1# 2# Multiplexer I2C chip drivers configuration 3# 4 5menu "Multiplexer I2C Chip support" 6 depends on I2C_MUX 7 8config I2C_ARB_GPIO_CHALLENGE 9 tristate "GPIO-based I2C arbitration" 10 depends on GPIOLIB || COMPILE_TEST 11 depends on OF 12 help 13 If you say yes to this option, support will be included for an 14 I2C multimaster arbitration scheme using GPIOs and a challenge & 15 response mechanism where masters have to claim the bus by asserting 16 a GPIO. 17 18 This driver can also be built as a module. If so, the module 19 will be called i2c-arb-gpio-challenge. 20 21config I2C_MUX_GPIO 22 tristate "GPIO-based I2C multiplexer" 23 depends on GPIOLIB 24 help 25 If you say yes to this option, support will be included for a 26 GPIO based I2C multiplexer. This driver provides access to 27 I2C busses connected through a MUX, which is controlled 28 through GPIO pins. 29 30 This driver can also be built as a module. If so, the module 31 will be called i2c-mux-gpio. 32 33config I2C_MUX_PCA9541 34 tristate "NXP PCA9541 I2C Master Selector" 35 help 36 If you say yes here you get support for the NXP PCA9541 37 I2C Master Selector. 38 39 This driver can also be built as a module. If so, the module 40 will be called i2c-mux-pca9541. 41 42config I2C_MUX_PCA954x 43 tristate "Philips PCA954x I2C Mux/switches" 44 depends on GPIOLIB || COMPILE_TEST 45 help 46 If you say yes here you get support for the Philips PCA954x 47 I2C mux/switch devices. 48 49 This driver can also be built as a module. If so, the module 50 will be called i2c-mux-pca954x. 51 52config I2C_MUX_PINCTRL 53 tristate "pinctrl-based I2C multiplexer" 54 depends on PINCTRL 55 help 56 If you say yes to this option, support will be included for an I2C 57 multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing. 58 This is useful for SoCs whose I2C module's signals can be routed to 59 different sets of pins at run-time. 60 61 This driver can also be built as a module. If so, the module will be 62 called pinctrl-i2cmux. 63 64config I2C_MUX_REG 65 tristate "Register-based I2C multiplexer" 66 help 67 If you say yes to this option, support will be included for a 68 register based I2C multiplexer. This driver provides access to 69 I2C busses connected through a MUX, which is controlled 70 by a single register. 71 72 This driver can also be built as a module. If so, the module 73 will be called i2c-mux-reg. 74 75endmenu 76