xref: /openbmc/linux/drivers/iio/adc/ad7606.h (revision 023e4163)
1 /* SPDX-License-Identifier: GPL-2.0 */
2 /*
3  * AD7606 ADC driver
4  *
5  * Copyright 2011 Analog Devices Inc.
6  */
7 
8 #ifndef IIO_ADC_AD7606_H_
9 #define IIO_ADC_AD7606_H_
10 
11 /**
12  * struct ad7606_chip_info - chip specific information
13  * @channels:		channel specification
14  * @num_channels:	number of channels
15  * @has_oversampling:   whether the device has oversampling support
16  */
17 struct ad7606_chip_info {
18 	const struct iio_chan_spec	*channels;
19 	unsigned int			num_channels;
20 	bool				has_oversampling;
21 };
22 
23 /**
24  * struct ad7606_state - driver instance specific data
25  * @dev		pointer to kernel device
26  * @chip_info		entry in the table of chips that describes this device
27  * @reg		regulator info for the the power supply of the device
28  * @bops		bus operations (SPI or parallel)
29  * @range		voltage range selection, selects which scale to apply
30  * @oversampling	oversampling selection
31  * @base_address	address from where to read data in parallel operation
32  * @lock		protect sensor state from concurrent accesses to GPIOs
33  * @gpio_convst	GPIO descriptor for conversion start signal (CONVST)
34  * @gpio_reset		GPIO descriptor for device hard-reset
35  * @gpio_range		GPIO descriptor for range selection
36  * @gpio_standby	GPIO descriptor for stand-by signal (STBY),
37  *			controls power-down mode of device
38  * @gpio_frstdata	GPIO descriptor for reading from device when data
39  *			is being read on the first channel
40  * @gpio_os		GPIO descriptors to control oversampling on the device
41  * @complete		completion to indicate end of conversion
42  * @trig		The IIO trigger associated with the device.
43  * @data		buffer for reading data from the device
44  */
45 struct ad7606_state {
46 	struct device			*dev;
47 	const struct ad7606_chip_info	*chip_info;
48 	struct regulator		*reg;
49 	const struct ad7606_bus_ops	*bops;
50 	unsigned int			range;
51 	unsigned int			oversampling;
52 	void __iomem			*base_address;
53 
54 	struct mutex			lock; /* protect sensor state */
55 	struct gpio_desc		*gpio_convst;
56 	struct gpio_desc		*gpio_reset;
57 	struct gpio_desc		*gpio_range;
58 	struct gpio_desc		*gpio_standby;
59 	struct gpio_desc		*gpio_frstdata;
60 	struct gpio_descs		*gpio_os;
61 	struct iio_trigger		*trig;
62 	struct completion		completion;
63 
64 	/*
65 	 * DMA (thus cache coherency maintenance) requires the
66 	 * transfer buffers to live in their own cache lines.
67 	 * 8 * 16-bit samples + 64-bit timestamp
68 	 */
69 	unsigned short			data[12] ____cacheline_aligned;
70 };
71 
72 /**
73  * struct ad7606_bus_ops - driver bus operations
74  * @read_block		function pointer for reading blocks of data
75  */
76 struct ad7606_bus_ops {
77 	/* more methods added in future? */
78 	int (*read_block)(struct device *dev, int num, void *data);
79 };
80 
81 int ad7606_probe(struct device *dev, int irq, void __iomem *base_address,
82 		 const char *name, unsigned int id,
83 		 const struct ad7606_bus_ops *bops);
84 
85 enum ad7606_supported_device_ids {
86 	ID_AD7605_4,
87 	ID_AD7606_8,
88 	ID_AD7606_6,
89 	ID_AD7606_4
90 };
91 
92 #ifdef CONFIG_PM_SLEEP
93 extern const struct dev_pm_ops ad7606_pm_ops;
94 #define AD7606_PM_OPS (&ad7606_pm_ops)
95 #else
96 #define AD7606_PM_OPS NULL
97 #endif
98 
99 #endif /* IIO_ADC_AD7606_H_ */
100