1 // SPDX-License-Identifier: GPL-2.0 2 /* 3 * Synopsys DesignWare I2C adapter driver (slave only). 4 * 5 * Based on the Synopsys DesignWare I2C adapter driver (master). 6 * 7 * Copyright (C) 2016 Synopsys Inc. 8 */ 9 #include <linux/delay.h> 10 #include <linux/err.h> 11 #include <linux/errno.h> 12 #include <linux/i2c.h> 13 #include <linux/interrupt.h> 14 #include <linux/io.h> 15 #include <linux/module.h> 16 #include <linux/pm_runtime.h> 17 #include <linux/regmap.h> 18 19 #include "i2c-designware-core.h" 20 21 static void i2c_dw_configure_fifo_slave(struct dw_i2c_dev *dev) 22 { 23 /* Configure Tx/Rx FIFO threshold levels. */ 24 regmap_write(dev->map, DW_IC_TX_TL, 0); 25 regmap_write(dev->map, DW_IC_RX_TL, 0); 26 27 /* Configure the I2C slave. */ 28 regmap_write(dev->map, DW_IC_CON, dev->slave_cfg); 29 regmap_write(dev->map, DW_IC_INTR_MASK, DW_IC_INTR_SLAVE_MASK); 30 } 31 32 /** 33 * i2c_dw_init_slave() - Initialize the designware i2c slave hardware 34 * @dev: device private data 35 * 36 * This function configures and enables the I2C in slave mode. 37 * This function is called during I2C init function, and in case of timeout at 38 * run time. 39 */ 40 static int i2c_dw_init_slave(struct dw_i2c_dev *dev) 41 { 42 int ret; 43 44 ret = i2c_dw_acquire_lock(dev); 45 if (ret) 46 return ret; 47 48 /* Disable the adapter. */ 49 __i2c_dw_disable(dev); 50 51 /* Write SDA hold time if supported */ 52 if (dev->sda_hold_time) 53 regmap_write(dev->map, DW_IC_SDA_HOLD, dev->sda_hold_time); 54 55 i2c_dw_configure_fifo_slave(dev); 56 i2c_dw_release_lock(dev); 57 58 return 0; 59 } 60 61 static int i2c_dw_reg_slave(struct i2c_client *slave) 62 { 63 struct dw_i2c_dev *dev = i2c_get_adapdata(slave->adapter); 64 65 if (dev->slave) 66 return -EBUSY; 67 if (slave->flags & I2C_CLIENT_TEN) 68 return -EAFNOSUPPORT; 69 pm_runtime_get_sync(dev->dev); 70 71 /* 72 * Set slave address in the IC_SAR register, 73 * the address to which the DW_apb_i2c responds. 74 */ 75 __i2c_dw_disable_nowait(dev); 76 regmap_write(dev->map, DW_IC_SAR, slave->addr); 77 dev->slave = slave; 78 79 __i2c_dw_enable(dev); 80 81 dev->status = 0; 82 83 return 0; 84 } 85 86 static int i2c_dw_unreg_slave(struct i2c_client *slave) 87 { 88 struct dw_i2c_dev *dev = i2c_get_adapdata(slave->adapter); 89 90 regmap_write(dev->map, DW_IC_INTR_MASK, 0); 91 dev->disable(dev); 92 synchronize_irq(dev->irq); 93 dev->slave = NULL; 94 pm_runtime_put(dev->dev); 95 96 return 0; 97 } 98 99 static u32 i2c_dw_read_clear_intrbits_slave(struct dw_i2c_dev *dev) 100 { 101 unsigned int stat, dummy; 102 103 /* 104 * The IC_INTR_STAT register just indicates "enabled" interrupts. 