xref: /openbmc/linux/drivers/memory/Kconfig (revision 44f57d78)
1# SPDX-License-Identifier: GPL-2.0-only
2#
3# Memory devices
4#
5
6menuconfig MEMORY
7	bool "Memory Controller drivers"
8
9if MEMORY
10
11config ARM_PL172_MPMC
12	tristate "ARM PL172 MPMC driver"
13	depends on ARM_AMBA && OF
14	help
15	  This selects the ARM PrimeCell PL172 MultiPort Memory Controller.
16	  If you have an embedded system with an AMBA bus and a PL172
17	  controller, say Y or M here.
18
19config ATMEL_SDRAMC
20	bool "Atmel (Multi-port DDR-)SDRAM Controller"
21	default y
22	depends on ARCH_AT91 && OF
23	help
24	  This driver is for Atmel SDRAM Controller or Atmel Multi-port
25	  DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs.
26	  Starting with the at91sam9g45, this controller supports SDR, DDR and
27	  LP-DDR memories.
28
29config ATMEL_EBI
30	bool "Atmel EBI driver"
31	default y
32	depends on ARCH_AT91 && OF
33	select MFD_SYSCON
34	select MFD_ATMEL_SMC
35	help
36	  Driver for Atmel EBI controller.
37	  Used to configure the EBI (external bus interface) when the device-
38	  tree is used. This bus supports NANDs, external ethernet controller,
39	  SRAMs, ATA devices, etc.
40
41config TI_AEMIF
42	tristate "Texas Instruments AEMIF driver"
43	depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF
44	help
45	  This driver is for the AEMIF module available in Texas Instruments
46	  SoCs. AEMIF stands for Asynchronous External Memory Interface and
47	  is intended to provide a glue-less interface to a variety of
48	  asynchronuous memory devices like ASRAM, NOR and NAND memory. A total
49	  of 256M bytes of any of these memories can be accessed at a given
50	  time via four chip selects with 64M byte access per chip select.
51
52config TI_EMIF
53	tristate "Texas Instruments EMIF driver"
54	depends on ARCH_OMAP2PLUS
55	select DDR
56	help
57	  This driver is for the EMIF module available in Texas Instruments
58	  SoCs. EMIF is an SDRAM controller that, based on its revision,
59	  supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
60	  This driver takes care of only LPDDR2 memories presently. The
61	  functions of the driver includes re-configuring AC timing
62	  parameters and other settings during frequency, voltage and
63	  temperature changes
64
65config OMAP_GPMC
66	bool
67	select GPIOLIB
68	help
69	  This driver is for the General Purpose Memory Controller (GPMC)
70	  present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows
71	  interfacing to a variety of asynchronous as well as synchronous
72	  memory drives like NOR, NAND, OneNAND, SRAM.
73
74config OMAP_GPMC_DEBUG
75	bool "Enable GPMC debug output and skip reset of GPMC during init"
76	depends on OMAP_GPMC
77	help
78	  Enables verbose debugging mostly to decode the bootloader provided
79	  timings. To preserve the bootloader provided timings, the reset
80	  of GPMC is skipped during init. Enable this during development to
81	  configure devices connected to the GPMC bus.
82
83	  NOTE: In addition to matching the register setup with the bootloader
84	  you also need to match the GPMC FCLK frequency used by the
85	  bootloader or else the GPMC timings won't be identical with the
86	  bootloader timings.
87
88config TI_EMIF_SRAM
89	tristate "Texas Instruments EMIF SRAM driver"
90	depends on (SOC_AM33XX || SOC_AM43XX) && SRAM
91	help
92	  This driver is for the EMIF module available on Texas Instruments
93	  AM33XX and AM43XX SoCs and is required for PM. Certain parts of
94	  the EMIF PM code must run from on-chip SRAM late in the suspend
95	  sequence so this driver provides several relocatable PM functions
96	  for the SoC PM code to use.
97
98config MVEBU_DEVBUS
99	bool "Marvell EBU Device Bus Controller"
100	default y
101	depends on PLAT_ORION && OF
102	help
103	  This driver is for the Device Bus controller available in some
104	  Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and
105	  Armada 370 and Armada XP. This controller allows to handle flash
106	  devices such as NOR, NAND, SRAM, and FPGA.
107
108config FSL_CORENET_CF
109	tristate "Freescale CoreNet Error Reporting"
110	depends on FSL_SOC_BOOKE
111	help
112	  Say Y for reporting of errors from the Freescale CoreNet
113	  Coherency Fabric.  Errors reported include accesses to
114	  physical addresses that mapped by no local access window
115	  (LAW) or an invalid LAW, as well as bad cache state that
116	  represents a coherency violation.
117
118config FSL_IFC
119	bool
120	depends on FSL_SOC || ARCH_LAYERSCAPE || SOC_LS1021A || COMPILE_TEST
121	depends on HAS_IOMEM
122
123config JZ4780_NEMC
124	bool "Ingenic JZ4780 SoC NEMC driver"
125	default y
126	depends on MACH_JZ4780 || COMPILE_TEST
127	depends on HAS_IOMEM && OF
128	help
129	  This driver is for the NAND/External Memory Controller (NEMC) in
130	  the Ingenic JZ4780. This controller is used to handle external
131	  memory devices such as NAND and SRAM.
132
133config MTK_SMI
134	bool
135	depends on ARCH_MEDIATEK || COMPILE_TEST
136	help
137	  This driver is for the Memory Controller module in MediaTek SoCs,
138	  mainly help enable/disable iommu and control the power domain and
139	  clocks for each local arbiter.
140
141config DA8XX_DDRCTL
142	bool "Texas Instruments da8xx DDR2/mDDR driver"
143	depends on ARCH_DAVINCI_DA8XX
144	help
145	  This driver is for the DDR2/mDDR Memory Controller present on
146	  Texas Instruments da8xx SoCs. It's used to tweak various memory
147	  controller configuration options.
148
149config PL353_SMC
150	tristate "ARM PL35X Static Memory Controller(SMC) driver"
151	default y
152	depends on ARM
153	depends on ARM_AMBA
154	help
155	  This driver is for the ARM PL351/PL353 Static Memory
156	  Controller(SMC) module.
157
158source "drivers/memory/samsung/Kconfig"
159source "drivers/memory/tegra/Kconfig"
160
161endif
162