1 /* SPDX-License-Identifier: GPL-2.0-only */
2 /* Copyright (c) 2015-2018, The Linux Foundation. All rights reserved.
3  */
4 
5 #ifndef _DPU_HW_PINGPONG_H
6 #define _DPU_HW_PINGPONG_H
7 
8 #include "dpu_hw_catalog.h"
9 #include "dpu_hw_mdss.h"
10 #include "dpu_hw_util.h"
11 #include "dpu_hw_blk.h"
12 
13 #define DITHER_MATRIX_SZ 16
14 
15 struct dpu_hw_pingpong;
16 
17 struct dpu_hw_tear_check {
18 	/*
19 	 * This is ratio of MDP VSYNC clk freq(Hz) to
20 	 * refresh rate divided by no of lines
21 	 */
22 	u32 vsync_count;
23 	u32 sync_cfg_height;
24 	u32 vsync_init_val;
25 	u32 sync_threshold_start;
26 	u32 sync_threshold_continue;
27 	u32 start_pos;
28 	u32 rd_ptr_irq;
29 	u8 hw_vsync_mode;
30 };
31 
32 struct dpu_hw_pp_vsync_info {
33 	u32 rd_ptr_init_val;	/* value of rd pointer at vsync edge */
34 	u32 rd_ptr_frame_count;	/* num frames sent since enabling interface */
35 	u32 rd_ptr_line_count;	/* current line on panel (rd ptr) */
36 	u32 wr_ptr_line_count;	/* current line within pp fifo (wr ptr) */
37 };
38 
39 /**
40  * struct dpu_hw_dither_cfg - dither feature structure
41  * @flags: for customizing operations
42  * @temporal_en: temperal dither enable
43  * @c0_bitdepth: c0 component bit depth
44  * @c1_bitdepth: c1 component bit depth
45  * @c2_bitdepth: c2 component bit depth
46  * @c3_bitdepth: c2 component bit depth
47  * @matrix: dither strength matrix
48  */
49 struct dpu_hw_dither_cfg {
50 	u64 flags;
51 	u32 temporal_en;
52 	u32 c0_bitdepth;
53 	u32 c1_bitdepth;
54 	u32 c2_bitdepth;
55 	u32 c3_bitdepth;
56 	u32 matrix[DITHER_MATRIX_SZ];
57 };
58 
59 /**
60  *
61  * struct dpu_hw_pingpong_ops : Interface to the pingpong Hw driver functions
62  *  Assumption is these functions will be called after clocks are enabled
63  *  @setup_tearcheck : program tear check values
64  *  @enable_tearcheck : enables tear check
65  *  @get_vsync_info : retries timing info of the panel
66  *  @setup_autorefresh : configure and enable the autorefresh config
67  *  @get_autorefresh : retrieve autorefresh config from hardware
68  *  @setup_dither : function to program the dither hw block
69  *  @get_line_count: obtain current vertical line counter
70  */
71 struct dpu_hw_pingpong_ops {
72 	/**
73 	 * enables vysnc generation and sets up init value of
74 	 * read pointer and programs the tear check cofiguration
75 	 */
76 	int (*setup_tearcheck)(struct dpu_hw_pingpong *pp,
77 			struct dpu_hw_tear_check *cfg);
78 
79 	/**
80 	 * enables tear check block
81 	 */
82 	int (*enable_tearcheck)(struct dpu_hw_pingpong *pp,
83 			bool enable);
84 
85 	/**
86 	 * read, modify, write to either set or clear listening to external TE
87 	 * @Return: 1 if TE was originally connected, 0 if not, or -ERROR
88 	 */
89 	int (*connect_external_te)(struct dpu_hw_pingpong *pp,
90 			bool enable_external_te);
91 
92 	/**
93 	 * provides the programmed and current
94 	 * line_count
95 	 */
96 	int (*get_vsync_info)(struct dpu_hw_pingpong *pp,
97 			struct dpu_hw_pp_vsync_info  *info);
98 
99 	/**
100 	 * configure and enable the autorefresh config
101 	 */
102 	void (*setup_autorefresh)(struct dpu_hw_pingpong *pp,
103 				  u32 frame_count, bool enable);
104 
105 	/**
106 	 * retrieve autorefresh config from hardware
107 	 */
108 	bool (*get_autorefresh)(struct dpu_hw_pingpong *pp,
109 				u32 *frame_count);
110 
111 	/**
112 	 * poll until write pointer transmission starts
113 	 * @Return: 0 on success, -ETIMEDOUT on timeout
114 	 */
115 	int (*poll_timeout_wr_ptr)(struct dpu_hw_pingpong *pp, u32 timeout_us);
116 
117 	/**
118 	 * Obtain current vertical line counter
119 	 */
120 	u32 (*get_line_count)(struct dpu_hw_pingpong *pp);
121 
122 	/**
123 	 * Setup dither matix for pingpong block
124 	 */
125 	void (*setup_dither)(struct dpu_hw_pingpong *pp,
126 			struct dpu_hw_dither_cfg *cfg);
127 };
128 
129 struct dpu_hw_pingpong {
130 	struct dpu_hw_blk base;
131 	struct dpu_hw_blk_reg_map hw;
132 
133 	/* pingpong */
134 	enum dpu_pingpong idx;
135 	const struct dpu_pingpong_cfg *caps;
136 	struct dpu_hw_blk *merge_3d;
137 
138 	/* ops */
139 	struct dpu_hw_pingpong_ops ops;
140 };
141 
142 /**
143  * to_dpu_hw_pingpong - convert base object dpu_hw_base to container
144  * @hw: Pointer to base hardware block
145  * return: Pointer to hardware block container
146  */
147 static inline struct dpu_hw_pingpong *to_dpu_hw_pingpong(struct dpu_hw_blk *hw)
148 {
149 	return container_of(hw, struct dpu_hw_pingpong, base);
150 }
151 
152 /**
153  * dpu_hw_pingpong_init - initializes the pingpong driver for the passed
154  *	pingpong idx.
155  * @idx:  Pingpong index for which driver object is required
156  * @addr: Mapped register io address of MDP
157  * @m:    Pointer to mdss catalog data
158  * Returns: Error code or allocated dpu_hw_pingpong context
159  */
160 struct dpu_hw_pingpong *dpu_hw_pingpong_init(enum dpu_pingpong idx,
161 		void __iomem *addr,
162 		const struct dpu_mdss_cfg *m);
163 
164 /**
165  * dpu_hw_pingpong_destroy - destroys pingpong driver context
166  *	should be called to free the context
167  * @pp:   Pointer to PP driver context returned by dpu_hw_pingpong_init
168  */
169 void dpu_hw_pingpong_destroy(struct dpu_hw_pingpong *pp);
170 
171 #endif /*_DPU_HW_PINGPONG_H */
172