xref: /openbmc/linux/drivers/cxl/Kconfig (revision ca48739e)
1# SPDX-License-Identifier: GPL-2.0-only
2menuconfig CXL_BUS
3	tristate "CXL (Compute Express Link) Devices Support"
4	depends on PCI
5	help
6	  CXL is a bus that is electrically compatible with PCI Express, but
7	  layers three protocols on that signalling (CXL.io, CXL.cache, and
8	  CXL.mem). The CXL.cache protocol allows devices to hold cachelines
9	  locally, the CXL.mem protocol allows devices to be fully coherent
10	  memory targets, the CXL.io protocol is equivalent to PCI Express.
11	  Say 'y' to enable support for the configuration and management of
12	  devices supporting these protocols.
13
14if CXL_BUS
15
16config CXL_MEM
17	tristate "CXL.mem: Memory Devices"
18	help
19	  The CXL.mem protocol allows a device to act as a provider of
20	  "System RAM" and/or "Persistent Memory" that is fully coherent
21	  as if the memory was attached to the typical CPU memory
22	  controller.
23
24	  Say 'y/m' to enable a driver (named "cxl_mem.ko" when built as
25	  a module) that will attach to CXL.mem devices for
26	  configuration, provisioning, and health monitoring. This
27	  driver is required for dynamic provisioning of CXL.mem
28	  attached memory which is a prerequisite for persistent memory
29	  support. Typically volatile memory is mapped by platform
30	  firmware and included in the platform memory map, but in some
31	  cases the OS is responsible for mapping that memory. See
32	  Chapter 2.3 Type 3 CXL Device in the CXL 2.0 specification.
33
34	  If unsure say 'm'.
35
36config CXL_MEM_RAW_COMMANDS
37	bool "RAW Command Interface for Memory Devices"
38	depends on CXL_MEM
39	help
40	  Enable CXL RAW command interface.
41
42	  The CXL driver ioctl interface may assign a kernel ioctl command
43	  number for each specification defined opcode. At any given point in
44	  time the number of opcodes that the specification defines and a device
45	  may implement may exceed the kernel's set of associated ioctl function
46	  numbers. The mismatch is either by omission, specification is too new,
47	  or by design. When prototyping new hardware, or developing / debugging
48	  the driver it is useful to be able to submit any possible command to
49	  the hardware, even commands that may crash the kernel due to their
50	  potential impact to memory currently in use by the kernel.
51
52	  If developing CXL hardware or the driver say Y, otherwise say N.
53endif
54