xref: /openbmc/linux/drivers/gpio/gpio-xra1403.c (revision 3d40aed8)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * GPIO driver for EXAR XRA1403 16-bit GPIO expander
4  *
5  * Copyright (c) 2017, General Electric Company
6  */
7 
8 #include <linux/bitops.h>
9 #include <linux/gpio/driver.h>
10 #include <linux/kernel.h>
11 #include <linux/module.h>
12 #include <linux/mutex.h>
13 #include <linux/of_device.h>
14 #include <linux/seq_file.h>
15 #include <linux/spi/spi.h>
16 #include <linux/regmap.h>
17 
18 /* XRA1403 registers */
19 #define XRA_GSR   0x00 /* GPIO State */
20 #define XRA_OCR   0x02 /* Output Control */
21 #define XRA_PIR   0x04 /* Input Polarity Inversion */
22 #define XRA_GCR   0x06 /* GPIO Configuration */
23 #define XRA_PUR   0x08 /* Input Internal Pull-up Resistor Enable/Disable */
24 #define XRA_IER   0x0A /* Input Interrupt Enable */
25 #define XRA_TSCR  0x0C /* Output Three-State Control */
26 #define XRA_ISR   0x0E /* Input Interrupt Status */
27 #define XRA_REIR  0x10 /* Input Rising Edge Interrupt Enable */
28 #define XRA_FEIR  0x12 /* Input Falling Edge Interrupt Enable */
29 #define XRA_IFR   0x14 /* Input Filter Enable/Disable */
30 #define XRA_LAST  0x15 /* Bounds */
31 
32 struct xra1403 {
33 	struct gpio_chip  chip;
34 	struct regmap     *regmap;
35 };
36 
37 static const struct regmap_config xra1403_regmap_cfg = {
38 		.reg_bits = 7,
39 		.pad_bits = 1,
40 		.val_bits = 8,
41 
42 		.max_register = XRA_LAST,
43 };
44 
45 static unsigned int to_reg(unsigned int reg, unsigned int offset)
46 {
47 	return reg + (offset > 7);
48 }
49 
50 static int xra1403_direction_input(struct gpio_chip *chip, unsigned int offset)
51 {
52 	struct xra1403 *xra = gpiochip_get_data(chip);
53 
54 	return regmap_update_bits(xra->regmap, to_reg(XRA_GCR, offset),
55 			BIT(offset % 8), BIT(offset % 8));
56 }
57 
58 static int xra1403_direction_output(struct gpio_chip *chip, unsigned int offset,
59 				    int value)
60 {
61 	int ret;
62 	struct xra1403 *xra = gpiochip_get_data(chip);
63 
64 	ret = regmap_update_bits(xra->regmap, to_reg(XRA_GCR, offset),
65 			BIT(offset % 8), 0);
66 	if (ret)
67 		return ret;
68 
69 	ret = regmap_update_bits(xra->regmap, to_reg(XRA_OCR, offset),
70 			BIT(offset % 8), value ? BIT(offset % 8) : 0);
71 
72 	return ret;
73 }
74 
75 static int xra1403_get_direction(struct gpio_chip *chip, unsigned int offset)
76 {
77 	int ret;
78 	unsigned int val;
79 	struct xra1403 *xra = gpiochip_get_data(chip);
80 
81 	ret = regmap_read(xra->regmap, to_reg(XRA_GCR, offset), &val);
82 	if (ret)
83 		return ret;
84 
85 	if (val & BIT(offset % 8))
86 		return GPIO_LINE_DIRECTION_IN;
87 
88 	return GPIO_LINE_DIRECTION_OUT;
89 }
90 
91 static int xra1403_get(struct gpio_chip *chip, unsigned int offset)
92 {
93 	int ret;
94 	unsigned int val;
95 	struct xra1403 *xra = gpiochip_get_data(chip);
96 
97 	ret = regmap_read(xra->regmap, to_reg(XRA_GSR, offset), &val);
98 	if (ret)
99 		return ret;
100 
101 	return !!(val & BIT(offset % 8));
102 }
103 
104 static void xra1403_set(struct gpio_chip *chip, unsigned int offset, int value)
105 {
106 	int ret;
107 	struct xra1403 *xra = gpiochip_get_data(chip);
108 
109 	ret = regmap_update_bits(xra->regmap, to_reg(XRA_OCR, offset),