105 * The unmasked raw version of interrupt status bits is available 106 * in the IC_RAW_INTR_STAT register. 107 * 108 * That is, 109 * stat = readl(IC_INTR_STAT); 110 * equals to, 111 * stat = readl(IC_RAW_INTR_STAT) & readl(IC_INTR_MASK); 112 * 113 * The raw version might be useful for debugging purposes. 114 */ 115 regmap_read(dev->map, DW_IC_INTR_STAT, &stat); 116 117 /* 118 * Do not use the IC_CLR_INTR register to clear interrupts, or 119 * you'll miss some interrupts, triggered during the period from 120 * readl(IC_INTR_STAT) to readl(IC_CLR_INTR). 121 * 122 * Instead, use the separately-prepared IC_CLR_* registers. 123 */ 124 if (stat & DW_IC_INTR_TX_ABRT) 125 regmap_read(dev->map, DW_IC_CLR_TX_ABRT, &dummy); 126 if (stat & DW_IC_INTR_RX_UNDER) 127 regmap_read(dev->map, DW_IC_CLR_RX_UNDER, &dummy); 128 if (stat & DW_IC_INTR_RX_OVER) 129 regmap_read(dev->map, DW_IC_CLR_RX_OVER, &dummy); 130 if (stat & DW_IC_INTR_TX_OVER) 131 regmap_read(dev->map, DW_IC_CLR_TX_OVER, &dummy); 132 if (stat & DW_IC_INTR_RX_DONE) 133 regmap_read(dev->map, DW_IC_CLR_RX_DONE, &dummy); 134 if (stat & DW_IC_INTR_ACTIVITY) 135 regmap_read(dev->map, DW_IC_CLR_ACTIVITY, &dummy); 136 if (stat & DW_IC_INTR_STOP_DET) 137 regmap_read(dev->map, DW_IC_CLR_STOP_DET, &dummy); 138 if (stat & DW_IC_INTR_START_DET) 139 regmap_read(dev->map, DW_IC_CLR_START_DET, &dummy); 140 if (stat & DW_IC_INTR_GEN_CALL) 141 regmap_read(dev->map, DW_IC_CLR_GEN_CALL, &dummy); 142 143 return stat; 144 } 145 146 /* 147 * Interrupt service routine. This gets called whenever an I2C slave interrupt 148 * occurs. 149 */ 150 static irqreturn_t i2c_dw_isr_slave(int this_irq, void *dev_id) 151 { 152 struct dw_i2c_dev *dev = dev_id; 153 unsigned int raw_stat, stat, enabled, tmp; 154 u8 val = 0, slave_activity; 155 156 regmap_read(dev->map, DW_IC_ENABLE, &enabled); 157 regmap_read(dev->map, DW_IC_RAW_INTR_STAT, &raw_stat); 158 regmap_read(dev->map, DW_IC_STATUS, &tmp); 159 slave_activity = ((tmp & DW_IC_STATUS_SLAVE_ACTIVITY) >> 6); 160 161 if (!enabled || !(raw_stat & ~DW_IC_INTR_ACTIVITY) || !dev->slave) 162 return IRQ_NONE; 163 164 stat = i2c_dw_read_clear_intrbits_slave(dev); 165 dev_dbg(dev->dev, 166 "%#x STATUS SLAVE_ACTIVITY=%#x : RAW_INTR_STAT=%#x : INTR_STAT=%#x\n", 167 enabled, slave_activity, raw_stat, stat); 168 169 if (stat & DW_IC_INTR_RX_FULL) { 170 if (!