1# 2# Memory devices 3# 4 5menuconfig MEMORY 6 bool "Memory Controller drivers" 7 8if MEMORY 9 10config ARM_PL172_MPMC 11 tristate "ARM PL172 MPMC driver" 12 depends on ARM_AMBA && OF 13 help 14 This selects the ARM PrimeCell PL172 MultiPort Memory Controller. 15 If you have an embedded system with an AMBA bus and a PL172 16 controller, say Y or M here. 17 18config ATMEL_SDRAMC 19 bool "Atmel (Multi-port DDR-)SDRAM Controller" 20 default y 21 depends on ARCH_AT91 && OF 22 help 23 This driver is for Atmel SDRAM Controller or Atmel Multi-port 24 DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs. 25 Starting with the at91sam9g45, this controller supports SDR, DDR and 26 LP-DDR memories. 27 28config ATMEL_EBI 29 bool "Atmel EBI driver" 30 default y 31 depends on ARCH_AT91 && OF 32 select MFD_SYSCON 33 help 34 Driver for Atmel EBI controller. 35 Used to configure the EBI (external bus interface) when the device- 36 tree is used. This bus supports NANDs, external ethernet controller, 37 SRAMs, ATA devices, etc. 38 39config TI_AEMIF 40 tristate "Texas Instruments AEMIF driver" 41 depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF 42 help 43 This driver is for the AEMIF module available in Texas Instruments 44 SoCs. AEMIF stands for Asynchronous External Memory Interface and 45 is intended to provide a glue-less interface to a variety of 46 asynchronuous memory devices like ASRAM, NOR and NAND memory. A total 47 of 256M bytes of any of these memories can be accessed at a given 48 time via four chip selects with 64M byte access per chip select. 49 50config TI_EMIF 51 tristate "Texas Instruments EMIF driver" 52 depends on ARCH_OMAP2PLUS 53 select DDR 54 help 55 This driver is for the EMIF module available in Texas Instruments 56 SoCs. EMIF is an SDRAM controller that, based on its revision, 57 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols. 58 This driver takes care of only LPDDR2 memories presently. The 59 functions of the driver includes re-configuring AC timing 60 parameters and other settings during frequency, voltage and 61 temperature changes 62 63config OMAP_GPMC 64 bool 65 select GPIOLIB 66 help 67 This driver is for the General Purpose Memory Controller (GPMC) 68 present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows 69 interfacing to a variety of asynchronous as well as synchronous 70 memory drives like NOR, NAND, OneNAND, SRAM. 71 72config OMAP_GPMC_DEBUG 73 bool "Enable GPMC debug output and skip reset of GPMC during init" 74 depends on OMAP_GPMC 75 help 76 Enables verbose debugging mostly to decode the bootloader provided 77 timings. To preserve the bootloader provided timings, the reset 78 of GPMC is skipped during init. Enable this during development to 79 configure devices connected to the GPMC bus. 80 81 NOTE: In addition to matching the register setup with the bootloader 82 you also need to match the GPMC FCLK frequency used by the 83 bootloader or else the GPMC timings won't be identical with the 84 bootloader timings. 85 86config MVEBU_DEVBUS 87 bool "Marvell EBU Device Bus Controller" 88 default y 89 depends on PLAT_ORION && OF 90 help 91 This driver is for the Device Bus controller available in some 92 Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and 93 Armada 370 and Armada XP. This controller allows to handle flash 94 devices such as NOR, NAND, SRAM, and FPGA. 95 96config TEGRA20_MC 97 bool "Tegra20 Memory Controller(MC) driver" 98 default y 99 depends on ARCH_TEGRA_2x_SOC 100 help 101 This driver is for the Memory Controller(MC) module available 102 in Tegra20 SoCs, mainly for a address translation fault 103 analysis, especially for IOMMU/GART(Graphics Address 104 Relocation Table) module. 105 106config FSL_CORENET_CF 107 tristate "Freescale CoreNet Error Reporting" 108 depends on FSL_SOC_BOOKE 109 help 110 Say Y for reporting of errors from the Freescale CoreNet 111 Coherency Fabric. Errors reported include accesses to 112 physical addresses that mapped by no local access window 113 (LAW) or an invalid LAW, as well as bad cache state that 114 represents a coherency violation. 115 116config FSL_IFC 117 bool 118 depends on FSL_SOC 119 120config JZ4780_NEMC 121 bool "Ingenic JZ4780 SoC NEMC driver" 122 default y 123 depends on MACH_JZ4780 124 help 125 This driver is for the NAND/External Memory Controller (NEMC) in 126 the Ingenic JZ4780. This controller is used to handle external 127 memory devices such as NAND and SRAM. 128 129config MTK_SMI 130 bool 131 depends on ARCH_MEDIATEK || COMPILE_TEST 132 help 133 This driver is for the Memory Controller module in MediaTek SoCs, 134 mainly help enable/disable iommu and control the power domain and 135 clocks for each local arbiter. 136 137source "drivers/memory/samsung/Kconfig" 138source "drivers/memory/tegra/Kconfig" 139 140endif 141