_id)			\
55 {						\
56 	.name          = "lm363x-regulator",	\
57 	.id            = _id,			\
58 	.of_compatible = "ti,lm363x-regulator",	\
59 }						\
60 
61 static const struct mfd_cell lm3631_devices[] = {
62 	LM363X_REGULATOR(LM3631_BOOST),
63 	LM363X_REGULATOR(LM3631_LDO_CONT),
64 	LM363X_REGULATOR(LM3631_LDO_OREF),
65 	LM363X_REGULATOR(LM3631_LDO_POS),
66 	LM363X_REGULATOR(LM3631_LDO_NEG),
67 	{
68 		.name          = "ti-lmu-backlight",
69 		.id            = LM3631,
70 		.of_compatible = "ti,lm3631-backlight",
71 	},
72 };
73 
74 static const struct mfd_cell lm3632_devices[] = {
75 	LM363X_REGULATOR(LM3632_BOOST),
76 	LM363X_REGULATOR(LM3632_LDO_POS),
77 	LM363X_REGULATOR(LM3632_LDO_NEG),
78 	{
79 		.name          = "ti-lmu-backlight",
80 		.id            = LM3632,
81 		.of_compatible = "ti,lm3632-backlight",
82 	},
83 };
84 
85 static const struct mfd_cell lm3633_devices[] = {
86 	{
87 		.name          = "ti-lmu-backlight",
88 		.id            = LM3633,
89 		.of_compatible = "ti,lm3633-backlight",
90 	},
91 	{
92 		.name          = "lm3633-leds",
93 		.of_compatible = "ti,lm3633-leds",
94 	},
95 	/* Monitoring driver for open/short circuit detection */
96 	{
97 		.name          = "ti-lmu-fault-monitor",
98 		.id            = LM3633,
99 		.of_compatible = "ti,lm3633-fault-monitor",
100 	},
101 };
102 
103 static const struct mfd_cell lm3695_devices[] = {
104 	{
105 		.name          = "ti-lmu-backlight",
106 		.id            = LM3695,
107 		.of_compatible = "ti,lm3695-backlight",
108 	},
109 };
110 
111 static const struct mfd_cell lm36274_devices[] = {
112 	LM363X_REGULATOR(LM36274_BOOST),
113 	LM363X_REGULATOR(LM36274_LDO_POS),
114 	LM363X_REGULATOR(LM36274_LDO_NEG),
115 	{
116 		.name          = "lm36274-leds",
117 		.id            = LM36274,
118 		.of_compatible = "ti,lm36274-backlight",
119 	},
120 };
121 
122 #define TI_LMU_DATA(chip, max_reg)		\
123 static const struct ti_lmu_data chip##_data =	\
124 {						\
125 	.cells = chip##_devices,		\
126 	.num_cells = ARRAY_SIZE(chip##_devices),\
127 	.max_register = max_reg,		\
128 }						\
129 
130 TI_LMU_DATA(lm3631, LM3631_MAX_REG);
131 TI_LMU_DATA(lm3632, LM3632_MAX_REG);
132 TI_LMU_DATA(lm3633, LM3633_MAX_REG);
133 TI_LMU_DATA(lm3695, LM3695_MAX_REG);
134 TI_LMU_DATA(lm36274, LM36274_MAX_REG);
135 
136 static int ti_lmu_probe(struct i2c_client *cl, const struct i2c_device_id *id)
137 {
138 	struct device *dev = &cl->dev;
139 	const struct ti_lmu_data *data;
140 	struct regmap_config regmap_cfg;
141 	struct ti_lmu *lmu;
142 	int ret;
143 
144 	/*
145 	 * Get device specific data from of_match table.
146 	 * This data is defined by using TI_LMU_DATA() macro.
147 	 */
148 	data = of_device_get_match_data(dev);
149 	if (!data)
150 		return -ENODEV;
151 
152 	lmu = devm_kzalloc(dev, sizeof(*lmu), GFP_KERNEL);
153 	if (!lmu)
154 		return -ENOMEM;
155 
156 	lmu->dev = &cl->dev;
157 
158 	/* Setup regmap */
159 	memset(&regmap_cfg, 0, sizeof(struct regmap_config));
160 	regmap_cfg.reg_bits = 8;
161 	regmap_cfg.val_bits = 8;
162 	regmap_cfg.name = id->name;
163 	regmap_cfg.max_register = data->max_register;
164 
165 	lmu->regmap = devm_regmap_init_i2c(cl, &regmap_cfg);
166 	if (IS_ERR(lmu->regmap))
167 		return PTR_ERR(lmu->regmap);
168 
169 	/* HW enable pin control and additional power up sequence if required */
170 	lmu->en_gpio = devm_gpiod_get_optional(dev, "enable", GPIOD_OUT_HIGH);
171 	if (IS_ERR(lmu->en_gpio)) {
172 		ret = PTR_ERR(lmu->en_gpio);
173 		dev_err(dev, "Can not request enable GPIO: %d\n", ret);
174 		return ret;
175 	}
176 
177 	ret = ti_lmu_enable_hw(lmu, id->driver_data);
178 	if (ret)
179 		return ret;
180 
181 	ret = devm_add_action_or_reset(dev, ti_lmu_disable_hw, lmu);
182 	if (ret)
183 		return ret;
184 
185 	/*
186 	 * Fault circuit(open/short) can be detected by ti-lmu-fault-monitor.
187 	 * After fault detection is done, some devices should re-initialize
188 	 * configuration. The notifier enables such kind of handling.
189 	 */
190 	BLOCKING_INIT_NOTIFIER_HEAD(&lmu->notifier);
191 
192 	i2c_set_clientdata(cl, lmu);
193 
194 	return devm_mfd_add_devices(lmu->dev, 0, data->cells,
195 				    data->num_cells, NULL, 0, NULL);
196 }
197 
198 static const struct of_device_id ti_lmu_of_match[] = {
199 	{ .compatible = "ti,lm3631", .data = &lm3631_data },
200 	{ .compatible = "ti,lm3632", .data = &lm3632_data },
201 	{ .compatible = "ti,lm3633", .data = &lm3633_data },
202 	{ .compatible = "ti,lm3695", .data = &lm3695_data },
203 	{ .compatible = "ti,lm36274", .data = &lm36274_data },
204 	{ }
205 };
206 MODULE_DEVICE_TABLE(of, ti_lmu_of_match);
207 
208 static const struct i2c_device_id ti_lmu_ids[] = {
209 	{ "lm3631", LM3631 },
210 	{ "lm3632", LM3632 },
211 	{ "lm3633", LM3633 },
212 	{ "lm3695", LM3695 },
213 	{ "lm36274", LM36274 },
214 	{ }
215 };
216 MODULE_DEVICE_TABLE(i2c, ti_lmu_ids);
217 
218 static struct i2c_driver ti_lmu_driver = {
219 	.probe = ti_lmu_probe,
220 	.driver = {
221 		.name = "ti-lmu",
222 		.of_match_table = ti_lmu_of_match,
223 	},
224 	.id_table = ti_lmu_ids,
225 };
226 
227 module_i2c_driver(ti_lmu_driver);
228 
229 MODULE_DESCRIPTION("TI LMU MFD Core Driver");
230 MODULE_AUTHOR("Milo Kim");
231 MODULE_LICENSE("GPL v2");
232