1# 2# Memory devices 3# 4 5menuconfig MEMORY 6 bool "Memory Controller drivers" 7 8if MEMORY 9 10config ARM_PL172_MPMC 11 tristate "ARM PL172 MPMC driver" 12 depends on ARM_AMBA && OF 13 help 14 This selects the ARM PrimeCell PL172 MultiPort Memory Controller. 15 If you have an embedded system with an AMBA bus and a PL172 16 controller, say Y or M here. 17 18config ATMEL_SDRAMC 19 bool "Atmel (Multi-port DDR-)SDRAM Controller" 20 default y 21 depends on ARCH_AT91 && OF 22 help 23 This driver is for Atmel SDRAM Controller or Atmel Multi-port 24 DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs. 25 Starting with the at91sam9g45, this controller supports SDR, DDR and 26 LP-DDR memories. 27 28config TI_AEMIF 29 tristate "Texas Instruments AEMIF driver" 30 depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF 31 help 32 This driver is for the AEMIF module available in Texas Instruments 33 SoCs. AEMIF stands for Asynchronous External Memory Interface and 34 is intended to provide a glue-less interface to a variety of 35 asynchronuous memory devices like ASRAM, NOR and NAND memory. A total 36 of 256M bytes of any of these memories can be accessed at a given 37 time via four chip selects with 64M byte access per chip select. 38 39config TI_EMIF 40 tristate "Texas Instruments EMIF driver" 41 depends on ARCH_OMAP2PLUS 42 select DDR 43 help 44 This driver is for the EMIF module available in Texas Instruments 45 SoCs. EMIF is an SDRAM controller that, based on its revision, 46 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols. 47 This driver takes care of only LPDDR2 memories presently. The 48 functions of the driver includes re-configuring AC timing 49 parameters and other settings during frequency, voltage and 50 temperature changes 51 52config OMAP_GPMC 53 bool 54 help 55 This driver is for the General Purpose Memory Controller (GPMC) 56 present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows 57 interfacing to a variety of asynchronous as well as synchronous 58 memory drives like NOR, NAND, OneNAND, SRAM. 59 60config OMAP_GPMC_DEBUG 61 bool "Enable GPMC debug output and skip reset of GPMC during init" 62 depends on OMAP_GPMC 63 help 64 Enables verbose debugging mostly to decode the bootloader provided 65 timings. To preserve the bootloader provided timings, the reset 66 of GPMC is skipped during init. Enable this during development to 67 configure devices connected to the GPMC bus. 68 69 NOTE: In addition to matching the register setup with the bootloader 70 you also need to match the GPMC FCLK frequency used by the 71 bootloader or else the GPMC timings won't be identical with the 72 bootloader timings. 73 74config MVEBU_DEVBUS 75 bool "Marvell EBU Device Bus Controller" 76 default y 77 depends on PLAT_ORION && OF 78 help 79 This driver is for the Device Bus controller available in some 80 Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and 81 Armada 370 and Armada XP. This controller allows to handle flash 82 devices such as NOR, NAND, SRAM, and FPGA. 83 84config TEGRA20_MC 85 bool "Tegra20 Memory Controller(MC) driver" 86 default y 87 depends on ARCH_TEGRA_2x_SOC 88 help 89 This driver is for the Memory Controller(MC) module available 90 in Tegra20 SoCs, mainly for a address translation fault 91 analysis, especially for IOMMU/GART(Graphics Address 92 Relocation Table) module. 93 94config FSL_CORENET_CF 95 tristate "Freescale CoreNet Error Reporting" 96 depends on FSL_SOC_BOOKE 97 help 98 Say Y for reporting of errors from the Freescale CoreNet 99 Coherency Fabric. Errors reported include accesses to 100 physical addresses that mapped by no local access window 101 (LAW) or an invalid LAW, as well as bad cache state that 102 represents a coherency violation. 103 104config FSL_IFC 105 bool 106 depends on FSL_SOC 107 108config JZ4780_NEMC 109 bool "Ingenic JZ4780 SoC NEMC driver" 110 default y 111 depends on MACH_JZ4780 112 help 113 This driver is for the NAND/External Memory Controller (NEMC) in 114 the Ingenic JZ4780. This controller is used to handle external 115 memory devices such as NAND and SRAM. 116 117config MTK_SMI 118 bool 119 depends on ARCH_MEDIATEK || COMPILE_TEST 120 help 121 This driver is for the Memory Controller module in MediaTek SoCs, 122 mainly help enable/disable iommu and control the power domain and 123 clocks for each local arbiter. 124 125source "drivers/memory/tegra/Kconfig" 126 127endif 128