1# SPDX-License-Identifier: GPL-2.0-only 2 3comment "Texas Instruments drivers" 4 5# TI VIDEO PORT Helper Modules 6# These will be selected by VPE and VIP 7config VIDEO_TI_VPDMA 8 tristate 9 10config VIDEO_TI_SC 11 tristate 12 13config VIDEO_TI_CSC 14 tristate 15 16# V4L drivers 17 18config VIDEO_TI_CAL 19 tristate "TI CAL (Camera Adaptation Layer) driver" 20 depends on VIDEO_DEV 21 depends on V4L_PLATFORM_DRIVERS 22 select MEDIA_CONTROLLER 23 select VIDEO_V4L2_SUBDEV_API 24 depends on SOC_DRA7XX || ARCH_K3 || COMPILE_TEST 25 select VIDEOBUF2_DMA_CONTIG 26 select V4L2_FWNODE 27 help 28 Support for the TI CAL (Camera Adaptation Layer) block 29 found on DRA72X SoC. 30 In TI Technical Reference Manual this module is referred as 31 Camera Interface Subsystem (CAMSS). 32 33config VIDEO_TI_CAL_MC 34 bool "Media Controller centric mode by default" 35 depends on VIDEO_TI_CAL 36 default n 37 help 38 Enables Media Controller centric mode by default. 39 40 If set, CAL driver will start in Media Controller mode by 41 default. Note that this behavior can be overridden via 42 module parameter 'mc_api'. 43 44# Mem2mem drivers 45 46config VIDEO_TI_VPE 47 tristate "TI VPE (Video Processing Engine) driver" 48 depends on V4L_MEM2MEM_DRIVERS 49 depends on VIDEO_DEV 50 depends on SOC_DRA7XX || COMPILE_TEST 51 select VIDEOBUF2_DMA_CONTIG 52 select V4L2_MEM2MEM_DEV 53 select VIDEO_TI_VPDMA 54 select VIDEO_TI_SC 55 select VIDEO_TI_CSC 56 help 57 Support for the TI VPE(Video Processing Engine) block 58 found on DRA7XX SoC. 59 60config VIDEO_TI_VPE_DEBUG 61 bool "VPE debug messages" 62 depends on VIDEO_TI_VPE 63 help 64 Enable debug messages on VPE driver. 65