1# 2# Memory devices 3# 4 5menuconfig MEMORY 6 bool "Memory Controller drivers" 7 8if MEMORY 9 10config ARM_PL172_MPMC 11 tristate "ARM PL172 MPMC driver" 12 depends on ARM_AMBA && OF 13 help 14 This selects the ARM PrimeCell PL172 MultiPort Memory Controller. 15 If you have an embedded system with an AMBA bus and a PL172 16 controller, say Y or M here. 17 18config ATMEL_SDRAMC 19 bool "Atmel (Multi-port DDR-)SDRAM Controller" 20 default y 21 depends on ARCH_AT91 && OF 22 help 23 This driver is for Atmel SDRAM Controller or Atmel Multi-port 24 DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs. 25 Starting with the at91sam9g45, this controller supports SDR, DDR and 26 LP-DDR memories. 27 28config ATMEL_EBI 29 bool "Atmel EBI driver" 30 default y 31 depends on ARCH_AT91 && OF 32 select MFD_SYSCON 33 select MFD_ATMEL_SMC 34 help 35 Driver for Atmel EBI controller. 36 Used to configure the EBI (external bus interface) when the device- 37 tree is used. This bus supports NANDs, external ethernet controller, 38 SRAMs, ATA devices, etc. 39 40config TI_AEMIF 41 tristate "Texas Instruments AEMIF driver" 42 depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF 43 help 44 This driver is for the AEMIF module available in Texas Instruments 45 SoCs. AEMIF stands for Asynchronous External Memory Interface and 46 is intended to provide a glue-less interface to a variety of 47 asynchronuous memory devices like ASRAM, NOR and NAND memory. A total 48 of 256M bytes of any of these memories can be accessed at a given 49 time via four chip selects with 64M byte access per chip select. 50 51config TI_EMIF 52 tristate "Texas Instruments EMIF driver" 53 depends on ARCH_OMAP2PLUS 54 select DDR 55 help 56 This driver is for the EMIF module available in Texas Instruments 57 SoCs. EMIF is an SDRAM controller that, based on its revision, 58 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols. 59 This driver takes care of only LPDDR2 memories presently. The 60 functions of the driver includes re-configuring AC timing 61 parameters and other settings during frequency, voltage and 62 temperature changes 63 64config OMAP_GPMC 65 bool 66 select GPIOLIB 67 help 68 This driver is for the General Purpose Memory Controller (GPMC) 69 present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows 70 interfacing to a variety of asynchronous as well as synchronous 71 memory drives like NOR, NAND, OneNAND, SRAM. 72 73config OMAP_GPMC_DEBUG 74 bool "Enable GPMC debug output and skip reset of GPMC during init" 75 depends on OMAP_GPMC 76 help 77 Enables verbose debugging mostly to decode the bootloader provided 78 timings. To preserve the bootloader provided timings, the reset 79 of GPMC is skipped during init. Enable this during development to 80 configure devices connected to the GPMC bus. 81 82 NOTE: In addition to matching the register setup with the bootloader 83 you also need to match the GPMC FCLK frequency used by the 84 bootloader or else the GPMC timings won't be identical with the 85 bootloader timings. 86 87config TI_EMIF_SRAM 88 tristate "Texas Instruments EMIF SRAM driver" 89 depends on (SOC_AM33XX || SOC_AM43XX) && SRAM 90 help 91 This driver is for the EMIF module available on Texas Instruments 92 AM33XX and AM43XX SoCs and is required for PM. Certain parts of 93 the EMIF PM code must run from on-chip SRAM late in the suspend 94 sequence so this driver provides several relocatable PM functions 95 for the SoC PM code to use. 96 97config MVEBU_DEVBUS 98 bool "Marvell EBU Device Bus Controller" 99 default y 100 depends on PLAT_ORION && OF 101 help 102 This driver is for the Device Bus controller available in some 103 Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and 104 Armada 370 and Armada XP. This controller allows to handle flash 105 devices such as NOR, NAND, SRAM, and FPGA. 106 107config TEGRA20_MC 108 bool "Tegra20 Memory Controller(MC) driver" 109 default y 110 depends on ARCH_TEGRA_2x_SOC 111 help 112 This driver is for the Memory Controller(MC) module available 113 in Tegra20 SoCs, mainly for a address translation fault 114 analysis, especially for IOMMU/GART(Graphics Address 115 Relocation Table) module. 116 117config FSL_CORENET_CF 118 tristate "Freescale CoreNet Error Reporting" 119 depends on FSL_SOC_BOOKE 120 help 121 Say Y for reporting of errors from the Freescale CoreNet 122 Coherency Fabric. Errors reported include accesses to 123 physical addresses that mapped by no local access window 124 (LAW) or an invalid LAW, as well as bad cache state that 125 represents a coherency violation. 126 127config FSL_IFC 128 bool 129 depends on FSL_SOC || ARCH_LAYERSCAPE || SOC_LS1021A 130 131config JZ4780_NEMC 132 bool "Ingenic JZ4780 SoC NEMC driver" 133 default y 134 depends on MACH_JZ4780 135 help 136 This driver is for the NAND/External Memory Controller (NEMC) in 137 the Ingenic JZ4780. This controller is used to handle external 138 memory devices such as NAND and SRAM. 139 140config MTK_SMI 141 bool 142 depends on ARCH_MEDIATEK || COMPILE_TEST 143 help 144 This driver is for the Memory Controller module in MediaTek SoCs, 145 mainly help enable/disable iommu and control the power domain and 146 clocks for each local arbiter. 147 148config DA8XX_DDRCTL 149 bool "Texas Instruments da8xx DDR2/mDDR driver" 150 depends on ARCH_DAVINCI_DA8XX 151 help 152 This driver is for the DDR2/mDDR Memory Controller present on 153 Texas Instruments da8xx SoCs. It's used to tweak various memory 154 controller configuration options. 155 156source "drivers/memory/samsung/Kconfig" 157source "drivers/memory/tegra/Kconfig" 158 159endif 160