(dev->status & STATUS_WRITE_IN_PROGRESS)) { 171 dev->status |= STATUS_WRITE_IN_PROGRESS; 172 dev->status &= ~STATUS_READ_IN_PROGRESS; 173 i2c_slave_event(dev->slave, I2C_SLAVE_WRITE_REQUESTED, 174 &val); 175 } 176 177 do { 178 regmap_read(dev->map, DW_IC_DATA_CMD, &tmp); 179 if (tmp & DW_IC_DATA_CMD_FIRST_DATA_BYTE) 180 i2c_slave_event(dev->slave, 181 I2C_SLAVE_WRITE_REQUESTED, 182 &val); 183 val = tmp; 184 i2c_slave_event(dev->slave, I2C_SLAVE_WRITE_RECEIVED, 185 &val); 186 regmap_read(dev->map, DW_IC_STATUS, &tmp); 187 } while (tmp & DW_IC_STATUS_RFNE); 188 } 189 190 if (stat & DW_IC_INTR_RD_REQ) { 191 if (slave_activity) { 192 regmap_read(dev->map, DW_IC_CLR_RD_REQ, &tmp); 193 194 if (!(dev->status & STATUS_READ_IN_PROGRESS)) { 195 i2c_slave_event(dev->slave, 196 I2C_SLAVE_READ_REQUESTED, 197 &val); 198 dev->status |= STATUS_READ_IN_PROGRESS; 199 dev->status &= ~STATUS_WRITE_IN_PROGRESS; 200 } else { 201 i2c_slave_event(dev->slave, 202 I2C_SLAVE_READ_PROCESSED, 203 &val); 204 } 205 regmap_write(dev->map, DW_IC_DATA_CMD, val); 206 } 207 } 208 209 if (stat & DW_IC_INTR_STOP_DET) 210 i2c_slave_event(dev->slave, I2C_SLAVE_STOP, &val); 211 212 return IRQ_HANDLED; 213 } 214 215 static const struct i2c_algorithm i2c_dw_algo = { 216 .functionality = i2c_dw_func, 217 .reg_slave = i2c_dw_reg_slave, 218 .unreg_slave = i2c_dw_unreg_slave, 219 }; 220 221 void i2c_dw_configure_slave(struct dw_i2c_dev *dev) 222 { 223 dev->functionality = I2C_FUNC_SLAVE; 224 225 dev->slave_cfg = DW_IC_CON_RX_FIFO_FULL_HLD_CTRL | 226 DW_IC_CON_RESTART_EN | DW_IC_CON_STOP_DET_IFADDRESSED; 227 228 dev->mode = DW_IC_SLAVE; 229 } 230 EXPORT_SYMBOL_GPL(i2c_dw_configure_slave); 231 232 int i2c_dw_probe_slave(struct dw_i2c_dev *dev) 233 { 234 struct i2c_adapter *adap = &dev->adapter; 235 int ret; 236 237 dev->init = i2c_dw_init_slave; 238 dev->disable = i2c_dw_disable; 239 240 ret = i2c_dw_init_regmap(dev); 241 if (ret) 242 return ret; 243 244 ret = i2c_dw_set_sda_hold(dev); 245 if (ret) 246 return ret; 247 248 ret = i2c_dw_set_fifo_size(dev); 249 if (ret) 250 return ret; 251 252 ret = dev->init(dev); 253 if (ret) 254 return ret; 255 256 snprintf(adap->name, sizeof(adap->name), 257 "Synopsys DesignWare I2C Slave adapter"); 258 adap->retries = 3; 259 adap->algo = &i2c_dw_algo; 260 adap->dev.parent = dev->dev; 261 i2c_set_adapdata(adap, dev); 262 263 ret = devm_request_irq(dev->dev, dev->irq, i2c_dw_isr_slave, 264 IRQF_SHARED, dev_name(dev->dev), dev); 265 if (ret) { 266 dev_err(dev->dev, "failure requesting irq %i: %d\n", 267 dev->irq, ret); 268 return ret; 269 } 270 271 ret = i2c_add_numbered_adapter(adap); 272 if (ret) 273 dev_err(dev->dev, "failure adding adapter: %d\n", ret); 274 275 return ret; 276 } 277 EXPORT_SYMBOL_GPL(i2c_dw_probe_slave); 278 279 MODULE_AUTHOR("Luis Oliveira <lolivei@synopsys.com>"); 280 MODULE_DESCRIPTION("Synopsys DesignWare I2C bus slave adapter"); 281 MODULE_LICENSE("GPL v2"); 282