1 #ifndef _DRXK_H_
2 #define _DRXK_H_
3 
4 #include <linux/types.h>
5 #include <linux/i2c.h>
6 
7 /**
8  * struct drxk_config - Configure the initial parameters for DRX-K
9  *
10  * @adr:		I2C address of the DRX-K
11  * @parallel_ts:	True means that the device uses parallel TS,
12  * 			Serial otherwise.
13  * @dynamic_clk:	True means that the clock will be dynamically
14  *			adjusted. Static clock otherwise.
15  * @enable_merr_cfg:	Enable SIO_PDR_PERR_CFG/SIO_PDR_MVAL_CFG.
16  * @single_master:	Device is on the single master mode
17  * @no_i2c_bridge:	Don't switch the I2C bridge to talk with tuner
18  * @antenna_gpio:	GPIO bit used to control the antenna
19  * @antenna_dvbt:	GPIO bit for changing antenna to DVB-C. A value of 1
20  *			means that 1=DVBC, 0 = DVBT. Zero means the opposite.
21  * @mpeg_out_clk_strength: DRXK Mpeg output clock drive strength.
22  * @microcode_name:	Name of the firmware file with the microcode
23  * @qam_demod_parameter_count:	The number of parameters used for the command
24  *				to set the demodulator parameters. All
25  *				firmwares are using the 2-parameter commmand.
26  *				An exception is the "drxk_a3.mc" firmware,
27  *				which uses the 4-parameter command.
28  *				A value of 0 (default) or lower indicates that
29  *				the correct number of parameters will be
30  *				automatically detected.
31  *
32  * On the *_gpio vars, bit 0 is UIO-1, bit 1 is UIO-2 and bit 2 is
33  * UIO-3.
34  */
35 struct drxk_config {
36 	u8	adr;
37 	bool	single_master;
38 	bool	no_i2c_bridge;
39 	bool	parallel_ts;
40 	bool	dynamic_clk;
41 	bool	enable_merr_cfg;
42 
43 	bool	antenna_dvbt;
44 	u16	antenna_gpio;
45 
46 	u8	mpeg_out_clk_strength;
47 	int	chunk_size;
48 
49 	const char	*microcode_name;
50 	int		 qam_demod_parameter_count;
51 };
52 
53 #if IS_REACHABLE(CONFIG_DVB_DRXK)
54 extern struct dvb_frontend *drxk_attach(const struct drxk_config *config,
55 					struct i2c_adapter *i2c);
56 #else
57 static inline struct dvb_frontend *drxk_attach(const struct drxk_config *config,
58 					struct i2c_adapter *i2c)
59 {
60         printk(KERN_WARNING "%s: driver disabled by Kconfig\n", __func__);
61         return NULL;
62 }
63 #endif
64 
65 #endif
66