110 			BIT(offset % 8), value ? BIT(offset % 8) : 0);
111 	if (ret)
112 		dev_err(chip->parent, "Failed to set pin: %d, ret: %d\n",
113 				offset, ret);
114 }
115 
116 #ifdef CONFIG_DEBUG_FS
117 static void xra1403_dbg_show(struct seq_file *s, struct gpio_chip *chip)
118 {
119 	int reg;
120 	struct xra1403 *xra = gpiochip_get_data(chip);
121 	int value[XRA_LAST];
122 	int i;
123 	const char *label;
124 	unsigned int gcr;
125 	unsigned int gsr;
126 
127 	seq_puts(s, "xra reg:");
128 	for (reg = 0; reg <= XRA_LAST; reg++)
129 		seq_printf(s, " %2.2x", reg);
130 	seq_puts(s, "\n  value:");
131 	for (reg = 0; reg < XRA_LAST; reg++) {
132 		regmap_read(xra->regmap, reg, &value[reg]);
133 		seq_printf(s, " %2.2x", value[reg]);
134 	}
135 	seq_puts(s, "\n");
136 
137 	gcr = value[XRA_GCR + 1] << 8 | value[XRA_GCR];
138 	gsr = value[XRA_GSR + 1] << 8 | value[XRA_GSR];
139 	for_each_requested_gpio(chip, i, label) {
140 		seq_printf(s, " gpio-%-3d (%-12s) %s %s\n",
141 			   chip->base + i, label,
142 			   (gcr & BIT(i)) ? "in" : "out",
143 			   (gsr & BIT(i)) ? "hi" : "lo");
144 	}
145 }
146 #else
147 #define xra1403_dbg_show NULL
148 #endif
149 
150 static int xra1403_probe(struct spi_device *spi)
151 {
152 	struct xra1403 *xra;
153 	struct gpio_desc *reset_gpio;
154 	int ret;
155 
156 	xra = devm_kzalloc(&spi->dev, sizeof(*xra), GFP_KERNEL);
157 	if (!xra)
158 		return -ENOMEM;
159 
160 	/* bring the chip out of reset if reset pin is provided*/
161 	reset_gpio = devm_gpiod_get_optional(&spi->dev, "reset", GPIOD_OUT_LOW);
162 	if (IS_ERR(reset_gpio))
163 		dev_warn(&spi->dev, "Could not get reset-gpios\n");
164 
165 	xra->chip.direction_input = xra1403_direction_input;
166 	xra->chip.direction_output = xra1403_direction_output;
167 	xra->chip.get_direction = xra1403_get_direction;
168 	xra->chip.get = xra1403_get;
169 	xra->chip.set = xra1403_set;
170 
171 	xra->chip.dbg_show = xra1403_dbg_show;
172 
173 	xra->chip.ngpio = 16;
174 	xra->chip.label = "xra1403";
175 
176 	xra->chip.base = -1;
177 	xra->chip.can_sleep = true;
178 	xra->chip.parent = &spi->dev;
179 	xra->chip.owner = THIS_MODULE;
180 
181 	xra->regmap = devm_regmap_init_spi(spi, &xra1403_regmap_cfg);
182 	if (IS_ERR(xra->regmap)) {
183 		ret = PTR_ERR(xra->regmap);
184 		dev_err(&spi->dev, "Failed to allocate regmap: %d\n", ret);
185 		return ret;
186 	}
187 
188 	return devm_gpiochip_add_data(&spi->dev, &xra->chip, xra);
189 }
190 
191 static const struct spi_device_id xra1403_ids[] = {
192 	{ "xra1403" },
193 	{},
194 };
195 MODULE_DEVICE_TABLE(spi, xra1403_ids);
196 
197 static const struct of_device_id xra1403_spi_of_match[] __maybe_unused = {
198 	{ .compatible = "exar,xra1403" },
199 	{},
200 };
201 MODULE_DEVICE_TABLE(of, xra1403_spi_of_match);
202 
203 static struct spi_driver xra1403_driver = {
204 	.probe    = xra1403_probe,
205 	.id_table = xra1403_ids,
206 	.driver   = {
207 		.name           = "xra1403",
208 		.of_match_table = of_match_ptr(xra1403_spi_of_match),
209 	},
210 };
211 
212 module_spi_driver(xra1403_driver);
213 
214 MODULE_AUTHOR("Nandor Han <nandor.han@ge.com>");
215 MODULE_AUTHOR("Semi Malinen <semi.malinen@ge.com>");
216 MODULE_DESCRIPTION("GPIO expander driver for EXAR XRA1403");
217 MODULE_LICENSE("GPL v2");
218