1# 2# Industrial I/O standalone triggers 3# 4# When adding new entries keep the list in alphabetical order 5 6menu "Triggers - standalone" 7 8config IIO_HRTIMER_TRIGGER 9 tristate "High resolution timer trigger" 10 depends on IIO_SW_TRIGGER 11 help 12 Provides a frequency based IIO trigger using high resolution 13 timers as interrupt source. 14 15 To compile this driver as a module, choose M here: the 16 module will be called iio-trig-hrtimer. 17 18config IIO_INTERRUPT_TRIGGER 19 tristate "Generic interrupt trigger" 20 help 21 Provides support for using an interrupt of any type as an IIO 22 trigger. This may be provided by a gpio driver for example. 23 24 To compile this driver as a module, choose M here: the 25 module will be called iio-trig-interrupt. 26 27config IIO_STM32_TIMER_TRIGGER 28 tristate "STM32 Timer Trigger" 29 depends on (ARCH_STM32 && OF && MFD_STM32_TIMERS) || COMPILE_TEST 30 help 31 Select this option to enable STM32 Timer Trigger 32 33 To compile this driver as a module, choose M here: the 34 module will be called stm32-timer-trigger. 35 36config IIO_TIGHTLOOP_TRIGGER 37 tristate "A kthread based hammering loop trigger" 38 depends on IIO_SW_TRIGGER 39 help 40 An experimental trigger, used to allow sensors to be sampled as fast 41 as possible under the limitations of whatever else is going on. 42 Uses a tight loop in a kthread. Will only work with lower half only 43 trigger consumers. 44 45 To compile this driver as a module, choose M here: the 46 module will be called iio-trig-loop. 47 48config IIO_SYSFS_TRIGGER 49 tristate "SYSFS trigger" 50 depends on SYSFS 51 select IRQ_WORK 52 help 53 Provides support for using SYSFS entries as IIO triggers. 54 If unsure, say N (but it's safe to say "Y"). 55 56 To compile this driver as a module, choose M here: the 57 module will be called iio-trig-sysfs. 58 59endmenu 60