xref: /openbmc/linux/drivers/memory/Kconfig (revision 7b43b8fd)
1# SPDX-License-Identifier: GPL-2.0-only
2#
3# Memory devices
4#
5
6menuconfig MEMORY
7	bool "Memory Controller drivers"
8
9if MEMORY
10
11config DDR
12	bool
13	help
14	  Data from JEDEC specs for DDR SDRAM memories,
15	  particularly the AC timing parameters and addressing
16	  information. This data is useful for drivers handling
17	  DDR SDRAM controllers.
18
19config ARM_PL172_MPMC
20	tristate "ARM PL172 MPMC driver"
21	depends on ARM_AMBA && OF
22	help
23	  This selects the ARM PrimeCell PL172 MultiPort Memory Controller.
24	  If you have an embedded system with an AMBA bus and a PL172
25	  controller, say Y or M here.
26
27config ATMEL_SDRAMC
28	bool "Atmel (Multi-port DDR-)SDRAM Controller"
29	default y
30	depends on ARCH_AT91 && OF
31	help
32	  This driver is for Atmel SDRAM Controller or Atmel Multi-port
33	  DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs.
34	  Starting with the at91sam9g45, this controller supports SDR, DDR and
35	  LP-DDR memories.
36
37config ATMEL_EBI
38	bool "Atmel EBI driver"
39	default y
40	depends on ARCH_AT91 && OF
41	select MFD_SYSCON
42	select MFD_ATMEL_SMC
43	help
44	  Driver for Atmel EBI controller.
45	  Used to configure the EBI (external bus interface) when the device-
46	  tree is used. This bus supports NANDs, external ethernet controller,
47	  SRAMs, ATA devices, etc.
48
49config TI_AEMIF
50	tristate "Texas Instruments AEMIF driver"
51	depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF
52	help
53	  This driver is for the AEMIF module available in Texas Instruments
54	  SoCs. AEMIF stands for Asynchronous External Memory Interface and
55	  is intended to provide a glue-less interface to a variety of
56	  asynchronuous memory devices like ASRAM, NOR and NAND memory. A total
57	  of 256M bytes of any of these memories can be accessed at a given
58	  time via four chip selects with 64M byte access per chip select.
59
60config TI_EMIF
61	tristate "Texas Instruments EMIF driver"
62	depends on ARCH_OMAP2PLUS
63	select DDR
64	help
65	  This driver is for the EMIF module available in Texas Instruments
66	  SoCs. EMIF is an SDRAM controller that, based on its revision,
67	  supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
68	  This driver takes care of only LPDDR2 memories presently. The
69	  functions of the driver includes re-configuring AC timing
70	  parameters and other settings during frequency, voltage and
71	  temperature changes
72
73config OMAP_GPMC
74	bool
75	select GPIOLIB
76	help
77	  This driver is for the General Purpose Memory Controller (GPMC)
78	  present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows
79	  interfacing to a variety of asynchronous as well as synchronous
80	  memory drives like NOR, NAND, OneNAND, SRAM.
81
82config OMAP_GPMC_DEBUG
83	bool "Enable GPMC debug output and skip reset of GPMC during init"
84	depends on OMAP_GPMC
85	help
86	  Enables verbose debugging mostly to decode the bootloader provided
87	  timings. To preserve the bootloader provided timings, the reset
88	  of GPMC is skipped during init. Enable this during development to
89	  configure devices connected to the GPMC bus.
90
91	  NOTE: In addition to matching the register setup with the bootloader
92	  you also need to match the GPMC FCLK frequency used by the
93	  bootloader or else the GPMC timings won't be identical with the
94	  bootloader timings.
95
96config TI_EMIF_SRAM
97	tristate "Texas Instruments EMIF SRAM driver"
98	depends on (SOC_AM33XX || SOC_AM43XX) && SRAM
99	help
100	  This driver is for the EMIF module available on Texas Instruments
101	  AM33XX and AM43XX SoCs and is required for PM. Certain parts of
102	  the EMIF PM code must run from on-chip SRAM late in the suspend
103	  sequence so this driver provides several relocatable PM functions
104	  for the SoC PM code to use.
105
106config MVEBU_DEVBUS
107	bool "Marvell EBU Device Bus Controller"
108	default y
109	depends on PLAT_ORION && OF
110	help
111	  This driver is for the Device Bus controller available in some
112	  Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and
113	  Armada 370 and Armada XP. This controller allows to handle flash
114	  devices such as NOR, NAND, SRAM, and FPGA.
115
116config FSL_CORENET_CF
117	tristate "Freescale CoreNet Error Reporting"
118	depends on FSL_SOC_BOOKE
119	help
120	  Say Y for reporting of errors from the Freescale CoreNet
121	  Coherency Fabric.  Errors reported include accesses to
122	  physical addresses that mapped by no local access window
123	  (LAW) or an invalid LAW, as well as bad cache state that
124	  represents a coherency violation.
125
126config FSL_IFC
127	bool
128	depends on FSL_SOC || ARCH_LAYERSCAPE || SOC_LS1021A || COMPILE_TEST
129	depends on HAS_IOMEM
130
131config JZ4780_NEMC
132	bool "Ingenic JZ4780 SoC NEMC driver"
133	default y
134	depends on MACH_JZ4780 || COMPILE_TEST
135	depends on HAS_IOMEM && OF
136	help
137	  This driver is for the NAND/External Memory Controller (NEMC) in
138	  the Ingenic JZ4780. This controller is used to handle external
139	  memory devices such as NAND and SRAM.
140
141config MTK_SMI
142	bool
143	depends on ARCH_MEDIATEK || COMPILE_TEST
144	help
145	  This driver is for the Memory Controller module in MediaTek SoCs,
146	  mainly help enable/disable iommu and control the power domain and
147	  clocks for each local arbiter.
148
149config DA8XX_DDRCTL
150	bool "Texas Instruments da8xx DDR2/mDDR driver"
151	depends on ARCH_DAVINCI_DA8XX
152	help
153	  This driver is for the DDR2/mDDR Memory Controller present on
154	  Texas Instruments da8xx SoCs. It's used to tweak various memory
155	  controller configuration options.
156
157config PL353_SMC
158	tristate "ARM PL35X Static Memory Controller(SMC) driver"
159	default y
160	depends on ARM
161	depends on ARM_AMBA
162	help
163	  This driver is for the ARM PL351/PL353 Static Memory
164	  Controller(SMC) module.
165
166source "drivers/memory/samsung/Kconfig"
167source "drivers/memory/tegra/Kconfig"
168
169endif
170